lock DODGE SPRINTER 2008 2.G Owners Manual

339 Operation
Battery isolating switch*
4
\1
Take the key out of the ignition lock
and wait for approximately
20 seconds.
\1
Move red slide
2
down in the direc-
tion of the arrow and disconnect
connector
1
from the ground pin.
\1
Clamp connector
1
under the ac-
celerator pedal so that it cannot
make contact with the ground pin.
The consumers of the vehicle battery
are cut off from the electrical circuit.
!
CAUTION
Make sure that the key is in
position
0 in the ignition lock and
wait at least 20 seconds before dis-
connecting or connecting the battery
isolating switch. You could otherwise
damage electrical system compo-
nents.
Switching off the electrical system
!
CAUTION
When you clamp the connector under
the accelerator pedal, make sure that
the connector does not become:
\4
dirty
\4
damaged
It may otherwise not be possible to
restore the electrical connection
when the parts are reassembled.
nf_BA.book Page 339 Friday, January 25, 2008 3:53 PM

340 OperationBattery isolating switch*
4
1Connector
2Ground pin
\1
Insert the key into the ignition lock.
\1
Press connector
1
onto ground pin
2
until you feel it engage.
The connector must be in full contact
with ground pin
2
.
All consumers are reconnected to
the power supply circuit.
Switching on the electrical system
nf_BA.book Page 340 Friday, January 25, 2008 3:53 PM

347 Operation
Tires and wheels
4
The tire inflation pressure should be
checked regularly, i.e. at least each time
you refuel the vehicle. The preferred in-
terval for checking the tire inflation pres-
sure, however, is before each trip.
For more information on checking tire
inflation pressure, refer to "Recom-
mended tire inflation pressure"
(\2
page 361).
Tire inspectionEvery time when checking the tire infla-
tion pressure, the tires should also be in-
spected for the following:\4
excessive treadwear, refer to "Tread
depth".
\4
the condition of the tread depths, i.e.
uneven tread wear or excessive
treadwear on one side. Turn the front
wheels to full lock if necessary to en-
able you to check the inner edge of
the front tires more easily. You must
also always check the inside of the
tire tread on the rear wheels.
\4
cord or fabric showing through the
tire’s rubber
Tire care and maintenanceWarning
G
Regularly check the tires for damage.
Damaged tires can cause tire inflation
pressure loss. As a result, you could lose
control of your vehicle.
Worn, old tires can cause accidents. If the
tire tread is badly worn, or if the tires have
sustained damage, replace them.
nf_BA.book Page 347 Friday, January 25, 2008 3:53 PM

421 Operation
Cleaning and care of the vehicle
4
Outside of windshield and wiper
blades
\1
Turn key to position
1 in ignition lock
(
\2
page 111).
\1
Switch on windshield wipers
(\2
page 210).
\1
When the wiper arms are vertical,
turn key to position
0 in the ignition
lock or remove the key.
\1
Fold the wiper arms away from the
windshield until you feel them en-
gage in place.
\1
You can now clean the windshield
and the wiper blades.
\1
Fold the windshield wipers back
again before you switch on the igni-
tion.
Windows
!
CAUTION
Do not fold the windshield wipers
away from the windshield unless the
hood is closed. You will otherwise
damage the hood.
Warning
G
Switch off the ignition before cleaning the
windshield or the wiper blades. The wind-
shield wipers could otherwise move and
injure you.
!
CAUTION
Do not use a dry cloth, abrasive ma-
terial, solvent or solvent-based clean-
ing agent to clean the inside of the
windows. Clean the inside of the win-
dows with a damp cloth or a commer-
cially available glass cleaner. Do not
touch the inside of the rear and side
windows with hard objects, such as
an ice scraper or a ring. You could
otherwise damage the windows or
the rear window heating.
nf_BA.book Page 421 Friday, January 25, 2008 3:53 PM

