JAGUAR XFR 2010 1.G Workshop Manual
Page 2641 of 3039
10.
11. NOTE: Note the position of the wiring harnesses to
aid installation.
Page 2642 of 3039
12.
13. CAUTION: Take extra care not to damage the clips.
NOTE: Note the position of the wiring harnesses to
aid installation.
Page 2643 of 3039
Page 2644 of 3039
17.
18.
19.
WARNING: Do not probe supplemental restraint
system (SRS) electrical connectors. www.JagDocs.com
Page 2645 of 3039
Installation 20.
1. CAUTION: The front passenger seat occupant
classification sensor is available only as a service kit. No
attempt should be made to replace individual components.
Failure to follow this instruction may result in personal
injury.
Page 2646 of 3039
2. NOTES:
Make sure that new hog rings are installed.
Use hog ring pliers to close the hog rings. Do not use
any other tool. The hog rings must be closed to overlap as
illustrated.
3.
4.
Page 2647 of 3039
Page 2648 of 3039
8. NOTE: Make sure that the harness is routed to the
position noted on removal.
9.
Page 2649 of 3039
10.
11. Torque: 4 Nm
NOTE: Make sure that the harness is routed to the
position noted on removal. www.JagDocs.com
Page 2650 of 3039
12.
13.
14. CAUTION: Make sure that the wiring harness is routed
above the drive bar as shown, to avoid damage to the
wiring harness during movement of the front seat.
NOTES:
An audible click is heard when the clips are fully
latched.
Make sure the electrical connector is securely
connected.
Torque: 1.3 Nm