MERCEDES-BENZ E350 4MATIC WAGON 2007 S211 Owner's Manual

470 Practical hintsTowing the vehicleInstalling towing eye bolt
Front of vehicle
1Cover on right side of front bumper
To remove cover:
Press mark on cover1 in direction of
arrow.

Lift cover1 off to reveal the threaded
hole for towing eye bolt.
The towing eye bolt is supplied with the
tool kit (located in the storage compart-
ment under the cargo compartment floor).

Screw towing eye bolt in to its stop and
tighten with lug wrench.
To reinstall cover:

Fit cover1 and snap into place.
Rear of vehicle
2Cover on right side of rear bumper
To remove cover:

Pull cover2 in direction of arrow.

Fold cover2 down to reveal the
threaded hole for the towing eye bolt.The towing eye bolt is supplied with the
tool kit (located in the storage compart-
ment under the cargo compartment floor).

Screw towing eye bolt in to its stop and
tighten with lug wrench.
To reinstall cover:

Fit cover2 and snap into place.

471 Practical hintsFuses
Fuses
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operat-
ing.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
The following aids are available to help you
replace fuses.


Fuse chart
The fuse chart is located in the main
fuse box in the passenger compart-
ment (
page 472). The fuse chart ex-
plains the fuse allocation and fuse
amperages.


Spare fuses
Spare fuses are located in the vehicle
tool kit in the cargo compartment
(page 430).


Fuse extractor
The fuse extractor is located in the ve-
hicle tool kit in the cargo compartment
(page 430).The electrical fuses are located in different
fuse boxes:


in the passenger compartment on the
driver’s side (
page 472)


in the cargo compartment
(page 472)
Before replacing fuses:

Apply the parking brake (
page 62).

Make sure the gear selector lever is set
to position P (
page 187).

Turn off all electrical consumers.

Turn off the engine (
page 63).

Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door.
Warning!
G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center.i
A blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to advise
you on this subject.

472 Practical hintsFusesFuse box in passenger compartment
The fuse box is located behind a cover in
the dashboard on the driver’s side.
1Cover
2Recess in the coverOpening

Open the driver’s door.

Insert flat, blunt object as a lever in
recess2 on the edge of cover1.

Loosen cover1 from the dashboard
using lever.

Using your hands, pull cover1 in di-
rection of arrow and remove.
Closing

Hook cover1 into the opening at the
front.

Press cover1 back on until it engag-
es.
Fuse box in cargo compartment
The fuse box is located behind the
left-hand trim panel in the cargo compart-
ment.
1Button for unlocking trim panel
2Trim panel
Opening trim panel
Press button1.

Fold down trim panel2.
Closing trim panel

Fold up trim panel2.
!
Do not use sharp objects such as a screw
driver to open the fuse box cover1 in the dash-
board, as this could damage it.
!
The cover1 must be properly positioned
as described to prevent moisture or dirt from en-
tering the fuse box and possibly impairing fuse
operation.

473 Technical data
Parts service
Warranty coverage
Identification labels
Layout of poly-V-belt drive
Engine
Rims and tires
Electrical system
Main dimensions and weight
Fuels, coolants, lubricants etc.

474 Technical dataThe “Technical data” section provides the
necessary technical data for your vehicle.Parts service
All authorized Mercedes-Benz Centers
maintain a stock of Genuine
Mercedes-Benz Parts required for mainte-
nance and repair work. In addition, strate-
gically located parts distribution centers
provide quick and reliable parts service.
More than 300 000 different parts for
Mercedes-Benz models are available.
Genuine Mercedes-Benz Parts are subject-
ed to stringent quality inspections. Each
part has been specifically developed, man-
ufactured or selected for and adapted to
Mercedes-Benz vehicles.
Therefore, Genuine Mercedes-Benz Parts
should be installed.
!
The use of non-genuine Mercedes-Benz
parts and accessories not authorized by
Mercedes-Benz could damage the vehicle, which
is not covered by the Mercedes-Benz Limited
Warranty, or could compromise the vehicle’s du-
rability or safety.

475 Technical data
Warranty coverage
Warranty coverage
Your vehicle is covered under the terms of
the warranties printed in the Service and
Warranty Information Booklet. Your
authorized Mercedes-Benz Center will ex-
change or repair any defective parts origi-
nally installed in the vehicle in accordance
with the terms of the following warranties:

New Vehicle Limited Warranty


Emission System Warranty


Emission Performance Warranty


California, Maine, Massachusetts,
New York, and Vermont Emission
Control System WarrantyReplacement parts and accessories are
covered by the Mercedes-Benz Parts and
Accessories Warranties, copies of which
are available at any authorized
Mercedes-Benz Center.Loss of Service and Warranty
Information Booklet
Should you lose your Service and Warranty
Information Booklet, have your authorized
Mercedes-Benz Center arrange for a re-
placement. It will be mailed to you.

476 Technical dataIdentification labels1Certification label (on driver’s B-pillar)
The V
ehicle I
dentification N
umber (VIN)
can be found in the following locations:


on the certification label


embossed under a cover in the front
passenger footwell (
page 477)


lower edge of windshield(
page 477)
Example certification label (U.S. vehicles)2VIN
3Paintwork code
Example certification label (Canada
vehicles)2VIN
3Paintwork codei
Data shown on certification label are for il-
lustration purposes only. These data are specific
to each vehicle and may vary from data shown in
the illustration. Refer to certification label on ve-
hicle for actual data specific to your vehicle.

477 Technical data
Identification labels
4Cover
5VIN
6Emission control information label, in-
cludes both federal and California cer-
tification exhaust emission standards
7Vacuum line routing diagram label
8VIN (lower edge of windshield)
9Engine number (engraved on engine)
i
When ordering parts, please specify vehicle
identification and engine number.

478 Technical dataLayout of poly-V-belt driveE 350 4MATIC
1Idler pulley
2Idler pulley
3Automatic belt tensioner
4Power steering pump
5Air conditioning compressor
6Crankshaft
7Coolant pump
8Generator (alternator)
E63AMG
1Idler pulley
2Idler pulley
3Idler pulley
4Automatic belt tensioner
5Power steering pump
6Air conditioning compressor
7Crankshaft
8Coolant pump
9Generator (alternator)

479 Technical data
Engine
Engine
Model
E 350 4MATIC (211.287
1)
1The quoted data apply only to the standard vehicle. See an authorized Mercedes-Benz Center for the corresponding data of all special bodies and special equipment.
E 63 AMG (211.277
1)
Engine
272
156
Mode of operation
4-stroke engine, gasoline injection
4-stroke engine, gasoline injection
No. of cylinders
6
8
Bore
3.66 in (92.90 mm)
4.02 in (102.20 mm)
Stroke
3.39 in (86.00 mm)
3.72 in (94.60 mm)
Total piston displacement
213.5cu in (3498cm
3)
378.8 cu in (6 208 cm
3)
Compression ratio
10.7:1
11.3:1
Output acc. to SAE J 1349
268 hp / 6 000 rpm
2
(200 kW / 6 000 rpm)
2Premium fuel required. Performance may vary with fuel octane rating.
507 hp/6 800 rpm
2
(378 kW/6 800 rpm)
Maximum torque acc. to SAE J 1349
258 lb-ft / 2 400 rpm - 5 000 rpm
(350 Nm / 2 400 rpm - 5 000 rpm)
468 lb-ft/5 200 rpm
(635 Nm/5 200 rpm)
Maximum engine speed
6 500 rpm
7 200 rpm
Firing order
1-4-3-6-2-5
1-5-4-2-6-3-7-8
Poly-V-belt
2 404 mm
2 369 mm