torque JAGUAR XFR 2010 1.G Workshop Manual
Page 2649 of 3039
10.
11. Torque: 4 Nm
NOTE: Make sure that the harness is routed to the
position noted on removal. www.JagDocs.com
Page 2650 of 3039
12.
13.
14. CAUTION: Make sure that the wiring harness is routed
above the drive bar as shown, to avoid damage to the
wiring harness during movement of the front seat.
NOTES:
An audible click is heard when the clips are fully
latched.
Make sure the electrical connector is securely
connected.
Torque: 1.3 Nm
Page 2659 of 3039
19.
20.
21. CAUTION: Fixings must be started by hand to avoid
damaging threads.
Torque:
M8 2.5 Nm T27 9 Nm www.JagDocs.com
Page 2660 of 3039
22.
23.
CAUTION: Fixings must be started by hand to avoid
damaging threads.
Torque:
M8 2.5 Nm T27 9 Nm
Page 2661 of 3039
Torque: 20 Nm
Page 2662 of 3039
Torque: 20 Nm
Page 2666 of 3039
5.
6. Torque: 6 Nm 7.
8. NOTES:
If the SRS component is to be replaced, the bar code
of the new unit must be recorded.
The RCM will record and store impact data. The
module must be replaced when three records are noted.
Torque: 10 Nm
Page 2673 of 3039
Supplemental Restraint System - Side Air Curtain Module
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles Published: 19-May-2011
1. Make the air bag supplemental restraint system (SRS) safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
3. Refer to: Interior Rear View Mirror (501-09 Rear View Mirrors, Removal and Installation).
4. Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
5. Refer to: Sun Visor (501-05 Interior Trim and Ornamentation, Removal and Installation).
6. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
7. Refer to: B-Pillar Upper Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
8. Refer to: C-Pillar Lower Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
9. Torque: 2 Nm
Page 2676 of 3039
Vehicles with roof opening panel
13. NOTES:
Note the different lengths of screws.
Make sure that the component is installed to the
position noted on removal.
Torque: 2 Nm
Page 2677 of 3039
Vehicles without roof opening panel
14. NOTES:
Note the different lengths of screws.
Make sure that the component is installed to the
position noted on removal.
Torque: 2 Nm
All vehicles
15.