buttons CHEVROLET MONTE CARLO 2004 Owner's Manual
[x] Cancel search | Manufacturer: CHEVROLET, Model Year: 2004, Model line: MONTE CARLO, Model: CHEVROLET MONTE CARLO 2004Pages: 416, PDF Size: 4.56 MB
Page 279 of 416

After changing the engine oil, the system must be reset.
To reset the CHANGE ENGINE OIL message use
one of the following procedures:
Using the Radio
1. Turn the ignition to ACC or ON, with the radio off.
2. Press and hold the TUNE DISP knob on the
radio for at least ve seconds until SETTINGS
is displayed.
3. Press the SEEK PSCAN up or down arrow to scroll
through the main menu.
4. Scroll until OIL LIFE appears on the display.
5. Press the 1 PREV or 2 NEXT buttons to enter the
submenu. RESET will be displayed.
6. Press the TUNE DISP knob to reset. A chime will
be heard to verify the new setting and DONE will
be displayed for one second.
7. Once the indicator has been reset, scroll until
EXIT appears on the display.8. Press the TUNE DISP knob to exit programming.
A chime will be heard to verify the exit.
9. Turn the key to OFF.
If the CHANGE ENGINE OIL message comes back on
when you start your vehicle, the engine oil life system
has not reset. Repeat the procedure.
Using the Accelerator Pedal
1. Turn the ignition to ON, with the engine off.
2. Fully press and release the accelerator pedal slowly
three times within ve seconds. If the CHANGE
ENGINE OIL message ashes, the system is reset.
However, if it stays on, it did not reset. Repeat
the procedure.
3. Turn the key to OFF.
If the CHANGE ENGINE OIL message comes back on
when you start your vehicle, the engine oil life system
has not reset. Repeat the procedure.
5-23
Page 405 of 416

Driving Through Deep Standing Water...............4-20
Driving Through Flowing Water.........................4-20
Driving with a Trailer.......................................4-42
Dual Climate Control System............................3-21
E
Easy Entry Seat............................................... 1-7
Electrical System
Add-On Equipment.....................................5-103
Fuses and Circuit Breakers.........................5-104
Headlamp Wiring.......................................5-103
Power Windows and Other Power Options....5-103
Windshield Wiper Fuses.............................5-103
Emergency Trunk Release Handle.....................2-12
Emissions Inspection and
Maintenance Programs.................................3-41
Engine
Air Cleaner/Filter.........................................5-26
Battery.......................................................5-53
Change Oil Message...................................3-47
Check and Service Engine Soon Light............3-39
Coolant......................................................5-31
Coolant Heater............................................2-20
Coolant Temperature Gage...........................3-38
Drive Belt Routing.......................................6-14
Engine Compartment Overview......................5-12Engine (cont.)
Exhaust.....................................................2-29
Low Oil Level Message................................3-46
Oil .............................................................5-18
Overheating................................................5-34
Starting......................................................2-18
Supercharger Oil.........................................5-24
Engine Cooling When Trailer Towing..................4-45
Engine Oil Additives........................................5-22
Entry Lighting.................................................3-17
Erasing HomeLink
®Buttons..............................2-39
Event Data Records (EDR)..............................7-10
EXIT (Exit Feature
Customization Mode)....................................2-50
Express-Down Window....................................2-14
Extender, Safety Belt.......................................1-28
Exterior Lamps...............................................3-14
F
Filter
Engine Air Cleaner......................................5-26
Finding a Program Type (PTY)
Station (RDS and XM™)..............3-60, 3-71, 3-82
Finding a Station............................3-58, 3-69, 3-80
Finish Care....................................................5-98
Finish Damage...............................................5-99
5