wheel Alfa Romeo 166 2007 Owner handbook (in English)

59
Flashing(fig. 69)
The headlights are flashed by pulling the
lever towards the steering wheel (unsta-
ble position) regardless of the position of
the light switch.
The warning light
1on the instrument
panel will come on at the same time.
IMPORTANT Only the main beam
lights are flashed. To avoid penalties, fol-
low local regulations.Direction indicators (fig. 70)
Moving the lever to the stable position:
Up (A) - engages the right-hand direc-
tion indicators.
Down (B) - engages the left-hand direc-
tion indicators.One of the warning lights
Îo¥will
light up on the instrument panel at the
same time.
The lever returns to its home position
automatically and the indicators are
switched off when the steering wheel is
straightened.
IMPORTANT If you wish to signal a
rapid change of direction involving only a
minimum movement of the steering
wheel, the lever can be moved up or
down without it clicking (unstable posi-
tion). When released the lever will return
to its home position.
A0D0018m
fig. 69
A0D0016m
fig. 70

60
RIGHT-HAND LEVER (fig. 72)
The right-hand lever is used to operate
the windscreen wiper and the windscreen
washer.
The control used to activate the wind-
screen washer also activates the head-
light washers (optional for versions/mar-
kets where applicable). “Follow me home” device
(fig. 71)
This function allows the illumination of the
space in front of the car for the length of
time set, and is activated with the ignition
key at STOPor removed, pulling the left-
hand lever towards the steering wheel.This function is activated pulling the lever
within 2 minutes from when the engine is
turned off. At each single movement of the
lever, the staying on of the dipped beams
and sidelights is extended by 30 seconds up
to a maximum of 3.5 minutes; the lights
switch off automatically after the time set.
Each time the lever is operated, the
1
warning light on the cluster turns on.
This function can be interrupted by keep-
ing the lever pulled towards the steering
wheel for more than 2 seconds.
fig. 72
A0D0015m
A0D0018m
fig. 71

62
At each start the rain sensor automati-
cally (in about 2 minutes) stabilises at a
temperature of about 40°C to eliminate
any condensation from the control surface
and prevent the formation of ice.
The rain sensor is capable of detecting
and adapting automatically to the pres-
ence of the following particular conditions
which call for different sensitivity:
– impurities on the control surface
(saline deposits, dirt, etc.)
– streaks of water caused by partial
wear of the windscreen wiper
– difference between day and night
(the human eye is more disturbed during
the night by a wet windscreen surface.Headlight washer (fig. 75)
(optional for versions/markets where
applicable)
These are operated when the low beam
headlights are on and the windscreen
washer is switched on. Windscreen washer (fig. 74)
The windscreen washer is operated by
pulling the lever towards the steering
wheel.
Keeping the lever pulled the windscreen
wiper is turned on continuously. When
the lever is released the wiper continues
for a few strokes and then stops or con-
tinues at the speed set.
A0D0020m
fig. 74
A0D0021m
fig. 75

75
Seat belts not fastened
When the ignition key is turned to
MARthe warning light turns on but it
must go out after approx. 15 seconds.
For versions/markets where applicable,
the warning light turns on permanently
when, with the key in the MARposi-
tion, the driver’s seat belt is not fastened
properly. This warning light comes on when the
brake pedal is pressed and the front
brake pads are found to be worn, have
them replaced as soon as possible. When
the ignition key is turned to MARthe
warning light comes on but must go out
after approx. 6 seconds.
IMPORTANT As the vehicle is fitted
with brake pad wear sensors for the front
wheels only, when these are replaced
check the back brake pads at the same
time.dAlfa Romeo CODE system
When the ignition key is turned to MAR
the warning light should come on and then
go out. If the warning lights stays on with
the key in the MARposition, it indicates
a possible failure: see “The Alfa Romeo
CODE system”.
IMPORTANT The turning on contem-
poraneously of warning lights and
indicates a failure of the Alfa Romeo
CODE system.
¢
¢

