Hyundai Getz 2002 Owner's Manual

FEATURES OF YOUR HYUNDAI 1- 7
B070A01A-EAT ANTI-THEFT ALARM SYSTEM (Not all models) This system is designed to provide protection from unauthorized entry intothe car. This system is operated inthree stages: the first is the "Armed"stage, the second is the "Alarm" stage, and the third is the "Disarmed" stage. If triggered, the system provides an au-dible alarm with blinking of the turnsignal lights.
The central door locking is operated bypushing the driver's door lock switchtoward the front or rear of the vehicle. Ifthe passenger and rear doors are openwhen the switch is pushed, the door will remain locked when closed. NOTE:
o When pushing the switch toward
the rear, all doors and tail gate will unlock.When pushing the switch towardthe front, all doors and tail gate will lock.
o When the door is unlocked, the red mark on the switch is visible and the character "LOCK" on theswitch is visible.
o The central door locking is oper- ated by turning the key (with theft-alarm system: driver's door andpassenger's door, without theft-alarm system: driver's door only)toward the front or rear of thevehicle. Park the car and stop the engine. Armthe system as described below.
1) Remove the ignition key from the
ignition switch.
2) Make sure that the engine bonnet
and tail gate are locked.
3) Lock the doors using the transmitter
of the keyless entry system.
After completion of the steps above, the turn signal lights will blink once to indicate that the system is armed. NOTE:
1) If any door, tail gate or engine bonnet remains open, the system will not be armed.
2) If this happens, rearm the system as described above.
CAUTION:
Do not arm the system until all pas-sengers have left the car. If the sys-tem is armed while a passenger(s)remains in the car, the alarm may beactivated when the remaining passenger(s) leaves the car.
!
HTB052-D
B070B01O-DAT Armed Stage

1- 8 FEATURES OF YOUR HYUNDAI
HTB202
B070D01TB-AAT Disarmed Stage
B070C01FC-EATAlarm Stage The alarm will be activated if any of the following occurs while the car is parkedand the system is armed.
1) A front or rear door is opened without
using the transmitter.
2) The tail gate is opened without using the transmitter.
3) The engine bonnet is opened.The alarming horn will sound and the turn signal lights will blink continuously for 27 seconds. To turn off the system,unlock the door or tail gate with thetransmitter. The system will be disarmed when thedriver's or passenger's door is un-locked by depressing the button on the transmitter. After completion of the step above, the turn signal lights will blink twice toindicate that the system is disarmed. NOTE: Once the system has been dis- armed, it can not be rearmed exceptby repeating the arming procedures. CAUTION:
Only the transmitter can disarm thearmed stage. If the transmitter does not disarm the system, it is neces- sary to take the following steps;
1. Unlock the door with the key, which will cause, the alarm to be activated.
2. Insert the key in the ignition key
cylinder and turn the ignition keyto "ON" position.
3. Wait for 30 seconds. After completing the steps above, the system will be disarmed.
!

FEATURES OF YOUR HYUNDAI 1- 9
HTB053
B070F01TB-EAT Keyless Entry System (Not all models) Locking doors
1. Close all doors.
2. Push the button on the transmitter.
3. At the same time all doors lock, the
turn signal light will blink once toindicate that the system is armed.
Unlocking doors
1. Push the button on the transmitter.
2. At the same time all doors unlock, the turn signal light will blink twice toindicate that the system is disarmed. B070E01TB-GAT Replacing the battery When the transmitter's battery begins to get weak, it may take several pusheson the button to lock or unlock thedoors, and the LED will not light. Re-place the battery as soon as possible. Battery type : CR1220 Replacement instructions:
1. Remove the screw with a (+) screw-
driver.
2. Separate the case with a (-) screw-
driver as shown in the illustration. 3. Remove four screws back side of the
built-in circuit. HTB054
HTB055
Battery
4. Remove the old battery from the case and note the polarity. Make sure the polarity of the new batteryis the same (+side facing up), theninsert it in the transmitter.

