FORD PROBE 1997 2.G Owners Manual

178
*
[ER13100(ALL)02/96]
Jump-Starting
*
[ER13200(ALL)02/96]
1. Make sure that the jumper cables are not in
the way of moving engine parts, then start
the booster vehicle. Run the engine at a
moderate speed.
*
[ER13300(ALL)02/96]
2. Let the discharged battery charge for a few
minutes and then start the disabled vehicle.
It may take a couple of tries before the
vehicle starts. If the vehicle does not start
after several attempts, there may be a
different problem.
*
[ER13400(ALL)02/96]
3. When both vehicles are running, let them
idle for a few minutes to charge the
discharged battery.
%*
[ER13500(ALL)02/96]
Removing jumper cables
[ER13600(ALL)01/96]
1.Always remove the jumper cables in
reverse order.Remove the negative (-) end
of the jumper cable from the metallic surface
on the engine or frame of the disabled
vehicle.
*
[ER13700(ALL)03/96]
2. Remove the negative (S) cable from the
booster battery.
*
[ER13800(ALL)02/96]
3. Remove the positive (+) cable from the
booster battery.
*
[ER13900(ALL)02/96]
4. Remove the other end of the positive (+)
cable from the discharged battery.
*
[ER14000(ALL)02/96]
After the vehicle is started, let it idle for a while
to let the engine ªrelearnº its idle conditions.
Drive it around for a while with all electrical
accessories turned off to let the battery recharge.
Driveability may be deteriorated slightly until all
drive modes are ªrelearned.ºYou may need to
use a battery charger to fully recharge the
battery.
File:10prerp.ex
Update:Thu Jun 13 09:57:39 1996

179
*
[ER14100(ALL)03/96]
If you need to replace your battery, seeBattery
in theMaintenance and Carechapter.
%
*
[ER15000(ALL)04/96]
Towing Your Vehicle
*
[ER15100(ALL)03/96]
If you need to have your vehicle towed, contact
a professional towing service or, if you are a
member, your roadside assistance center.
Recommended towing options include wheel lift
towing or flat bed towing.
[ER15200(ALL)01/96]
half page art:0032391-A*
[ER15300(ALL)01/96]
When calling for a tow truck, tell the operator
what kind of vehicle you have. A towing
manual is available from Ford Motor Company
for all authorized tow truck operators. Have
your tow truck driver refer to this manual for
the proper hook-up and towing procedures for
your vehicle.
File:10prerp.ex
Update:Thu Jun 13 09:57:39 1996

180
*
[ER15400(ALL)01/96]
Towing With the Back Wheels Off the
Ground
[ER15500(ALL)01/96]
For automatic and manual transaxle vehicles, if
it is necessary to tow your vehicle from the rear
(with the rear wheels off the ground), a dolly
must be placed under the front tires to prevent
transaxle damage.
[ER15600(ALL)01/96]
If the slingbelt towing method must be used, use
the following procedure:
[ER15700(ALL)01/96]
1. Place the front wheels on wheel dollies.
[ER15800(ALL)01/96]
2. Place T-hooks into the T-hook slots located
on the frame rail behind the rear wheels.
[ER15900(ALL)01/96]
3. Route the tow chain to clear the exhaust
pipes.
[ER16000(ALL)01/96]
4. Position the tow bar under the rear bumper.
[ER16100(ALL)01/96]
5. Slowly raise the vehicle off the ground.
[ER16200(ALL)01/96]
6. Attach safety chains around the rear
crossmember.
File:10prerp.ex
Update:Thu Jun 13 09:57:39 1996

181 [ER16300(ALL)01/96]
two third page art:0032195-A
*
[ER16400(ALL)01/96]
Do not use your vehicle's steering column lock
to secure the wheels in a straight-ahead position.
Always use a steering wheel clamping device
designed for towing service.
*
[ER16500(ALL)01/96]
Refer toTowing behind another vehicle
Ðrecreational vehiclein the Index for information
on towing behind an RV.
File:10prerp.ex
Update:Thu Jun 13 09:57:39 1996

183
Maintenance and Care
%*
[MC00300(ALL)01/96]
Service Made Easy
*
[MC00400(ALL)01/96]
Ford has two goals for servicing your vehicle.
*
[MC00500(ALL)01/96]
1. When we can, we design parts that do not
need to be serviced.
*
[MC00600(ALL)01/96]
2. We want to make servicing your vehicle as
easy as possible. To help you:
*
[MC00700(ALL)01/96]
q
We highlight do-it-yourself items in yellow in
the engine compartment so that you can find
them easily.
*
[MC00800(ALL)03/96]
q
When possible, we design parts that can be
replaced without tools.
*
[MC00900(ALL)02/96]
q
We give you a Maintenance Schedule that
makes tracking routine service for your
vehicle easy. The maintenance schedule is
located in theMaintenance Schedulebooklet.
*
[MC00925(ALL)01/96]
This chapter tells you about the basic parts that
you need to check and service regularly.
*
[MC00930(ALL)01/96]
If your vehicle needs professional servicing, your
dealership can provide the parts and service
required. Check yourWarranty Information Booklet
to find out which parts and services are covered.
Also see theCustomer Assistancechapter of this
Owner Guide.
*
[MC01000(ALL)03/96]
Ford Motor Company recommends that you
perform the Owner Maintenance Checks listed in
theMaintenance Schedulebooklet. These services
are important for the proper operation of your
vehicle. In addition to the conditions listed in
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

