lock DODGE SPRINTER 2008 2.G Owners Manual

284 Controls in detailTransporting
3
Mounting lashing points for load
rails*1Locking mechanism\1To install:
slide the lashing eye
through a recess in the load rail close
to the load until locking mechanism
1
in the recess engages.
iWhen you pull locking
mechanism
1
out of the recess, the
lashing eye is able to move within the
lashing rail or load rail. Make sure
that locking mechanism
1
is always
engaged in a recess.
Warning
G
If the lashing eye is not firmly anchored in
the load rail, the lashing eye may slip or
snap out of the load rail in the event of
sudden braking or an accident.
The load would no longer be secured,
which could result in serious injuries
caused by the load slipping.
For this reason, always check that the
lashing eye is firmly in place whenever
you install it.
nf_BA.book Page 284 Friday, January 25, 2008 3:53 PM

285 Controls in detail
Transporting
3
\1
Check whether the lashing eye is
firmly in place.
\1To remove:
pull locking mechanism
1
upward and pull the lashing eye
through a recess towards the locking
mechanism and out of the load rail.
It is possible to mount a roof rack if your
vehicle is equipped with securing rails
on the roof.
1Securing railsSpecial mountings (sliding blocks) are
available as accessories. These are
available from any authorized Sprinter
Dealer.
Carrier systems
Warning
G
Handling and braking characteristics may
change when you have mounted carrier
systems on the vehicle. You could endan-
ger yourself and others.Observe the manufacturer’s installation
instructions. An incorrectly secured carri-
er system or load could:\4come loose\4fall offand thereby endanger yourself and
others.
Continued
nf_BA.book Page 285 Friday, January 25, 2008 3:53 PM

286 Controls in detailTransporting
3
Only install roof racks that have been
approved or recommended for Sprinter
vehicles. These are available in any au-
thorized Sprinter Dealer.Observe the instructions in the “Opera-
tion” section (
\2
page 303).
Warning (Continued)
G
Observe the maximum roof loads
(\2page 630), the maximum axle load
and the maximum load-bearing capacity
of the roof rack.!
CAUTION
Make sure that:
the securing bolts for the roof
rack are tightened to a torque of
6.0 – 7.4 lb-ft (8 – 10 Nm) in the slid-
ing blocks provided
the bolts do not make contact with
the rails when tightened
the sliding blocks are not positioned
near the plastic caps
the sliding blocks have the correct
cross-section
the securing rails are free of dirt on
the inside
the securing bolts are retightened
evenly after approximately 300 miles
(500 km)
This will help to avoid damage to the
vehicle.
!
CAUTION
If you wish to retrofit securing rails,
have them installed at a qualified
specialist workshop which has the
necessary specialist knowledge and
tools to carry out the work required.
You could otherwise damage the ve-
hicle.
The manufacturer recommends that
you use an authorized Sprinter Deal-
er for this purpose.
Trailer towing
nf_BA.book Page 286 Friday, January 25, 2008 3:53 PM

288 Controls in detailFeatures
3
Storage compartments in the doorsYou can use these storage compart-
ments for the safe storage of small and
light items.Storage compartment under the twin
passenger's seat*On vehicles with a twin passenger’s
seat, the storage compartment is under
the seat cushion (
\2
page 119).
You can use the storage compartment
for the safekeeping of tools and other
small items.
Glove box1Glove box handle
2Locked*
3Unlocked*
!
CAUTION
The entire storage compartment is
permitted to hold a maximum load of
66 lbs (30 kg).
Do not store high, bulky loads in the
storage compartment. You could oth-
erwise damage the roof trim in the
event of sudden braking.
iYou can lock and unlock the glove
box using the key*.
nf_BA.book Page 288 Friday, January 25, 2008 3:53 PM

298 Controls in detailFeatures
3
Telephones may only be used inside the
vehicle if they are connected to a sepa-
rate exterior antenna of a type tested
and approved by the manufacturer.
iThe sockets are supplied with power
even if the key is removed from the
ignition lock. Please note that the
battery may be discharged if you
have connected an accessory, e.g. a
coolbox, and the engine is switched
off.Telephone*
Warning
G
You must observe the legal requirements
for the country in which you are driving
when operating a cell phone in the vehi-
cle.If it is permitted to operate a cell phone
while the vehicle is in motion, you must
only operate it when road and traffic con-
ditions permit. You may otherwise be dis-
tracted from the traffic conditions, cause
an accident and injure yourself and oth-
ers.
Continued
Warning (Continued)
G
Cell phones without exterior antennas
may interfere with the vehicle electronics
and thereby jeopardize the operational
safety of the vehicle. You must therefore
only use these devices when they are con-
nected to a separate exterior antenna.
nf_BA.book Page 298 Friday, January 25, 2008 3:53 PM