1- 10 FEATURES OF YOUR HYUNDAI
HTB257-D
SB060A1-E DOOR WINDOWS
The front door windows may be opened or closed by turning the window regula-tor handle. Ensure that when the win- dows are closed, nothing may become trapped between the glass and the doorframe. HTB064-D
(1)
HTB066-D
In order to prevent operation of the passenger front and rear windows, awindow lock switch is provided on thearmrest of the driver's door. To disablethe power windows, press the windowlock switch. To revert to normal operation, press the window lock switch a second time. Auto-Down Window (Driver's Side) The Auto-Down window is moved to its fully open position by pushing theswitch. To stop at the desired position push the switch again.
B060A01E-EAT POWER WINDOWS (Not all models)
The power windows operate when the ignition key is in the "ON" position. Themain switches are located on the driver'sarmrest and control the front and rearwindows on both sides of the vehicle.The windows may be opened by de- pressing the appropriate window switch and closed by pulling up the switch. Toopen the window on the driver's side,press the switch(1) down. The windowmoves as long as the switch is oper-ated.
WARNING:
When opening or closing the win-dows, make sure your passenger's arms and hands are safety out of the way.
!

FEATURES OF YOUR HYUNDAI 1- 11
HTB026-D
HTB024-D
B080A01FC-EAT SEAT ADJUSTMENT B080B01FC-EAT FRONT SEATS Front Seat Rake Adjustment
The front seat rake adjustment is per- formed by raising the lever at the frontof the seat base and sliding the seat tothe desired position. At this position thelever should be released and the seat rocked to and fro to ensure that the mechanism has locked.
!WARNING:
Front seat adjustments must not be undertaken whilst the vehicle is in motion. Loss of control of the ve- hicle may result if seat adjustmentsare made whilst the vehicle is inmotion. SB070C1-E Front Seat Recline Adjustment
WARNING:
1) Be careful that someone's head, hands and body are not trapped by a closing window.
2) Never try to operate the main switch on the driver's door andthe individual door window switch in opposing directions at the same time. If this is done, the windowwill stop and cannot be opened orclosed.
3) Do not leave children alone in the
car. Always remove the ignition key for their safety.
!
The front seat back recline angle may be adjusted by leaning forward slightly and raising the recline adjustment leverat the side of the seat. When theseatback is at the desired angle, thelever should be released. Ensure thatthe seatback is locked before driving the vehicle.

1- 12 FEATURES OF YOUR HYUNDAI
HTB025-D
SB070F1-F Seat Cushion Height Adjustment (Not all models) (Driver's seatonly)
To raise or lower the front part of the seat cushion, turn the front knob for-ward or rearward. To raise or lower the rear part of the seat cushion, turn the rear knob forward orrearward.HTB027-D
SB070E1-E Lumbar Support Adjustment (Not all models) (Driver's seatonly)
HFC2028
Lock knob
SB070D2-E Head Restraint Adjustment To raise the head restraint, pull it up. To lower it, push it down while pressing thelock knob. For maximum effectiveness in the event of an accident, the restraint must be adjusted so that the restraint isapproximately at the level of the seatoccupant's ears. The restraint mustnever be so adjusted that it is centredabout the level of the seat occupant's neck.
!WARNING:
Do not operate the vehicle with the restraints removed. The restraintsprovide protection against neck in- jury when installed and correctly adjusted. Some models are fitted with adjustabledriver seat lumbar support which maybe used to increase the amount oflumbar support offered by the seat back.Adjustment is performed by moving the handle at the side of the backrest in a forward direction to increase the sup-port.

FEATURES OF YOUR HYUNDAI 1- 13
ZB070A1-E REAR SEAT ENTRY (For 3-door model) The front passenger seatback should be tilted to enter the rear seat.By pulling up on the recliner control lever (1) at the outside of the front passenger seat, the seatback will tiltforward and the seat will automaticallyslide forward.Rear seat occupants can tilt the frontpassenger seatback by depressing the foot lever (2) as shown in the drawing. WARNING:
Passengers sitting in the rear seat should be careful not to accidentally press the foot lever (2) whilst the vehicle is moving. As this may causethe seat back to move forward andinjure a front seat occupant.
!
HTB028
Seatback folding lever
B080H01FC-EAT REAR SEAT Seat Rake Adjustment
HTB258-D
(1)
(2) The rear seat rake adjustment is per- formed by raising the lever at the frontof the seat base and sliding the seat tothe desired position. At this position thelever should be released and the seat rocked to and fro to ensure that the mechanism has locked.

