JAGUAR XFR 2010 1.G Workshop Manual
Page 761 of 3039
Torque: 25 Nm
Page 762 of 3039
Installation
14.
15.
CAUTION: Note the fitted position of the component
prior to removal.
1. To install, reverse the removal procedure.
Page 763 of 3039
Published: 05-Feb-2014
Power Steering - Power Steering Pump to Steering Gear Pressure Line V8 5.0L Petrol/V8 S/C 5.0L Petrol
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Power Steering System Filling - V8 5.0L Petrol/V8 S/C 5.0L Petrol (211-00 Steering System - General Information, General Procedures).
3. Torque: 11 Nm 4. NOTE: RHD shown, LHD is similar.
5. Lower the vehicle.
Page 764 of 3039
6. CAUTION: Make sure on installation the component is
correctly located.
7. WARNING: Fluid loss is unavoidable, use absorbent
cloth or a container to collect the fluid.
CAUTION: Always plug any open connections to
prevent contamination.
NOTES:
Note the fitted position.
Discard the sealing washers.
Torque: 28 Nm
8. Raise the vehicle.
9. WARNING: Fluid loss is unavoidable, use absorbent
cloth or a container to collect the fluid.
CAUTION: Always plug any open connections to
prevent contamination.
NOTES:
RHD shown, LHD is similar.
Discard the retaining bolt.
Discard the o-ring seals.
Torque: 20 Nm www.JagDocs.com
Page 765 of 3039
Installation
10.
NOTE: RHD shown, LHD is similar.
1. To install, reverse the removal procedure.
Page 766 of 3039
Published: 03-Jun-2011
Power Steering - Steering Gear to Fluid Cooler Return Hose V8 5.0L Petrol/V8 S/C 5.0L Petrol
Removal and Installation
Removal
NOTES:
Some variation in the illustrations may occur, but the essential information is always correct.
Removal steps in this procedure may contain installation details.
All vehicles
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Power Steering System Filling - V8 5.0L Petrol/V8 S/C 5.0L Petrol (211-00 Steering System - General Information, General Procedures).
3. NOTE: If equipped.
4.
Left-hand drive vehicles
Page 767 of 3039
Petrol (211-00 Steering System - General Information, General Procedures). www.JagDocs.com
Page 768 of 3039
Tie-rod end retaining nut 133 98 - Tie-rod end lock nut 55 41 -
Page 769 of 3039
1 Steering gear boot 2 Inner tie-rod arm 3 Locknut 4 Outer tie-rod arm 5 Taper ball joint 6 Locknut
Page 770 of 3039
Steering Linkage - Steering Linkage - Overview
Description and Operation
OVERVIEW Published: 11-May-2011
The steering linkage comprises the tie rod which provides the connection between the steering gear and the front wheel
knuckle. Each end of the steering gear has a threaded hole which provides for the fitment of the inner tie rods. The external
ends of the inner tie rods are sealed with boots to prevent the ingress of dirt and moisture into the steering gear.