JAGUAR XFR 2010 1.G Workshop Manual
Page 2451 of 3039
a power supply to operate the glovebox latch to unlock the glovebox.
The glove box opening is inhibited by the CJB if the anti-theft alarm system is armed and if valet mode is selected using the Touch Screen Display (TSD). The CJB detects the voltage signal from the switch but will not operate the glovebox latch if other condition exists.
GLOVEBOX SWITCH DESCRIPTION Component Description
The conventional glove box switch is located behind the instrument panel veneer. The round button of the switch is visible
through an aperture in the veneer.
Two screws hold the switch in position behind the veneer. The veneer panel has two bosses which the screws are threaded
into.
Page 2452 of 3039
Instrument Panel and Console - Floor Console
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details. Published: 11-May-2011
1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
2. Refer to: Floor Console Cup Holder (501-12 Instrument Panel and Console, Removal and Installation).
3. CAUTIONS:
Protect the surrounding trim to avoid damage.
Cover fiber optic cable connectors to minimize dust
ingress and avoid bending the cables in a radius of less
than 30 mm.
Page 2453 of 3039
5.
Page 2454 of 3039
7. www.JagDocs.com
Page 2455 of 3039
9.
Page 2456 of 3039
Page 2457 of 3039
Instrument Panel and Console - Floor Console Cup Holder
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details. Published: 11-May-2011
1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
2. Refer to: Floor Console Double Cup Holder (501-12 Instrument Panel and Console, Removal and Installation).
3.
4. CAUTION: Take extra care not to damage the
component.
NOTE: Do not disassemble further if the component is
removed for access only.
Page 2458 of 3039
Installation
1. NOTE: Make sure that the veneer trim panel is correctly installed
and secured.
To install, reverse the removal procedure.
Page 2459 of 3039
Published: 11-May-2011
Instrument Panel and Console - Floor Console Double Cup Holder
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
2. Refer to: Transmission Control Switch (TCS) (307-05A Automatic Transmission/Transaxle External Controls - V6 3.0L Petrol, Removal and
Installation).
3.
4.
5. www.JagDocs.com