77
Faulty ABS anti
wheel-locking
This warning light comes on when the
system is inefficient. In this case normal
braking is ensured without though, mak-
ing use of the ABS system. Alfa Romeo
Authorized Services should however be
contacted as soon as possible.
When the ignition key is turned to
MARthe warning light comes on but
must go out after approx. 4 seconds.>
Presence of water
in the fuel oil filter
(JTD 20V Multijet versions)
When the ignition key is turned to the
MARposition the warning light should
come on and must go out after approx. 4
seconds.
The warning light switches on fixed
when driving, to indicate the presence of
water in the fuel oil filter.
In case the indicator light switches on,
even if just for a few seconds, we recom-
mend to contact an Alfa Romeo Autho-
rised Service as soon as possible in order
to purge the water from the fuel oil filter
and avoid severe damages to the injec-
tion pump and to the fuel oil supply cir-
cuit as well as the engine irregular opera-
tion.
c
Glowplugs
(JTD 20V Multijet versions)
The warning light comes on
when the ignition key is turned to MAR
position. When the glowplugs have
reached the established temperature the
warning light will go out. Start the en-
gine as soon as the warning light has
gone out.
For versions/markets where applica-
ble, the warning light flashes for approx.
30 seconds after starting the engine
meaning that there is a fault to the glow
plug warning system, in which case,
contact Alfa Romeo Authorized Services.
With a high ambient temperature the
warning light may turn on imperceptibly.
m
The car is fitted with an
electronic braking device
(EDB). If the
>andxwarning
lights turn on at the same time, this
means that there is an EBD system
fault; in this case violent braking
may be accompanied by early rear
wheel locking, with the possibility
of skidding. Drive the car ex-
tremely carefully to the nearest
Authorized Alfa Romeo workshop
to have the system checked.
WARNING

92
The temperature near
the heater should never
exceed 120°C (e.g. dur-
ing body painting operations in
the workshop oven). Higher tem-
perature could damage the elec-
tronic control unit components.
For maintenance and repairs con-
tact only Authorized Alfa Romeo
Services and only use original
spare parts.
The burner exhaust gas
is released in the centre
floor area: therefore never park
the car with the engine running
over inflammable surfaces, fire
hazard!
WARNING
IMPORTANT When the heater is
working with the vehicle stationery and
the engine running, standing outside the
car near the rear wheel arch a low noise
caused by normal operation of the heater
can be heard.MAINTENANCE
Have the additional heater checked at
regular intervals by Authorized Alfa
Romeo Services. This will ensure safe,
cost-effective working of the heater and
also long life.

95
GEARSHIFT LEVER (fig. 101)
When changing gear always fully de-
press the clutch pedal. Before engaging
reverse gear (R) wait for the car to be
stationary.
To engage reverse gear (R) it is neces-
sary to wait for the car to be stationary,
then raise the ring under the grip (A)
(with the fingers of the same hand hold-
ing the lever). After engaging reverse
gear, release the ring. It is not necessary
to raise the ring on the lever when shift-
ing from reverse to another gear.
fig. 101
A0D0031m
HAND BRAKE (fig. 102)
The hand brake is located between the
two front seats.
To operate the brake when the vehicle
is stationary pull the lever upwards until
the required braking action is obtained.
When the ignition key is in the MAR
position the
xwarning light will come
on on the instrument panel.To release the hand brake:
– Slightly lift the lever (A) and press
the button (B).
– holding the button down lower the
lever: the
xwarning light on the instru-
ment panel will go out.
To prevent the car from moving acciden-
tally, keep the brake pedal pressed when
engaging the handbrake.
The wheels should be
locked after a few clicks
of the hand brake lever.
if this does not occur contact Alfa
Romeo Authorized services to
have the hand brake adjusted.
fig. 102
372PGSm

