FIAT 500 2018 Owner handbook (in English)

99
MOPAR®CONNECT
(where provided)
These services let you keep your
vehicle under control at all times and
receive assistance in the event of
accident, theft or breakdown.
To have these services, install the
Mopar
®Connect Device on your
vehicle from the country (list available
on the www.driveuconnect.eu website)
and request activation by following the
instructions received at the email
address given when you picked up the
vehicle.
To use the connected services, you
must download the Uconnect™ LIVE
App or access the
www.driveuconnect.eu portal.
You can find all the details about the
services in the Mopar
®Connect
section of the www.driveuconnect.eu
portal.
PRIVACY MODE
Privacy mode lets you disable the
“Find car”, “Notify Area” and “Notify
Speed” services, which allow
registered customers to locate their
cars, for a fixed time.
IMPORTANT NOTE Vehicle position
tracing remains active for the
assistance services, where provided,
in the event of accident or vehicle
theft, but is not visible to the customer.
PRIVACY MODE
activation procedure
Proceed as follows:
❒ note down the current total mileage
(in km);
❒ make sure that the instrument
panel is off;
❒ Send the following text message to
+393424112613: “PRIVACY

”
(e.g.: PRIVACY
ZFA3340000P123456 12532).You can find the chassis number in the
registration document;
❒ before starting the engine, wait to
receive the text message
confirming that Privacy mode has
been activated and indicating when
it expires.
When you have received the
confirmation, you can start your trip in
the knowledge that the vehicle will not
be traced until the indicated expiry
time.
If it expires while you are still travelling,
Privacy mode will be extended until
you turn off the engine (instrument
panel off).
If you receive a text message
indicating that your request was not
successful, you must be aware that
the vehicle will continue to be visible to
the registered customer.
If you have any doubts or problems
during activation, consult the FAQ on
the www.driveuconnect.eu portal,
contact the Fiat Dealership or contact
Customer Care.

Blank page

101
OCCUPANT
PROTECTION
SYSTEMS
Some of the most important safety
equipment of the vehicle comprise the
following protection systems:
❒ seat belts;
❒ SBR (Seat Belt Reminder) system;
❒ head restraints;
❒ child restraint systems;
❒ front airbags and side bags.
Read the information given the
following pages with the utmost care. It
is of fundamental importance that the
protection systems are used in the
correct way to guarantee the maximum
possible safety level for the driver and
the passengers.
For the description of the head restraint
adjustment see the “Head restraints”
paragraph in the
“Knowing your vehicle”
chapter.
SEAT BELTS AND
PRETENSIONERS
22) 12)
SEAT BELTS
All vehicle seats are equipped with seat
belts with three anchor points and a
retractor.
The retractor mechanism operates
locking the belt in the event of sharp
braking or strong deceleration due to
an impact.
This allows the belt strap to slide freely
and to adapt to the body of the
occupant. In the event of an accident,
the belt will lock reducing the risk of
impact inside the passenger
compartment and of being projected
outside the vehicle.
The driver is responsible for respecting,
and ensuring that all the other
occupants of the vehicle also respect,
the local laws in force in relation to the
use of the seat belts.
Always fasten the seat belts before
setting off.
Using the seat belts
The belt should be worn keeping the
torso straight and rested against the
backrest.
To fasten the seat belts, hold tongue A
fig. 60 and insert it into buckle B until it
locks into place.
On removal, if the belt jams, let it
rewind for a short stretch, then pull it
out again without jerking.
SAFETY

