lock ISUZU TFS SERIES 1997 Owners Manual
Page 570 of 1600
7C-30 CLUTCH
MASTER CYLINDER (Except 6VD1 Engine)
DISASSEMBLY
Repair Kit
Disassembly Steps
1. Oil tank band
2. Oil tank assembly
3. Joint
4. Lock nut
5. Dust cover6. Stopper ring
7. Stopper
8. Push rod
9. Piston assembly
10. Cylinder body
Important : Take care not to disassemble the push rod stopper for master cylinder which calk to the master cylinder
body due to the component parts do not disassemble.
Page 572 of 1600
7C-32 CLUTCH
REASSEMBLY
* Apply grease
(COSMO rubber grease)
Repair Kit
Reassembly Steps
1. Cylinder body
2. Piston and assembly
3. Push rod
4. Stopper
5. Stopper ring6. Dust cover
7. Lock nut
8. Joint
9. Oil tank assembly
10. Oil tank band
Important Operations
1. Cylinder Body
Immerse the cylinder body in clean brake fluid.
Page 582 of 1600
7C-42 CLUTCH
1. CLUTCH SLIPPAGE
Checkpoint Trouble Cause Countermeasure
Adjust the push rod playNo push rod play in the master
cylinder NG
Clean the related parts and/or
replace the facing
Replace the transmission front
cover oil seal
Clean the related parts and/or
replace the facing
Repair or replace the
transmission front cover
Adjust the push rod play
Defective transmission front
cover oil seal
Continued on the next page
Grease or oil adhering to the
facingToo much grease
Transmission front cover
unevenly worn
No push rod play in the slave
cylinder
Clean and grease the shift
blockShift blockInsufficient grease on the front
cover contact surfaces
NG NG NG NG NG
OK
OK
Clutch pedal free play
OK