Citroen GRAND C4 PICASSO 2017 2.G Service Manual

39
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
Service overdue
For 5 seconds after the ignition is switched
on, the spanner flashes to indicate that
the service must be carried out as soon as
possible.
Example: the service is overdue by 300 miles.
For 5 seconds after the ignition is switched on,
the screen indicates: Therefore, the spanner may come on
if you have exceeded the period since
the last service, as indicated in the
manufacturer's service schedule.
For BlueHDi Diesel versions, the
spanner may also come on early,
according to the level of deterioration
of the engine oil, which depends on the
driving conditions in which the vehicle
is used.
5 seconds after the ignition is switched on,
the distance recorder resumes its normal
operation. The spanner remains on .
With BlueHDi Diesel versions, the Service
warning lamp also comes on when the ignition
is switched on.
1
Instruments

40
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
Resetting the service indicatorIf you have to disconnect the battery
following this operation, lock the vehicle
and wait at least 5 minutes for the reset
to be registered.
After each service, the service indicator must
be reset to zero.
If you have carried out the service on your
vehicle yourself:
F

s

witch off the ignition,
F

p

ress and hold the trip distance recorder
reset button,
F

s

witch on the ignition; the distance recorder
display begins a countdown,
F

w

hen the display indicates "=0" , release
the button; the spanner disappears.
Retrieving the service
information
You can access the service information at any
time.
F

P
ress the trip distance recorder reset
button.
T

he service information is displayed for a
few seconds, then disappears.
Instruments

41
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
* Only with the 12 inch colour instrument panel.
Coolant temperature gauge*
After driving for a few minutes, the temperature
and pressure in the cooling system increase.
To top-up the level:
F
w
ait for the engine to cool,
F

u
nscrew the cap slightly to allow the
pressure to drop,
F

w
hen the pressure has dropped, remove
the cap,
F

t
op-up the level to the "MA X" mark.
With the engine running, when the needle is:
-

i

n zone A , the temperature is correct,
-

i

n zone B, the temperature is too high;
the maximum temperature and the
central STOP warning lamps come on,
accompanied by an audible signal and a
warning message. Be aware of the risk of burns when
topping-up the cooling system. Do not
fill above the maximum level (indicated
on the header tank).
You MUST stop as soon as it is safe to
do

so.
Wait a few minutes before switching off the
engine.
Contact a CITROËN dealer or a qualified
workshop.
1
Instruments

42
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
Engine oil level indicator*
On versions fitted with an electric oil level
indicator, the state of the engine oil level is
displayed in the instrument panel for a few
seconds, after the servicing information.The level read will only be correct if
the vehicle is on level ground and the
engine has been off for more than
30
m

inutes.Oil level correct
This is indicated by the display of the message
"Oil level incorrect" in the instrument panel
screen, accompanied by the service warning
lamp and an audible signal.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to
avoid damage to the engine.
For more information on Checking levels,
refer to the corresponding section. This is signalled by the display of the message
"Oil level measurement invalid" in the
instrument panel.
Contact a CITROËN dealer or a qualified
workshop.
In the event of a fault with the electric indicator,
the oil level is no longer monitored.
If the system is faulty, you must check the
engine oil level using the manual dipstick
located under the bonnet.
For more information on Checking
levels,
refer to the corresponding section.
* Depending on version.
Oil level incorrect Oil level indicator fault
Instruments

43
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
AdBlue® fluid range indicators
Once the AdBlue® tank is on reserve or after
detection of a fault with the SCR emissions
control system, when the ignition is switched
on an indicator displays an estimate of the
distance that can be covered, the range, before
engine starting is prevented.
In the event of simultaneous system fault and
low AdBlue
® level, the shortest range figure is
the one displayed. Range greater than 1 500 miles (2 400 km)
When the ignition is switched on, no
information on range is displayed automatically
in the instrument panel.
With the 12 inch colour instrument panel,
pressing this button temporarily displays the
driving range.
In the event of the risk of non-starting related to a lack of AdBlue®
The engine start prevention system
required by regulations is activated
automatically once the AdBlue
® tank is
e m pt y.
Remaining range between 350 and 1500 miles
(600 and 2 400 km)
When switching on the ignition, the AdBlue
warning lamp comes on for a few seconds,
accompanied by an audible signal and the
display of a message (e.g. "Top-up AdBlue:
Starting impossible in 900 miles") indicating
the remaining range expressed in miles or
kilometres.
When driving, the message is displayed every
200 miles (300 km) until the fluid level has been
topped-up.
Go to a CITROËN dealer or a qualified
workshop to have the AdBlue
® fluid topped-up.
You can also top-up the fluid yourself.
For more information on AdBlue
® and the SCR
system, and in particular on topping-up, refer
to the corresponding section.
1
Instruments