SAFETY
102
Press button C fig. 67 to release the
belt.
Guide the belt while it is rewinding to
prevent it from twisting.
The retractor may lock when the
vehicle is parked on a steep slope: this
is perfectly normal.
Furthermore, the reel mechanism locks
the belt if it is pulled sharply or in the
event of sudden braking, collisions and
high-speed bends.
The rear seat is fitted with inertia seat
belts with three anchor points and a
retractor.
NOTE Wear the rear seat belts as
shown in fig. 68.
67DVDF0S041c
IMPORTANT When putting the seats
back to their normal position, make
sure the seat belts are positioned so
they are ready to use.
SBR SYSTEM
(for versions/markets, where provided)
The SBR system warns the
passengers of the front and rear (for
versions/markets, where provided)
seats if their seat belt is not fastened.
The system signals unfastened seat
belts with visual warnings (warning
lights on in the instrument panel and
icons on the display) and an acoustic
signal (see the following paragraphs).
NOTE Contact a Fiat Dealership to
deactivate this acoustic warning
permanently. The acoustic warning can
be reactivated at any time through the
display Setup Menu.
68DVDF0S0056c
Seat belts warning
light operation
The system warns the driver and the
front passenger if their seat belt is not
fastened, as follows:
❒ flashing
intermittent acoustic warning for
about 100 seconds.
❒ once the cycle has finished, the
warning light remains on constantly
until the seat belts are fastened.
PRE-TENSIONERS
The car is equipped with front seat belt
pretensioners, which in the event of a
major frontal impact guarantee the
perfect adherence of the seat belts to
the occupant’s bodies before the
retention action begins.

103
This car is also equipped with a
second pretensioner (fitted in the kick
plate area). Its activation is signalled by
the shortening of the metal cable.
A slight discharge of smoke may be
produced during the activation of the
pretensioner which is not harmful and
does not involve any fire hazard.
The pretensioner does not require any
maintenance or lubrication: any
changes to its original conditions will
invalidate its efficiency.
If, due to unusual natural events
(floods, sea storms, etc.), the device
has been affected by water and mud, it
must be replaced.
IMPORTANT To obtain the highest
degree of protection from the action of
the pretensioner, wear the seat belt
tight to the chest and pelvis.LOAD LIMITERS
To increase occupant safety, the seat
belt retractors contain a load limiter to
dose the force acting on the chest and
shoulders during the belt restraining
action in the case of frontal collisions.
GENERAL WARNINGS
FOR USING THE SEAT
BELTS
Seat belts are also to be worn by
pregnant women: the risk of injury in
the case of impact is greatly reduced
for them and the unborn child if they
are wearing a seat belt.
Pregnant women must position the
lower part of the belt very low down so
that it passes over the pelvis and under
the abdomen (see fig. 69). While pregnancy increases, the driver
must adjust both seat and steering
wheel to have full control over the
vehicle (pedals and steering wheel
should be easily accessed).
The maximum clearance should be
kept between the abdomen and the
steering wheel.
The belt must not be twisted.
The upper part must pass over the
shoulder and cross the chest
diagonally. The lower part must adhere
to the hips not to the abdomen.
Never use devices (clips, clamps, etc.)
that hold the seat belt away from your
body fig. 70.
69DVDF0S042c

SAFETY
104
SEAT BELTS
MAINTENANCE
For keeping the seat belts in efficient
conditions, carefully observe the
following warnings:
❒ always use the seat belt with the
strap well stretched and not twisted;
make sure that it is free to run
without obstructions;
❒ check seat belt operation as
follows: attach the seat belt and pull
it hard;
❒ replace the seat belt after an
accident of a certain severity even if
it does not appear to be damaged.
Always replace the seat belt if the
pretensioners were deployed;
❒ prevent the retractors from getting
wet: their correct operation is only
guaranteed if water does not get
inside;
❒ replace the seat belt when showing
significant wear or cut signs. Each seat belt must be used by only
one person. Never travel with a child
sitting on the passenger’s lap and a
single belt to protect them both.
In general, do not place any objects
between the person and the belt
fig. 71.
70DVDF0S043c
71DVDF0S044c
CHILD PROTECTION
SYSTEMS
CARRYING CHILDREN
SAFELY
23), 24 12)
For optimal protection in the event of
an impact, all occupants must be
seated and wearing adequate restraint
systems, including newborn and other
children.
This prescription is compulsory in all
EC countries according to EC Directive
2003/20/EC.
Children below the height of 1.50
metres and up to 12 years must be
protected with suitable restraint
systems and be seated on the rear
seats.
Statistics on accidents indicate that the
rear seats offer greater safety for
children.
Compared with an adult, a child’s head
is larger and heavier in proportion to
their body and the child’s muscular and
bone structures are not fully developed.