1- 14 FEATURES OF YOUR HYUNDAI
HTB294
B099A02F-EAT BEFORE FOLDING THE REAR SEATS Outboard Rear Seat Belt
HTB300
!
Rear Seat Centre's 3 Point Type Seat Belt.
Lock Knob
SB070D2-E Head Restraint Adjustment To raise the head restraint, pull it up. To lower it, push it down while pressing thelock knob. For maximum effectivenessin the event of an accident, the restraintmust be adjusted so that the restraint is approximately at the level of the seat occupant's ears. The restraint mustnever be so adjusted that it is centredabout the level of the seat occupant'sneck.
HFC2028
!WARNING:
Do not operate the vehicle with the restraints removed. The restraints provide protection against neck in- jury when installed and correctlyadjusted.
In order to prevent the shoulder beltfrom being damaged while folding therear seat, the shoulder belt must bepassed through the hanger to keep itout of the way.CAUTION:
Seat belts must be removed from thehanger when in use.

FEATURES OF YOUR HYUNDAI 1- 15
WARNING:
o When you return the folded down seatback to its upright position, make sure the seat belts are in position to be accessible and tofunction properly.
o When you return the folded down
seatback to its upright position,be careful not to get your fingers or legs in.
o The purpose of the fold down
rear seatback and the fold for- ward rear seat cushion is to in-crease cargo space. Do not allowpassengers to sit in the cargo area while the car is moving. This is not a proper seating position
3. Pull the seat cushion release handle
rear ward, then lift up a desired seatcushion.
4. To secure the seat, hook the secur-
ing strap under the seat back to the headrest stay of front driver andpassenger seat.
5. To return the seatback and seat cushion to its normal position, re-verse the above procedure.
o When you return the seatback to its
upright position, always be sure it islocked into position by pulling andpushing on the top of seatback.
HTB030A
Seat cushion release handle
HTB031Securing strap
!
Securing Strap
HTB029Seatback folding lever
B090B01TB-EAT Folding Rear Seatback and Seat Cushion For greater convenience, the entire seatback and seat cushion may befolded down and up.
1. Push the headrest down to the low-
est position.
2. To fold down the seatback , push
and hold the seatback folding lever toward the headrest, then push downthe seatback.

1- 16 FEATURES OF YOUR HYUNDAI
HTB195
B140A01B-GAT REAR SEAT WARNING
For the safety of all passengers, lug- gage or other cargo should not be piledhigher than the top of the seatback.
and no seat belts are available foruse when the seatback is foldeddown. Passengers who are notproperly seated and wearing seatbelts could sustain serious inju- ries or death in case of an accident or a sudden stop.
o Objects should not extend higher than the top of the front seatbacks.This could allow cargo to slideforward and cause injury or dam- age during sudden stops.
o When you return the folded down seatback to its upright position, always be sure to install the head-rests in their proper positions.Headrests are important to the safety of occupants in a rear colli- sion. If the headrests are notinstalled in their proper position,serious injury or death could re-sult if a rear end collision occurs. SB090A1-E SEAT BELT PRECAUTIONS Seat belts should be worn at all times by all occupants front and rear. Thepossibility of injury or the severity ofinjuries suffered in the event of anaccident will be greatly reduced by the wearing of seat belts. In addition the following recommenda-tions should be observed.
SB090B1-E Babies/Small Children Babies and small children must be restrained using a restraint system spe-cifically designed for this purpose. Un-der no circumstances should a child be carried in the vehicle without the use of a suitable restraint which meets theregulations in force in the country wherethe vehicle is in operation.