child restraint ACURA NSX 1997 Service Repair Manual

Seat Belts

Child Seat Anchor Plate

An attachment point is provided for a child restraint

system which uses a top tether. The tether bracket and

bolt are available at your Acura dealer. The tether at-

tachment point is located on the panel behind the

passenger's seat-back.

1. Adjust the passenger seat fully forward to make

room behind the seat-back.

2. Using the dimensions shown, measure and mark

the location of the attachment point on the interior

panel.

3. Use a razor blade or sharp knife to carefully cut a 1

inch diameter circle at the point you marked. Cut

through one layer at a time. You will need to

remove two layers to reach the tether attachment.

4. Install the tether bracket and bolt and tighten to:

16 Ibf-ft (22 N-m)

Make sure to route the tether through the space be-

tween the headrest and seat.

8 x
1.25
mm

22 N-m (2.2 kgf-m, 16 Ibf-ft)

25 mm

(1 in)

CHILD SEAT

ANCHOR PLATE

100 mm

(25.4
in)

246 mm

(62.5
in)

NOTE:

• Do not remove the toothed washer from the

child seat anchor plate. Use the child seat an-

chor plate with the toothed washer attached to

it.

• When installing a child seat, follow the instruc-

tions of the manufacturer of the child seat.

• Additional anchor plates are available.

Do not use the anchor plate for any

other purpose; it is designed exclusively for in-

stallation of a child seat.
Rearview Mirror

Replacement ——

1. Carefully remove the cover with a flat tip

screwdriver.

2. Loosen the lock bolt, then slide the mirror stay from

the
lug.

MIRROR
LUG

MIRROR STAY

LOCK BOLT

Counter-

clockwise

COVER

3. Remove the lock bolt, then remove the toothed

lock washer and hold spring from the mirror stay.

LOCK BOLT

Left-hand threads

TOOTHED LOCK WASHER

HOLD SPRING

MIRROR STAY

4. Installation is the reverse of the removal procedure.
TOOTHED WASHERProCarManuals.com