wheel alignment YAMAHA XT600E 2000 Owners Manual

EC000096
cCToo little chain slack will overload
the engine and other vital parts.
Keep the slack within the specified
limits.3.After adjusting, be sure to tighten
the axle nut and caliper bracket
bolt to the specified tightening
torque.
6-23
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU03006
Drive chain lubricationThe chain consists of many parts
which work with each other. If the
chain is not maintained properly, it
will wear out quickly. Therefore, the
chain must be serviced regularly.
This service is especially necessary
when riding in dusty areas. This
motorcycle is equipped with a sealed
type chain. Steam cleaning, high-
pressure washers, and solvents can
damage the drive chain, so do not
use these for cleaning it. Use only
kerosene to clean the drive chain.
Wipe it dry, and thoroughly lubricate it
with SAE 30 ~ 50W motor oil. Do not
use any other lubricants on the drive
chain. They may contain solvents
that could damage the sealed chain. Tightening torque:
Axle nut:
105 Nm (10.5 m
0kg)
Caliper bracket bolt:
48 Nm (4.8 m
0kg)
EAU01134
Drive chain slack adjustment1.Loosen the axle nut and caliper
bracket bolt.
2.Turn both left and right chain
adjusting plates the same
amount. Make sure that they are
in the same position for proper
wheel alignment. To tighten the
chain, turn in direction a. To
loosen the chain, turn in direction
b.
a
b2 1
3
1.Chain adjusting plate
2.Axle nut
3.Caliper bracket bolt
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 24