LAND ROVER FRELANDER 2 2006 Repair Manual
Page 2391 of 3229
1
1
se al?YesInst all a newwind deflect or.REFER t o: AirDeflect or(501-17 RoofOpening Panel,Remova l a ndInst allat ion).NoGO t o F4.F4: GLASS PANEL SEAL - LOCAT IONConfirm thatt he roofopening panel,glass panelseal is correct lylocated, s ecurewith no ki nks.
Is t he roof openingpane l gl ass panelse al correct lylocat ed and securewith no kinks.REFER t o: RoofOpening Panel Sea l(501-17 RoofOpening Panel,Removal andInst allat ion).YesGO t o F5.NoInst all a newglass panelseal.REFER t o: RoofOpening PanelSeal (501-17Roof OpeningPanel, RemovalandInst allat ion).F5: ROOF OPENING - APERT URE• NOTE: The pre vious s teps have confirme d that t he route of t he wat er ingress i s not t hrough t he roof opening panel but t hrough t he bondeds eal bet ween t he vehicle body t he roof opening panel frame .Carry out awater leak t estof the bondedseal be tweent he vehiclebody t he roofopening panelframe t o l ocat et he point ofwater ingres s.Can t he wat eringres s point belocat ed on thebonded sealbet ween the vehiclebody the roofopening panelframe?
Page 2392 of 3229
1
1
YesUsing t hemanufacture rapprove dproce ss applyseale r t o t hepoint of wat eringress .NoThe wateringress pointhas not beenlocated or t heroof openingpanel framerequiresremova l t oenable a wat ert ight s eal to beest ablis hed.Contact dealertechnicalsupport
PINPOINT TEST G : ROOF OPENING PANEL - WIND NOISET EST CONDIT IONSDETAILS/RESULT S/ACT IONSG1: ROOF OPENING PANEL - OPERATION• NOTE: These t est s are to be carried out t o det ermine t he caus e of t he wind noise around t he roof opening panel area.Operate t heroof openingpanel t hroughall poss ibleposit ions (sl ideopen / slidecl ose / t ilt open/ tilt clos e)using t he roofmount edswitch.Does t he roofopening paneloperat e correctl y?YesGO t o G2.NoGO t o PinpointTest C.G2: SIDE ACOUSTIC SEAL - LOCATIONCarry out avis ualinspe ct ion oft he sideacoust ic sea lsfor locat ion andsecurity.
Are t he sideacoust ic se alscorre ct ly loca tedand bonded to t heroof opening pa nelframe?YesGO t o G3.NoCorrect lyrelocate andbond t he sideacoust ic sea lst o the roofopening panelframe. GO toG3.G3: FRONT ACOUST IC SEAL - LOCAT ION
Page 2393 of 3229
1
1
Carry out avis ualinspe ct ion oft he frontacoust ic sea lsfor locat ion andsecurity.
Vehiclesbuilt up toVIN 154971.Vehiclesbuilt fromVIN 154972.
Is t he front acoust icse al correct lylocat ed and bondedt o the roof openingpane l frame?YesGO t o G4.NoReplace thefront acoust icseal. Clean allrelevantsurfaces t hencorrectl yposit ion andbond t he frontacoust ic sea l t ot he roofopening panel.GO t o G4.G4: GLASS SEAL - LOCAT IONCarry out avis ualinspe ct ion oft he glass s ealfor locat ion andsecurity.
Is t he glass s ealcorre ct ly loca tedand bonded to t heroof opening pa nelframe?YesGO t o G5.NoReplace theglass seal.
Page 2394 of 3229
1
1
2
3
1
Clean allrelevantsurfaces t hencorrectl yposit ion andbond t he glassseal t o t he roofopening panel.GO t o G5.G5: DRIP LIP - LOCATIONCarry out avis ualinspe ct ion oft he drip lip ont he glass pa nelfor locat ion andsecurity.
Is t he drip lipcorre ct ly loca ted ont he glass panel?YesGO t o G7.NoReplace theglass panel(The drip lip isnot aservi ceablepart ). GO t oG6.G6: INIT IALIZAT IONPerform themanual roofopening panelinit ializat ionproce dure.REFER t o:MotorSynchronizat ion(501-17 RoofOpening Panel,GeneralProce dures).Operate t heroof openingpanel t hroughall poss ibleposit ions (sl ideopen / slidecl ose / t ilt open/ tilt clos e)using t he roofmount edswitch.Check thevehicle for windnoise from t heroof openingpanel.Is t he wind nois est ill evident?YesCont act dealert echnicalsupport .NoNo furt heraction required.G7: INIT IALIZAT IONPerform themanual roofopening panelinit ializat ionproce dure.REFER t o:MotorSynchronizat ion(501-17 RoofOpening Panel,GeneralProce dures).
Page 2395 of 3229
2
1
1
Check thevehicle for windnoise from t heroof openingpanel.Is t he wind nois est ill evident?YesCont act dealert echnicalsupport .NoNo furt heraction required.