184the Owner Maintenance Checklist, be alert for
any unusual noise, vibration, or other indication
that your vehicle may need service. If you do
notice something unusual, see that your vehicle
is serviced promptly.
*
[MC01100(ALL)01/96]
Use only recommended fuels, lubricants, fluids,
and service parts that meet Ford Motor
Company specifications. Motorcraft parts are
designed and built to provide the best
performance in your vehicle. Using these parts
for replacement is your assurance that Ford-built
quality stays in your vehicle.
%*
[MC01150(ALL)05/96]
NOTE: Always dispose of used automotive
fluids in a responsible manner. Follow
your community's standards for
disposing of these types of fluids. Call
your local recycling center to find out
about recycling automotive fluids.
%
*
[MC01600(ALL)01/96]
Precautions When Servicing Your
Vehicle
*
[MC01700(ALL)01/96]
Be especially careful when inspecting or
servicing your vehicle. Here are some general
precautions for your safety:
%*
[MC01800(ALL)01/96]
q
Do not work on a hot engine. The engine
cooling fan may come on unexpectedly.
Always turn the engine off and let it cool.
*
[MC01850(ALL)05/96]
RWARNING
The cooling fan is automatic and may
come on at any time. Always disconnect
the negative terminal of the battery before
working near the fan.
*
[MC01900(ALL)01/96]
q
If you must work with the engine running,
avoid wearing loose clothing or jewelry that
could get caught in moving parts. Take
appropriate precautions with long hair.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

185
*
[MC02000(ALL)01/96]
q
Do not work on a vehicle in an enclosed
space with the engine running, unless you are
sure you have enough ventilation.
*
[MC02100(ALL)01/96]
q
Never get under a vehicle while it is
supported only by a jack. If you must work
under a vehicle, use safety stands.
*
[MC02200(ALL)01/96]
q
Keep all lit cigarettes and other smoking
materials away from the battery and all
fuel-related parts.
*
[MC02500(ALL)01/96]
If you disconnect the battery, the engine must
ªrelearnº its idle conditions before your vehicle
will drive properly. To find out how the engine
does this, seeBatteryin this chapter.
*
[MC02700(ALL)01/96]
Working with the engine off:
*
[MC02750(ALL)01/96]
1. Set the parking brake fully and make sure
the gearshift is securely latched in P (Park)
(automatic transaxle) or Neutral (manual
transaxle).
*
[MC02800(ALL)01/96]
2. Remove the key from the ignition after you
turn the engine off.
*
[MC02850(ALL)01/96]
3. Block the wheels. This will prevent your
vehicle from moving unexpectedly.
*
[MC02900(ALL)01/96]
Working with the engine on:
*
[MC03000(ALL)01/96]
1. Set the parking brake fully and make sure
the gearshift is securely latched in P (Park)
(automatic transaxle) or Neutral (manual
transaxle).
*
[MC03100(ALL)01/96]
2. Block the wheels. This will prevent your
vehicle from moving unexpectedly.
*
[MC03200(ALL)01/96]
RWARNING
Do not start your engine with the air
cleaner removed and do not remove it
while the engine is running.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

186 %
*
[MC03400(ALL)02/96]
Opening the Hood
%*
[MC03500(ALL)02/96]
1. Inside the vehicle, pull the hood release
handle located under the bottom left corner
of the instrument panel.
%*
[MC03600(ALL)02/96]
2. Go to the front of the vehicle and release the
auxiliary latch that is located under the hood
at the center of the vehicle.
[MC03750(ALL)01/96]
3. Lift the hood and set the prop rod in the
hole in the hood marked with an arrow.
*
[MC03800(ALL)02/96]
When you close the hood, make sure the prop
rod is in its retainer and that the hood latches
securely.
[MC03900(ALL)01/96]
half page art:0032100-A
The hood release handle
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

187
*
[MC04100(ALL)12/95]
NOTE: Apply lubricant to the hood latch at
six-month intervals to maintain smooth
and trouble-free operation.
*
[MC04200(ALL)01/96]
NOTE: Read and understandPrecautions When
Servicing Your Vehicleat the beginning
of this chapter before opening the
hood.
[MC04450(ALL)01/96]Engine Types
*
[MC04600(ALL)01/96]
Your vehicle has one of these types of engines:
[MC04700(ALL)01/96]
q
a 2.0L (121 CID) fuel injected 16-valve
four-cylinder engine.
[MC04800(ALL)01/96]
q
a 2.5L (152 CID) fuel injected 24-valve
six-cylinder engine.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

188 [MC05400(ALL)01/96]
three fourths page art:0032074-BThe 2.0L engine
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996