44
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
Remaining range between 0 and 350 miles
(0 and 600 km)
When switching on the ignition, the SERVICE
warning lamp comes on and the AdBlue
warning lamp flashes, accompanied by an
audible signal and the display of a message
(e.g. "Top-up AdBlue: Starting impossible in
350 miles") indicating the remaining range
expressed in miles or kilometres.
When driving, the message is displayed every
30 seconds until the fluid level has been
topped-up.
Go to a CITROËN dealer or a qualified
workshop to have the AdBlue
® fluid topped-up.
You can also top-up the fluid yourself.
Other wise you will not be able to restart your
engine. Breakdown related to a lack of AdBlue
®
When switching on the ignition, the SERVICE
warning lamp comes on and the AdBlue
warning lamp flashes, accompanied by an
audible signal and the display of a message
(e.g. "Top-up AdBlue: Starting impossible").
The AdBlue
® tank is empty: the system required
by regulations prevents engine starting.
To be able to start the engine,
we recommend that you call on
a CITROËN dealer or a qualified
workshop for the top-up required.
If you carry out the top-up yourself, it
is essential to add at least 3.8 litres of
AdBlue
® to the tank.
For more information on AdBlue® and the SCR
system, and in particular on topping-up, refer
to the corresponding section.
Instruments

45
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
In the event of a fault with the SCR emissions control system
In the event of the detection of a fault
The AdBlue, SERVICE and diagnostic
warning lamps come on, accompanied by an
audible signal and the display of the message
"Emissions fault".
The alert is triggered when driving when the
fault is detected for the first time, then when
switching on the ignition for subsequent
journeys, while the fault persists.During an authorised driving phase (between
650 miles and 0 miles) (1 100 km and 0 km)
If a fault with the SCR system is confirmed
(after 30 miles (50 km) covered with the
permanent display of the message signalling
a fault), the SERVICE and engine diagnostic
warning lamps come on and the AdBlue
warning lamp flashes, accompanied by an
audible signal and the display of a message
(e.g. "Emissions fault: Starting prevented in
150 miles") indicating the remaining range
expressed in miles or kilometres.
While driving, the message is displayed every
30 seconds while the fault with the SCR system
persists.
The alert is repeated when switching on the ignition.You should go to a CITROËN dealer or a
qualified workshop as soon as possible.
Other wise, you will not be able to restart your
engine.
A system that prevents engine starting is activated automatically from 650 miles (1 100 km) after confirmation of a fault with the SCR emissions
control system. Have the system checked by a CITROËN dealer or a qualified workshop as soon as possible.
If it is a temporary fault, the alert
disappears during the next journey,
after self-diagnosis of the SCR system.
Starting prevented
Every time the ignition is switched on, the
SERVICE and engine diagnostic warning
lamps come on and the AdBlue warning lamp
flashes, accompanied by an audible signal and
the display of the message "Emissions fault:
Starting prevented".
You have exceeded the authorised
driving limit: the starting prevention
system inhibits engine starting.
To be able to start the engine, you must
call on a CITROËN dealer or a qualified
workshop.
1
Instruments

46
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
Distance recorders
The total and trip distances are displayed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
vehicle is locked or unlocked.When travelling abroad, you may
have to change the units of distance:
the display of road speed must be in
the official units (miles or km) for the
country. The change of units is done via
the screen configuration menu, with the
vehicle stationary. It measures the distance travelled since it was
reset to zero by the driver.
F

W
ith the ignition on, press the button until
zeros appear.
It measures the total distance travelled by the
vehicle since its first registration.Total distance recorder
Trip distance recorder
Instruments

47
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
Lighting dimmer control
Allows the manual adjustment of the brightness of the instrument panel and touch screen to suit the
ambient light level.
Operates only when the vehicle lighting is on, with the exception of the daytime running lamps.
With the exterior lighting on, press button A
to increase the brightness of the instruments
and controls and the interior mood lighting or
button B to reduce it.
As soon as the lighting reaches the required
level of brightness, release the button. F

I
n the Configuration menu, select
" Brightness ".
F

A
djust the brightness using the arrows or
by moving the cursor.
Tw o b u t t o n s Touch screen
1
Instruments

48
C4-Picasso-II_en_Chap01_instruments-bord_ed02-2016
When driving at night, this function allows
certain displays in the instrument panel to be
switched off to avoid visual fatigue for the driver.
The essential information, such as the speed of
the vehicle, the warning lamps and the cruise
control or speed limiter indications remain
displayed in the instrument panel.
F
W
ith the vehicle lighting on, press this
button to activate the black panel.
F

P
ress this button again to deactivate it.
Black screen (touch screen)
Black panel (comfortable
night driving display)
F In the Configuration menu, select "Dark".
The screen goes off.
F

P
ress the screen again (anywhere on its
sur face) to switch it on again.
Using the steering mounted
control
Instruments