JAGUAR XFR 2010 1.G Workshop Manual

6. WARNING: This step requires the aid of another
technician.


NOTE: Note the fitted position of the spacers.
Torque: 8 Nm









7. NOTE: Do not disassemble further if the component is
removed for access only.

Torque: 4 Nm












8.

9.
Installation


1. CAUTION: Make sure that the component is correctly located on the
locating dowels.


NOTE: Replace the spacers to the fitted position.

To install, reverse the removal procedure.

Roof Opening Panel - Roof Opening Panel Glass
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details.


1.
2. Published: 11-May-2011

1. To install, reverse the removal procedure. www.JagDocs.com

Roof Opening Panel - Roof Opening Panel Motor
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details. Published: 11-May-2011

1. Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).




Installation

2. Torque: 4 Nm
1. To install, reverse the removal procedure.

Roof Opening Panel - Roof Opening Panel Rear Drain Hose
Removal and Installation

Removal Published: 11-May-2011

1. Refer to: Loadspace Trim Panel RH (501-05 Interior Trim and Ornamentation, Removal and Installation).

2. Refer to: Headliner (501-05 Interior Trim and Ornamentation, Removal and Installation).


3. NOTE: RH side only.























4. NOTE: RH illustration shown, LH is similar.

Removal and Installation).




Installation

2. NOTE: Make sure that this component is installed to
the noted removal position.

1. To install, reverse the removal procedure.

Radiator splash shield outer retaining bolts 3 - 26 Radiator splash shield inner retaining bolts 7 - 62 Radiator splash shield inner retaining screws 2 - 18 Front bumper cover retaining bolts 2 - 18 Rear bumper cover retaining bolts 7 - 62 Rear bumper retaining bolts 25 18 - www.JagDocs.com

Bumpers - Front Bumper
Removal and Installation Published: 11-May-2011

Removal

1. The front bumper is serviced as a separate bolt-on panel.














2. The front bumper is replaced in conjunction with:
Front bumper cover


3. WARNING: The hood and its associated components form part of the
pedestrian protection system, it is essential that any repair or
replacement operations do not affect the safe working of the system.

For additional information relating to the pedestrian safety system
please see the following:
For additional information, refer to: Pedestrian Protection System (501-20C Pedestrian Protection System, Description and Operation).

4. For additional information relating to this repair procedure please see
the following:
For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation) /
Body Repairs (501-25A Body Repairs - General Information, Description and Operation) /
Corrosion Protection (501-25B Body Repairs - Corrosion Protection, Description and Operation) /
Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).

5. Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

6. Remove the front bumper cover.
For additional information, refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).

7. Release and position the front bumper wiring harness and the hood
release cable to one side.