ISUZU AXIOM 2002 Service Repair Manual

EXTERIOR/INTERIOR TRIM8J±3
Consoles
Consoles and Associated Parts
745R200005
Legend
(1) Cluster Upper Cover
(2) Center Cluster
(3) Knee Pad
(4) Seat Heater Switch (Required Option)
(5) Rear Console Assembly(6) CD Changer
(7) Rear Console Bracket
(8) Front Console Bracket
(9) Front Console Assembly
(10) Accessory Socket
Removal
1. Disconnect the battery ground cable.
2. Remove the cluster upper cover and connectors.
3. Pry the knee pads.
4. Remove the center cluster.

Remove the six screws and pull out the center
cluster at the six clip positions.
Disconnect the connectors.
5. Remove the rear console assembly.

Open the rear console lid and remove two screws.
6. Remove the front console assembly.

Remove six fixing screws and disconnect the
accessory socket connectors.

Disconnect the seat heater switch connectors (if so
equipped).

8J±4EXTERIOR/INTERIOR TRIM
7. Remove the CD changer.

Remove the four fixing bolts and the connector.Installation
To install, follow the removal steps in the reverse order.
Front Door Trim Panel
Front Door Trim Panel and Associated Parts
635R200012
Legend
(1) Glass
(2) Glass Run
(3) Door Mirror Assembly
(4) Door Mirror Cover
(5) Tweeter
(6) Speaker Spacer
(7) Speaker Assembly
(8) Inner Waist Seal
(9) Door Trim Panel
(10) Power Window Switch
(11) Inside Lock Bracket(12) Inside Handle
(13) Pull Box
(14) Courtesy Light
(15) Pull Box Bracket
(16) Waterproof Sheet
(17) Front Door Panel
(18) Door Lock Assembly
(19) Door Lock Cylinder
(20) Outside Handle
(21) Power Window Regulator
(22) Outer Waist Seal

EXTERIOR/INTERIOR TRIM8J±5
Removal
1. Disconnect the battery ground cable.
2. Remove the pull box.

Remove the one fixing screw.
635R200004
3. Remove the power window switch (1).

Pry the power window switch out and disconnect
the switch connector.
635R200002
4. Remove the inside handle.

Open the screw cover (1) and remove the screw.

Disconnect the cable.
635R200003
5. Remove the door mirror cover.
6. Remove the door trim panel.

Remove the trim panel with the eight clips (1) from
the door panel.
635R200005

Disconnect the tweeter and courtesy light
connectors.
7. Remove the inner waist seal.
8. Remove the courtesy light.
9. Remove the tweeter.
Installation
To install, follow the removal steps in the reverse order.

8J±6EXTERIOR/INTERIOR TRIM
Rear Door Trim Panel
Rear Door Trim Panel and Associated Parts
655R200009
Legend
(1) Glass Run
(2) Glass
(3) Division Bar
(4) Fix Window Glass
(5) Power Window Regulator
(6) Outside Handle
(7) Door Lock Assembly
(8) Pull Box Bracket
(9) Speaker Spacer
(10) Speaker(11) Pull Box
(12) Door Trim Panel
(13) Courtesy Light
(14) Power Window Switch
(15) Inside Handle
(16) Inside Lock Bracket
(17) Inner Waist Seal
(18) Tweeter
(19) Waterproof Sheet
(20) Outer Waist Seal
(21) Rear Door Panel

EXTERIOR/INTERIOR TRIM8J±7
Removal
1. Disconnect the battery ground cable.
2. Remove the pull box.

Remove the fixing screw.
655R200003
3. Remove the power window switch.

Pry the power window switch (1) and remove the
connector.
655R200004
4. Remove the inside handle.

Open the screw cover and remove the screw.

Disconnect the cable.
655R200008
5. Remove the door trim panel.

Remove the trim panel with the seven clips from the
door panel.
655R200005

Disconnect the tweeter and the courtesy light
connectors.
6. Remove the inner waist seal.
7. Remove the tweeter.
8. Remove the courtesy light.
Installation
To install, follow the removal steps in the reverse order.