97
ODDMENTS COMPARTMENTS
ON THE DASHBOARD
Upper compartment
(fig. 110-111)
This is fitted with a lid. To open, press
and release the button (A). To close the
lid, simply lower it.Left side compartment (fig. 112)
On the lower side of the dashboard, at
the left of the steering wheel, there is an
oddments compartment (A).
436PGSm
fig. 112
600PGSm
fig. 110
601PGSm
fig. 111
COMPARTMENTS AND
POCKETS ON THE DOORS
(fig. 113-114)
Each door is fitted with a pocket.
fig. 113- Front doors
fig. 114- Rear doors.
438PGSm
fig. 114
437PGSm
fig. 113

114 ABS
The car is fitted with an ABS system
which prevents wheel lock when braking,
better exploits wheel grip and keeps the
vehicle controllable within the limits of
the available grip also during emergency
braking.
The driver can feel that the ABS is oper-
ational by a light pulsing of the brake
pedal, accompanied by noise.
This should not be interpreted as malfunc-
tioning of the brakes, but it is the signal to
the driver that the ABS system is working:
it is the warning that the car is travelling at
the limit of grip and that it is therefore nec-
essary to adapt the speed to the type of
road on which you are travelling.
The ABS system is an additional part of
the basic braking system; in the event of
a fault it is disabled, leaving the braking
system in the same conditions as a car
without ABS.In the event of a failure, though being
unable to rely on the antilock effect,
there is absolutely no adverse effect on
vehicle braking performance in terms of
braking capacity.
If you have never used a car with ABS
before, you are advised to learn how to
use it with a few preliminary trials on a
slippery surface, naturally under safety
conditions and fully adhering to the High-
way Code of the country concerned. You
are also advised to carefully read the fol-
lowing information.
The advantage of the ABS compared
with the conventional system is that it
makes it possible to maintain maximum
vehicle handling performance also in the
case of hard braking under grip limit con-
ditions, avoiding wheel lock.
Do not however expect the braking dis-
tance always to be reduced with the ABS
system: for example, on soft surfaces
such as gravel or fresh snow on slippery
surfaces, the distance might increase.In order to be able to exploit as far as
possible the possibility of the antilock
system in the case of need, it is wise to
follow a few pieces of advice.
The ABS exploits the
available grip in full, but
it cannot increase it; therefore cau-
tion is required on slippery surfac-
es, without running un-necessary
risks.
WARNING

115
Braking on corners always requires the
utmost caution, even with the help of the
ABS.
The most important piece of advice
however, is the following:WARNINGCars fitted with ABS must
only be fitted with wheel rims, tyres and
brake linings of the type and brand ap-
proved by the Manufacturer.
The braking system is completed by the
EBD (Electronic Brake Distributor) which
distributes the braking action through the
ABS control unit and sensors.
Following these instructions you will be
in a condition to obtain peak braking per-
formance at all times.
If the ABS cuts in, it
means that the grip limit
between the tyres and the road
surface has been reached: it is nec-
essary to slow down and adapt
driving to the grip available.
WARNING
In the event of a system
fault, with lighting up of
the
>warning light, have the ve-
hicle checked immediately by Au-
thorized Alfa Romeo Services, driv-
ing slowly to be able to regain full
system performance.
WARNING
When the ABS cuts in and
you feel the pedal pulse,
do not reduce the pressure, but
keep the brake pedal firmly
pressed with no fear; this way you
will stop in the shortest space pos-
sible, compatibly with the condi-
tions of the road surface.
WARNING
The car is fitted with an
electronic brake distrib-
utor (EBD). If the
>andxwarn-
ing lights come on at the same time
when the engine is running, there
is an EBD system fault; in this case,
violent braking may lock the rear
wheels too early, with the possibil-
ity of skidding. Drive extremely
carefully to the nearest Authorized
Alfa Romeo Services to have the
system checked over.
WARNING