JAGUAR XFR 2010 1.G Manual Online

1
Steering wheel in straight ahead position 2
Steering column lock locked 3
Steering column lock unlocked

4
Turn the steering wheel to the 90° left position 5
Turn the steering wheel to the 90° right position 6
Turn the steering wheel to the left-hand end position 7
Turn the steering wheel to the right-hand end position












































Item
Description 1
3, 4, 5-door body style 2
Wagon body style 3
Sports utility vehicle body style 4
Coupe body style 5
Convertible body style 6
Van body style 7
3, 4, 5-door body style - Top View 8
Wagon body style - Top View 9
Underview 10
Right-hand drive (RHD) vehicle 11
Left-hand drive (LHD) vehicle

1
Set the selector lever to the park (P) position 2 Set the selector lever to the reverse ®) position 3
Set the selector lever to the neutral (N) position 4
Set the selector lever to the drive (D) position 5
Set the selector lever with manual shift pattern to the park (D) position 6
Set the selector lever with manual shift pattern to the manual (M) position 7
Set the selector lever with manual shift pattern to the shift down (-) position 8
Set the selector lever with manual shift pattern to the shift up (+) position 9
Set the gearshift lever to the neutral (N) position 10
Further gearshift lever positions that may appear in illustrations

1
Screwdriver 2
Cross bladed screwdriver 3
Flat bladed screwdriver 4
Hexagonal screwdriver 5
TORX screwdriver www.JagDocs.com

1
Combination pliers 2
Side cutter pliers

4
Securing ring pliers - outer 5
Hose clamp pliers 6
Locking pliers 7
Long nose pliers Drill symbols

The drill symbols are used to show which type and size of drill bit is recommended to carry out a procedure step.



Item
Description 1
Drill bit with a specified diameter 2
Hole saw with a specified diameter 3
Stepped drill bit with a specified diameter 4
Tap with a specified diameter 5
Die with a specified diameter 6
Scraper for circular holes 7
Scraper for straight edges

1
Cutting knife 2
Air body saw 3
Scissors 4
Grinder 5
Jig saw

7
Sanding Paper 8
Drill through the shown number of body panel layers with a specified diameter 9
Drill through the shown number of body panel layers with a suitable diameter 10
Drill through 1 body panel layer with a specified diameter 11
Drill through 1 body panel layer with a suitable diameter 12
Wire brush

1
Apply a bead from the specified tube 2
Apply a bead from the specified cartridge 3
Apply the specified chemical with a brush 4
Apply the specified load to the specified component 5
Apply a bead with a specific diameter from the specified tube www.JagDocs.com