wheel ACURA RL KA9 1996 Service Repair Manual

11. Remove the cable reel from the column.
13. Carefully install the cable reel on the steering col-

umn shaft. Then connect the 4P connector to the

cable reel, and connect the 2P connector to the SRS

main harness, then attach the cable reel 2P connec-

tor to the connector holder.

'96-98 Models
'99 - 01 Models
CAUTION:

• Before installing the steering wheel, the front

wheels should be aligned straight ahead.

• Be sure to install the harness wires so that they

are not pinched or interfering with other vehicle

parts.

• After reassembly, confirm that the wheels are

still turned straight ahead and that the steering

wheel spoke angle is correct (road test). If minor

spoke angle adjustment is necessary, do so only

by adjusting the tie-rods, not by removing and

repositioning the steering wheel.

12. Set the cancel sleeve so that the projections are

aligned vertically.
Replacement (cont'd)

10. Disconnect the 4P connector between the cable reel

and combination switch harness, and remove the

2P connector between the cable reel and SRS main

harness.

'96 - 98 Models
Cable ReelProCarManuals.com

'99 - 01 Models
'99 - 01 Models

16. Install the steering wheel, then connect the radio

remote switch connector, horn connector and cruise

control set/resume/cancel switch connector.

'96 - 98 Models

14. Install the steering column covers.

15. If necessary, center the cable reel. (New replace-

ment cable reels come centered.) Do this by first

rotating the cable reel clockwise until it stops. Then

rotate it counterclockwise (about 21/2 turns) until the

arrow mark on the cable reel label points straight

up.

'96 - 98 Models

'99 - 01 ModelsProCarManuals.com

Replacement (cont'd )
17. Instal l th e steerin g whee l nut , the n instal l th e driv -
er' s airbag .
'9 6 - 9 8 Model s
Cable Ree l
18. Instal l th e dashboar d lowe r cover , an d reinstal l th e
acces s pane l o n th e steerin g wheel .
19 . Reconnec t th e batter y positiv e cable , the n th e nega -
tiv e cable .
20 . Afte r installin g th e cabl e reel , confir m prope r sys -
te m operation :
• Tur n th e ignitio n switc h O N (II) ; th e SR S indica -
to r ligh t shoul d com e o n fo r abou t 6 second s an d
the n g o off .
• Mak e sur e hor n butto n works .
• Mak e sur e th e headligh t an d wipe r switche s
work .
• G o fo r a tes t drive , an d mak e sur e th e cruis e con -
tro l switche s work .
21 . Ente r th e anti-thef t cod e fo r th e radio , the n ente r th e
customer' s radi o statio n presets .
'9
9 - 0 1 Model s
ProCarManuals.com

