JAGUAR XFR 2010 1.G Workshop Manual
Page 1331 of 3039
10.
11.
CAUTION: Make sure that all open ports are covered to
prevent any foreign material ingress. www.JagDocs.com
Page 1332 of 3039
1. CAUTION: Make sure that all open ports are covered to
prevent any foreign material ingress.
2. CAUTION: Apply a continuous bead of gasket sealant
as shown on the illustration. The application of the sealant
must be 1mm diameter. Install the component immediately
after applying the sealant without smearing the sealant.
3. Installation
Page 1333 of 3039
Page 1334 of 3039
6. NOTE: Loosen the adjustment screw.
Page 1335 of 3039
Page 1336 of 3039
Assemble the installation tool, supplied, to the actuator. www.JagDocs.com
Page 1337 of 3039
11.
12. Torque: 20 Nm
Remove the installation tool.
13. CAUTIONS:
Make sure that spring resistance is felt in both directions of the
pulley as shown.
Make sure that all open ports are covered to prevent any foreign
material ingress.
NOTE: Supercharger rotors will appear polished, this is normal.
Page 1338 of 3039
14. CAUTION: Make sure the components are installed as
noted on removal. Failure to follow this instruction may
result in damage to the component.
Page 1339 of 3039
16. Refer to: Supercharger (303-12D Intake Air Distribution and Filtering - V8 S/C 5.0L Petrol, Removal and Installation).
Page 1340 of 3039
Evaporative emission canister retaining nut 9 - 80 www.JagDocs.com