299 Controls in detail
Features
3
The installation of the antenna must be
approved by a qualified specialist work-
shop.
Always have maintenance work carried
out at a qualified specialist workshop,
e.g. an authorized Sprinter Dealer.
Warning
G
Only use the telephone when road, weath-
er and traffic conditions permit you to do
so. You will otherwise be too distracted. If
you are not using the hands-free system,
pull over to make a phone call.
Bear in mind that at a speed of just
30 mph (approx. 50 km/h), your vehicle
is covering a distance of 44 feet (approx.
14 m) every second.
Telephones without exterior antennas
may interfere with the vehicle electronics
and thereby jeopardize the operational
safety of the vehicle.
iObserve all legal requirements.iThe cell phone battery will be
charged depending on the charge
status and the position of the key in
the ignition lock. The cell phone dis-
play indicates the charging process.
nf_BA.book Page 299 Friday, January 25, 2008 3:53 PM

308 OperationDriving tips
4
Attaching a trailerPlease observe the maximum permitted
trailer dimensions (width and length).
Most states and all Canadian provinces
require safety chains between your tow
vehicle and the trailer. The chains should
be crisscrossed under the trailer tongue.
They must be attached to the hitch re-
ceiver, and not to the vehicle’s bumper
or axle. Be sure to leave enough slack in
the chains to permit turning corners.
iMost states and all Canadian prov-
inces require a separate brake sys-
tem at various trailer weights.
Warning
G
Do not connect a trailer brake system (if
trailer is so equipped) directly to the vehi-
cle’s hydraulic brake system as your vehi-
cle is equipped with antilock brakes. If
you do, neither the vehicle’s brakes nor
the trailer’s brakes will function properly.
This could cause an accident resulting in
property damage, injury or death to you or
others.The provided vehicle electrical wiring har-
ness for trailer towing has a brake signal
wire for hook-up to a brake controller.
Continued
Warning (Continued)
G
Most states and all Canadian provinces
require a break-away switch on trailers
with a separate brake system. The switch
activates the trailer brakes in the possible
event that the trailer might separate from
the tow vehicle.You should consider using a trailer sway
control system. For further information,
see your authorized Sprinter Dealer.
nf_BA.book Page 308 Friday, January 25, 2008 3:53 PM

317 Operation
Refueling
4
\1
Remove the key from the ignition
lock.
\1
Switch off the auxiliary heating.
\1
Open the driver’s door.
\1
Open the fuel filler flap.
\1
Close all the vehicle’s doors, so that
no fuel vapors can enter the vehicle.
\1
Turn fuel filler cap
2
counterclock-
wise and let it hang by retaining
strap
1
.
\1
Only fill the tank until the pump noz-
zle switches off.
\1
Replace fuel filler cap
2
and turn it
clockwise.A clicking sound indicates that the
fuel filler cap is fully closed.
\1
Open the driver’s door and close the
fuel filler flap.
You will find information about fuel in
the “Technical data” section
(
\2
page 610).
nf_BA.book Page 317 Friday, January 25, 2008 3:53 PM

320 OperationEngine compartment
4
Closing
Warning
G
Engine parts may be hot and can rotate.
There is a risk of injury if the hood is open
and the engine is running.
Only open the hood when the engine has
stopped and cooled down.
Warning
G
The engine has an electronic ignition sys-
tem which carries a high voltage. For this
reason, you must never touch the ignition
system components (ignition coil, test
socket) while:
\4the engine is running
\4the engine is being started
\4the key is in position2 in the ignition
lock and the engine is being cranked
by hand
Warning
G
Make sure that nobody can become
trapped as you close the hood.
nf_BA.book Page 320 Friday, January 25, 2008 3:53 PM

330 OperationEngine compartment
4
\1
Slowly unscrew cap
1
counter-
clockwise to reduce excess pres-
sure.
\1
Continue turning the cap and remove
it.
\1
Add coolant as far as the MAX mark.
\1
Twist cap
1
back on.
For coolant specifications, see "Service
products and capacities" (
\2
page 604).
Warning
G
When opening the coolant expansion tank
there is a risk of scalding from hot coolant
spraying out. The cooling system and the
coolant expansion tank are pressurized
when the engine is at normal operating
temperature.
Wear gloves and eye protection. Only
open the coolant expansion tank when
the coolant temperature is less than
122 °F (50 °C).
Warning
G
Coolant contains glycol and is therefore
toxic. Do not swallow coolant. Consult a
doctor immediately if any coolant is swal-
lowed.
Do not allow coolant to come into contact
with your skin, eyes or clothing. In the
event of contact with the eyes, rinse them
thoroughly with clean water. Clean skin
and clothes immediately with soap and
water. Change out of soiled clothing with-
out delay.
!
CAUTION
Check the cooling and heating sys-
tems regularly for leaks. If a large
quantity of coolant is lost, have the
cause traced and rectified at an au-
thorized Sprinter Dealer.
nf_BA.book Page 330 Friday, January 25, 2008 3:53 PM