CHEVROLET BLAZER 1997 2.G Service Manual

Downloaded from www.Manualslib.com manuals search engine Center Rear Passenger Position
@-Door Models)
Lap Belt
When you sit in the center rear seating position, you
have a lap safety belt which has a retractor.
1. Pick up the latch plate and pull the belt across you.
Don't let it get twisted.
2. Push the latch plate into the buckle until it clicks.
Pull up on the latch plate to make sure it is secure.
3. Feed the lap belt into the retractor to tighten it.
1-34

Downloaded from www.Manualslib.com manuals search engine 4. Position and release it the same way as the lap part
of a lap-shoulder belt.
If the belt isn’t long enough, see “Safety Belt
Extender” at
the end of this section. Make sure the
release button on the buckle
is positioned so you
would be able to unbuckle the safety belt quickly
if
you ever had to.
Children
Everyone in a vehicle needs protection! That includes
infants and
all children smaller than adult size. In fact,
the law in every state in the United States and
in every
Canadian province
says children up to some age must be
restrained while in a vehicle.
Smaller Children and Babies
I A CAUTION:
Smaller children and babies should always be
restrained in
a child or infant restraint. The
instructions for the restraint will say whether it is
the right type and size for your child.
A very
young child’s hip bones are
so small that a
regular belt might not stay low on the hips, as it
should. Instead, the belt will likely be over the
child’s abdomen. In
a crash, the belt would apply
force right on the child’s abdomen, which could
cause serious or fatal injuries.
So, be sure that
any child small enough for one is always properly
restrained in a child or infant restraint.
1-35

Downloaded from www.Manualslib.com manuals search engine 1 A CAUTION:
Never hold a baby in your arms while riding in a
vehicle. A baby doesn't weigh much -- until a
crash. During a crash a baby will become so
CAUTION: (Continued)
CAUTION: (Continued)
heavy
you can't hold it. For example, in a crash
at only
25 mph (40 km/h), a 12-lb. (5.5 kg) baby
will suddenly become
a 2404b. (110 kg) force on
your arms. The babv would be almost impossible
to hold.
Secure the baby in an infant restraint.
1-36

Downloaded from www.Manualslib.com manuals search engine Child Restraints
Be sure the child restraint is designed to be used in a
vehicle. If it is,
it will have a label saying that it meets
Federal Motor Vehicle Safety Standards.
Then follow the instructions for the restraint. You
may
find these instructions on the restraint itself or in a
booklet, or both. These restraints use
the belt system in
your vehicle, but the child also has to be secured within
the restraint
to help reduce the chance of personal injury.
The instructions that
come with the infant or child
restraint will show you how to do that.
Where to Put the Restraint
Accident statistics show that children are safer if they
are restrained
in the rear rather than the front seat. We at
General Motors therefore recommend that you put your
child restraint in
a rear seat outside position unless the
child is an infant and you’re the only adult in the
vehicle. In that case, you might want to secure the
restraint in the right front seat where you can keep an
eye on
the baby.
Wherever you install it, be sure
to secure the child
restraint properly.
Keep
in mind that an unsecured child restraint can move
around
in a collision or sudden stop and injure people
in the vehicle. Be sure to properly secure any child
restraint in
your vehicle -- even when no child is in it.
1-37

Downloaded from www.Manualslib.com manuals search engine Top Strap
If your child restraint has it top strap, it should be
anchored. Anchor brackets for the rear outside seat
positions
are located on the floor in the cargo area. Don't
use the front
set of tie-down brackets. Anchor the
top strap to the rearmost bracket on the same side of the
vehicle
as the child restraint.
Once
you have the top strap anchored. you'll be ready to
secure the child restraint itself.
1-38

Downloaded from www.Manualslib.com manuals search engine Securing a Child Restraint in a Rear
Outside Seat Position
You’ll be using the lap-shoulder belt. See the earlier part
about the top strap if the child restraint has one.
1.
2.
3.
Put the restraint on the seat. Follow the instructions
for
the child restraint.
Secure the child in the child restraint as the
instructions
say.
Pick up the latch plate, and run the lap and shoulder
portions
of the vehicle’s safety belt through or
around
the restraint. The child restraint instructions
will show you how.
If the shoulder belt goes
in front of the child’s face or
neck, put
it behind the child restraint.
4. Buckle the belt. Make sure the release button is
positioned
so you would be able to unbuckle the
safety belt quickly if you ever had to.
1-39

Downloaded from www.Manualslib.com manuals search engine I
5. Pull the rest of the shoulder belt all the way out of
the retractor to set the lock.
6. To tighten the belt, feed the shoulder belt back into the
retractor while you push down on the chld restraint.
7. Push and pull the child restraint in different
directions to be sure
it is secure.
To remove the child restraint. just unbuckle the vehicle's
safety belt and let
it go back all the way. The safety belt
wilI move freely again and be ready to work for an adult
or larger child passenger.
1-40

Downloaded from www.Manualslib.com manuals search engine Center Seat Positions (4-Door Models)
Don’t use child restraints in these positions. The
restraints won’t work properly.
Securing a Child Restraint in the Right
Front Seat Position
You’ll be using the lap-shoulder belt. See the earlier part
about the top strap if the child restraint has
one.
1.
2.
3.
Put the restraint on the seat. Follow the instructions
for
the child restraint.
Secure
the child in the child restraint as the
instructions say.
Pick up
the latch plate, and run the lap and shoulder
portions of
the vehicle’s safety belt through or
around
the restraint. The child restraint instructions
will show you how.
If the shoulder belt goes in front
of the child’s face or
neck, put it behind the child restraint.
1-41

Downloaded from www.Manualslib.com manuals search engine .."
4. Buckle the belt. Make sure the release button is
positioned so you would be able to unbuckle the
safety belt quickly
if you ever had to.
I
r
5. Pull the rest of the shoulder belt all the way out of
the retractor to set the lock.
1-42

Downloaded from www.Manualslib.com manuals search engine I
6. To tighten the belt, feed the shoulder belt back into the
retractor while
you push down on the child restraint.
7. Push and pull the child restraint in different
directions to be sure
it is secure. If you’re using a
bucket seat, adjust the seat forward until the lap
portion of the safety belt holds the restraint firmly.
But don’t move
it any more than needed to tighten
the
lap belt.
To remove the child restraint, just unbuckle the vehicle’s
safety belt and let
it go back all the way. The safety belt
will move freely again and be ready
to work for an adult
or larger child passenger.