PINPOINT TEST H : SEALS LOOSE OR ADRIFTT EST CONDIT IONSDETAILS/RESULT S/ACT IONSH1: SIDE ACOUSTIC SEAL - LOCATIONCarry out avis ualinspe ct ion oft he sideacoust ic sea lsfor locat ion andsecurity.
Are t he sideacoust ic se alscorre ct ly loca tedand bonded to t heroof opening pa nelframe?YesGO t o H2.NoCorrect lyrelocate andbond t he sideacoust ic sea lst o the roofopening panelframe. GO toH2.H2: FRONT ACOUST IC SEAL - LOCAT IONCarry out avis ualinspe ct ion oft he frontacoust ic sea lsfor locat ion andsecurity.
Vehiclesbuilt up toVIN 154971.Vehiclesbuilt fromVIN 154972.
Is t he front acoust icse al correct lylocat ed and bondedt o the roof openingpane l frame?
Page 2396 of 3229
1
1
YesGO t o H3.NoCorrect lyrelocate andbond t he frontacoust ic sea l t ot he roofopening panelframe. GO toH3.H3: GLASS SEAL - LOCAT IONCarry out avis ualinspe ct ion oft he glass s ealfor locat ion andsecurity.
Is t he glass s ealcorre ct ly loca tedand bonded to t heroof opening pa nelframe?YesGO t o H4.NoReplace theglass seal andbond t he fourcorne rs of t heglass seal t ot he roofopening panelframe. GO toH4.H4: DRIP LIP - LOCATIONCarry out avis ualinspe ct ion oft he drip lip ont he glass pa nelfor locat ion,condition andsecurity.
Is t he drip lipcorre ct ly loca ted ont he glass panel andin good condit ion?YesThe drip lip iscorrectl ylocated on t heglass panel. No
Page 2397 of 3229
further act ionrequired.NoReplace theglass panel(The drip lip isnot aservi ceablepart ).
Roof opening panel blind rewind procedure - Vehicles built up to VIN 154971
1. Close t he roof opening panel blind (but do not lat ch t he handle t o the frame ) .1.
• NOTE: Rot at e the roof opening panel in t he direct ions illus trat ed.
2. Releas e the roof opening panel blind from the runners.
Rota te t he left -hand e dge count er clockwise and releas e the right -hand edge from t he fra me.
2.
3. Open the roof opening panel blind.3.
Page 2398 of 3229
4. Releas e the roof opening panel blind from the mount ing bracke t and remove the roof opening panel blind from the vehicl e.
1. Push the roof ope ning panel blind in t o the frame t o releas e t he left -hand spring axle .2. Rot at e the roof opening panel blind count er clockwis e.3. Remove t he roof ope ning panel blind.
4.
• NOTE: The roof ope ning panel must be rewound 7 rotat ions .
5. Rewind the roof opening panel.
1. Using a s uit able tool, hol d a nd rotat e t he spring axle.2. Push the spring axle in t o the roof ope ning panel blind and al ign the s pring axle locking holes .3. Using s uit able pin or paperclip (as illustrat ed), lock t he spring axle.
5.
• NOTE: Make sure t hat the s pring axle is correct ly located into t he roof opening panel frame.
• NOTE: Make sure t hat the s uit able pin or paperclip rema ins in place while ins talling t he roof opening pa nel blind.
6. Inst all the roof ope ning panel blind t o t he frame.
6.
Page 2399 of 3229
Remove t he suit able pin or pape rclip from the roof opening panel blind once the roof opening panel has bee n correct lyinst alled.
7. Inst all the roof ope ning panel blind s liders to t he runners.
1. Push the roof ope ning panel blind right -hand slider in t o the runner.2. Inst all t he left -hand s lider clockwise t o t he runner.
7.
8. Open the roof opening panel blind and check for corre ct operati on.8.
Roof opening panel blind rewind procedure - Vehicles built from VIN 154972
1. Close t he roof opening panel blind.1.
• NOTE: Rot at e the roof opening panel in t he direct ions illus trat ed.
2. Releas e the roof opening panel blind from the runners.
Rota te t he left -hand e dge count er clockwise and releas e the right -hand edge from t he fra me.
2.
Page 2400 of 3229
3. Open the roof opening panel blind.3.
4. Using a sui table pi n or paperclip (as illust rat ed), releas e the roof opening panel blind from t he mount ing bracket and remove theroof opening panel blind from the vehicle.4.
• NOTE: The roof ope ning panel must be rewound 14 rotat ions .
5. Rewind the roof opening panel.
1. Push the spring axle in t o the roof ope ning panel blind.2. Using a s uit able tool, hol d a nd rotat e t he spring axle.3. Rele ase t he spring axle 17 mm from t he roof opening pane l blind once aft er the 14 rot at ions have been achi eved.
5.