SRS Uni t
Replacemen t
CAUTION:
• Befor e disconnectin g an y par t o f th e SR S wir e har -
ness , disconnec t th e airba g connectors , sea t bel t ten -
sione r connector s an d sid e airba g connectors .
• Durin g installatio n o r replacement , d o no t bum p
(impac t wrench , hamme r etc. ) th e are a nea r th e SR S
unit.
• D o no t damag e th e SR S uni t terminal s o r connec -
tors.
• D o no t disassembl e th e SR S unit ; i t ha s n o service -
abl e parts .
• Stor e th e SR S uni t i n a clean , dr y area .
• D o no t us e an y SR S uni t whic h ha s bee n subjecte d
t o wate r damag e o r show s sign s o f bein g droppe d o r
improperl y handled , suc h a s dents , crack s o r defor -
mation .
1. Mak e sur e yo u hav e th e anti-thef t cod e fo r th e radio ,
the n writ e dow n th e frequencie s fo r th e radio' s pre -
set buttons .
2. Disconnec t th e batter y negativ e cable , the n discon -
nec t th e positiv e cabl e fro m th e battery , an d wai t a t
leas t 3 minutes .
3. Disconnec t th e airba g connectors , sea t bel t tensione r
connector s an d sid e airba g connectors .
Driver' s Airbag :
• Remov e th e acces s pane l fro m th e steerin g wheel ,
the n disconnec t th e 2 P connecto r betwee n th e driver' s
airba g an d cabl e ree l (se e pag e 24-33 ).
NOTE : Whe n th e disconnected , th e airba g connecto r
i s automaticall y shorted .
Fron t Passenger' s Airbag :
• Remov e th e glov e bo x (se e sectio n 20 ).
• Disconnec t th e 2 P ('9 6 - 9 8 Models ) o r 4 P ('9 9 - 0 1
Models ) connecto r betwee n th e fron t passenger' s
airba g an d SR S mai n harnes s (se e pag e 24-33 ).
NOTE : Whe n disconnected , th e airba g connecto r i s
automaticall y shorted .
Sid e Airba g ('9 9 - 0 1 Models) :
• Disconnec t th e 2 P connector s betwee n th e sid e airba g
an d th e SR S floo r harnes s (se e pag e 24-33 ).
NOTE : Whe n disconnected , th e sid e airba g connecto r
i s automaticall y shorted .
Sea t Bel t Tensioner :
• Remov e th e lef t an d righ t B-pilla r tri m panel s (se e
sectio n 20 ).
• Disconnec t th e sea t bel t tensione r 2 P connector s
fro m th e lef t sid e wir e harnes s (driver' s side ) an d th e
righ t sid e wir e harnes s (fron t passenger' s side ) (se e
pag e 24-33 ).
NOTE : Whe n disconnected , th e tensione r connecto r
is automaticall y shorted .
'99 - 0 1 Model s
4
. Remov e th e radi o pane l assembl y (se e sectio n 20 ),
the n remov e th e bracket .
5 . '9 6 - 9 8 Models : Disconnec t th e SR S mai n harnes s
18P connecto r fro m th e SR S unit .
'99 - 0 1 Models : Disconnec t th e SR S mai n harnes s
18P connecto r an d SR S floo r harnes s 18 P connecto r
from th e SR S unit .
6. Remov e th e thre e Tor x bolt s fro m th e SR S unit ,
then pul l ou t th e SR S unit .
'96 - 9 8 Model s
ProCarManuals.com

Replacement (cont'd )
CAUTION :
• B e sur e t o instal l th e SR S wirin g s o tha t i t i s no t
pinche d o r interferin g wit h othe r vehicl e parts .
• Whe n tightenin g th e Tor x bolt s t o th e specifie d
torqu e afte r replacement , b e carefu l t o tur n the m in
s o tha t thei r head s res t squarel y o n th e brackets .
7 . Instal l th e ne w SR S unit .
'9 6 - 9 8 Model s
SRS Uni t
8. '9 6 - 9 8 Models : Connec t th e SR S mai n harnes s 18 P
connecto r t o th e SR S unit , the n pus h it int o positio n
until i t clicks .
'9 9 - 0 1 Models : Connec t th e SR S mai n harnes s 18 P
connecto r an d SR S floo r harnes s 18 P connecto r t o
th e SR S unit , the n pus h it int o positio n unti l i t clicks .
9. Reconnec t th e driver' s airba g 2 P connecto r t o th e
cabl e ree l 2 P connector , an d reinstal l th e acces s
pane l o n th e steerin g wheel .
10 . Reconnec t th e fron t passenger' s airba g 2 P ('9 6 - 9 8
Models ) o r 4 P ('9 9 - 0 1 Models ) connecto r t o th e SR S
mai n harnes s 2 P ('9 6 - 9 8 Models ) o r 4 P ('9 9 - 0 1
Models ) connector , the n instal l th e glov e box .
11 . '99-0 1 Models : Reconnec t th e sid e airba g 2 P con -
nector s t o th e SR S floo r harnes s 2 P connectors .
12 . Reconnec t th e lef t sid e wir e harnes s 2 P connecto r
t o th e driver' s sea t bel t tensione r an d th e righ t sid e
wir e harnes s 2 P connecto r t o th e fron t passenger' s
sea t bel t tensioner . Reinstal l th e B-pilla r tri m panels .
13 . Reconnec t th e batter y positiv e cable , the n th e nega -
tiv e cable .
14 . Afte r installin g th e SR S unit , confir m prope r syste m
operation : Tur n th e ignitio n switc h O N (II) ; th e SR S
indicato r ligh t shoul d com e o n fo r abou t 6 second s
an d the n g o off .
15 . Ente r th e anti-thef t cod e fo r th e radio , the n ente r th e
customer' s radi o statio n presets .
'9 9 - 0 1 Model s
ProCarManuals.com