8J±8EXTERIOR/INTERIOR TRIM
Door Mirror Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the door mirror cover (3).
3. Remove the door mirror assembly (1).

Remove the three nuts and disconnect the
connector (2).
635R200006
Installation
To install, follow the removal steps in the reverse order.
Interior Mirror Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the covers (1).
3. Remove the interior mirror assembly (4).

Pull the interior mirror up with the stay and remove
the interior mirror from the base (3).

Disconnect the connector (2).
720R200004
Installation
To install, follow the removal steps in the reverse order.

EXTERIOR/INTERIOR TRIM8J±9
Interior Trim Panels
Interior Trim Panels and Associated Parts
643R200003
Legend
(1) Assist Grip (Front & Rear)
(2) Door Finisher (Front & Rear)
(3) Upper Quarter Pillar Trim Cover
(4) Upper Rear Pillar Trim Cover
(5) Rear Roof Trim Cover
(6) Tailgate Weather Strip
(7) Multi Hook(8) Rear End Floor Trim Cover
(9) Lower Quarter Trim Cover
(10) Sill Plate (Front & Rear)
(11) Lower Center Pillar Trim Cover
(12) Upper Center Pillar Trim Cover
(13) Dash Side Trim Cover
(14) Front Pillar Trim Cover
Removal
1. Disconnect the battery ground cable.
2. Remove the sill plates (Front & Rear).
3. Remove the dash side trim cover.
4. Remove the lower center pillar trim cover.

Remove the lower anchor bolt cover and lower
anchor bolt from the front seat belt.

Pry the trim cover with the clips from the body panel.
5. Remove the door finishers (Front & Rear).

8J±10EXTERIOR/INTERIOR TRIM
6. Remove the upper center pillar trim cover.

Remove the cover (1) and screw.

Remove the shoulder anchor cap (2) and upper
anchor bolt (3) from the front seat belt.

Pry the trim cover with the clip from the body panel.
760R200006
7. Remove the front pillar trim cover.

Ply the trim cover with the clips from the body panel.
8. Remove the tailgate weather strip.
9. Remove the rear end floor trim cover.

Remove the four screw cover and nine fixing
screws.
10. Remove the rear roof trim cover.

Pry the trim cover with the clips from the body panel.
11. Remove the tonneau cover assembly (1).
643R200001
12. Remove the multi hooks.

While raising the notch of the hook with the
screwdriver, pull out the hook by turning 180
.
643R200004
13. Remove the lower quarter trim cover (1).

Remove the lower anchor bolt cover (4) and the
lower anchor bolt (3) from the rear seat belt.

Pull the trim cover at the five clip positions (2).

Disconnect the accessory socket connectors (LH
side).
643R200006
14. Remove the upper quarter pillar trim cover (1).

Remove the cover and screw, pull the trim cover at
the two clip positions (2).

Remove the shoulder anchor cap (4) and upper
anchor bolt (3) from the rear seat belt.

EXTERIOR/INTERIOR TRIM8J±11
15. Remove the upper rear pillar trim cover (5).

Pull the trim cover at the six clip positions (6) from
the body panel.
643R200007
16. Remove the assist grip (1) (Front & Rear).

Pull the assist grip downword.

Remove the caps and fixing bolts.
743R200001
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
1. Tighten the seat belt anchor bolt to the specified
torque.
Torque: 39 N´m (29 lb ft)

8J±12EXTERIOR/INTERIOR TRIM
Headlining
Parts Location
666R200001
Legend
(1) Interior Trim Panels
(2) Headlining (Without Sunroof)
(3) Clip
(4) Luggage Room Light
(5) Assist Grip
(6) Headlinng (With Sun Roof)(7) Sunroof Finisher (With Sunroof)
(8) Overhead Console/Sunroof Switch (With
Sunroof)
(9) Dome Light
(10) Overhead Console (Without Sunroof)
(11) Sunvisors
(12) Sunvisor Holder
Removal
1. Disconnect the battery ground cable.
2. Remove the interior trim panels.

Refer to
Interior Trim Panels in this section.
3. Remove the dome light.

Remove the dome light lens and the fixing screws.
Disconnect the dome light connectors.