431 Practical hints
What to do if ...
5
Problem
Possible cause / result
Suggested solutions
The anti-theft alarm system is suddenly trig-
gered.
You have opened the vehicle using the key
while the anti-theft alarm system was still
primed.
Key:
\1Press theΠbutton.
or
\1Insert the key into the ignition lock.
The anti-theft alarm system is deacti-
vated.
You hear a warning signal.
A message appears in the display.
\1Observe the instructions on
(\2page 484).
You are driving with the handbrake applied.
\1Release the handbrake (\2page 191).
You opened the driver’s door and forgot to
switch off the lights.
\1Turn the light switch to0.
Warning
G
You are not wearing your seat belt.
\1Fasten your seat belt .
nf_BA.book Page 431 Friday, January 25, 2008 3:53 PM

437 Practical hints
What to do if ...
5
Problem
Possible cause / result
Suggested solutions
The engine does not start.
You can hear the starter motor working.
There may be a malfunction in the fuel supply.
\1
Turn the key back to position
0 in the igni-
tion lock before the next starting attempt.
\1Start the engine again.
Note that excessively long attempts to
start the engine may drain the battery.
If the engine still will not start after several
starting attempts:
\1Consult an authorized Sprinter Dealer.
Vehicles with a diesel engine:
The engine does not start.
You can hear the starter motor working. The
reserve fuel warning lamp is lit and the fuel
gauge is at 0.
The fuel tank has been run dry.
\1Refuel the vehicle.
\1Bleed the fuel system (\2page 544).
nf_BA.book Page 437 Friday, January 25, 2008 3:53 PM

444 Practical hintsWhat to do if ...
5
Problem
Possible cause / result
Suggested solutions
The windshield wipers are jammed.
Leaves or snow, for example, are hindering the
movement of the windshield wipers.
The wiper motor has switched off.
\1Stop the vehicle as soon as possible
and, for safety reasons, remove the key
from the ignition lock.
\1Remove the cause of the obstruction.
\1Switch on the windshield wipers again.
The windshield wipers have stopped working
completely.
The windshield wiper drive has malfunctioned.
\1Select a different wiper speed on the
combination switch.
\1Have the windshield wipers checked at
an authorized Sprinter Dealer.
nf_BA.book Page 444 Friday, January 25, 2008 3:53 PM

446 Practical hintsWhat to do if ...
5
Problem
Possible cause / result
Suggested solutions
It is no longer possible to lock the vehicle us-
ing the remote control.
The turn signals do not flash when the vehicle
is locked.
The doors are not closed properly.
\1Close the doors properly and lock the
vehicle again.
The central locking system has malfunctioned.
\1Lock the vehicle using the key
(\2page 88).
\1Have the central locking system
checked as soon as possible at an au-
thorized Sprinter Dealer.
nf_BA.book Page 446 Friday, January 25, 2008 3:53 PM

447 Practical hints
What to do if ...
5
It is no longer possible to lock or unlock the
vehicle using the remote control.
The remote control batteries are weak or dis-
charged.
\1Point the remote control towards the
driver’s door handle at close range and
try again.
If this does not work:
\1Lock or unlock the vehicle using the key
(\2page 88).
\1Check the batteries of the remote
control (\2page 86). Change the
batteries if necessary (\2page 540).
The remote control is malfunctioning.
\1Lock or unlock the vehicle using the key
(\2page 88).
\1Have the remote control checked at an
authorized Sprinter Dealer.
Problem
Possible cause / result
Suggested solutions
nf_BA.book Page 447 Friday, January 25, 2008 3:53 PM

449 Practical hints
What to do if ...
5
The key can no longer be turned in the ignition
lock.
The on-board voltage is too low.
\1Remove the key and re-insert it into the
ignition lock.
\1Switch off all non-essential consumers,
for example the seat heating, interior
lighting, and try to turn the key again.
If this does not work:
\1Check the starter battery and charge it
if necessary.
or
\1The engine may be jump-started
(\2page 581).
or
\1Consult an authorized Sprinter
Dealer.
Problem
Possible cause / result
Suggested solutions
nf_BA.book Page 449 Friday, January 25, 2008 3:53 PM