105
Therefore, correct restraint systems
other than adult seat belts are
necessary to reduce as much as
possible the risk of injuries in the event
of an accident, braking or a sudden
manoeuvre. Children must be seated
safely and comfortably. Depending on
the characteristics of the child restraint
systems used, you are advised to keep
children in rearward facing child
restraint systems for as long as
possible (at least until 3-4 years old),
since this is the most protected
position in the event of an impact.
The choice of the most suitable child
restraint device depends on the weight
of the child; there are various types of
child restraint systems and you are
advised always to choose the one that
is most suitable for the child.
It is recommended to always choose
the restraint system most suitable for
the child; for this reason always refer to
the Owner Handbook provided with
the child restraint system, to be sure
that it is of the right type for the
children it is intended for.In Europe the characteristics of child
restraint systems are ruled by the
regulation ECE-R44, dividing them into
five weight groups:
Group 0 up to 10 kg in weight
Group 0+ up to 13 kg in weight
Group 1 9-18 kg
Group 2 15-25 kg
Group 3 22-36 kg
All child restraint devices must bear the
certification data, together with the
control mark, on a label solidly fixed to
the seat which must never be removed.
Lineaccessori Mopar
®includes child
restraint systems for each weight
group.
These devices are recommended
having been specifically designed for
Fiat cars.
FITTING A CHILD
RESTRAINT SYSTEM
WITH SEAT BELTS
The Universal child restraint systems
installed with the seat belts only are
type-approved on the basis of the
ECE R44 standard and are divided into
various weight groups.
WARNING The figures are indicative
and provided for assembly purposes
only.
Fit the child restraint system according
to the instructions, which must be
included.
IMPORTANT Following an accident of
a medium-to-high severity, it is
recommended to replace both the child
restraint system and the seat belt to
which it was bound.
Group 0 and 0+
Babies up to 13 kg must be carried
rearward facing on a cradle restraint
system, which, supporting the head,
does not induce stress on the neck in
the event of sharp decelerations.

SAFETY
106
The child restraint system must be
withheld using the car seat belts and
restrain the baby using the belts fitted in
the child restraint system.
Group 1
Children weighing from 9 to 18 kg may
be transported in forward facing child
restraint systems.
72DVDF0S045c
73
9-18 kg
DVDF0S046c
Group 2
Children from 15 to 25 kg may use the
vehicle seat belts directly.
In this case, the child restraint system
is used to position the child correctly
with respect to the seat belts so that
the diagonal belt section crosses the
child’s chest and not the neck, and
the lower part is snug on the pelvis not
the abdomen.
74DVDF0S047c
Group 3
For children between 22 kg and 36 kg,
there are boosters which allow the seat
belt to be worn correctly.
Fig. 75 shows proper child seat
positioning on the rear seat.
Children over 1.50 m in height can
wear seat belts like adults.
75DVDF0S048c

107
PASSENGER SEAT COMPLIANCE WITH
REGULATIONS ON UNIVERSAL CHILD SEAT USE
Fiat 500 complies with the new European Directive 2000/3/EC which governs the
arrangement possibilities for child restraints on the various seats of the car as
shown in the following table:
GroupWeight
groupFront passenger ()
Airbag onAirbag offRear passenger
Group 0, 0+ up to 13 kg X U U
Group 1 9-18 kg X U U
Group 2 15-25 kg U U U
Group 3 22-36 kg U U U
U = suitable for child restraint systems of the “Universal” category, according to European
Standard EEC-R44 for the specified Groups”.
X = restraint system not suitable for children in this weight category.
(
) IMPORTANT: NEVER fit rearward facing child restraint systems on the front seat
with an active passenger side airbag. Deactivate the respective airbag to install a rearward facing
child restraint system
(see instructions in the “Supplementary Restraint System
(SRS) - Airbag” paragraph).
INSTALLING AN
ISOFIX CHILD
RESTRAINT SYSTEM
24)
The vehicle is equipped with ISOFIX
anchorages, a new standard which
makes fitting a child restraint system
quick, simple and safe.
The ISOFIX system lets you install the
ISOFIX child restraining system without
using the car seat belts but connecting
them directly to the carseat with three
anchors in the car.
Traditional child restraint systems can
be fitted alongside ISOFIX child restraint
systems on different seats in the same
vehicle.

SAFETY
108
To install an ISOFIX child restraint
system, attach it to the two metal
anchor points A fig. 76, located behind
the rear seat cushion,where the rear
seat cushion meets the backrest and
highlighted by the symbol.
Then remove the parcel shelf and fix
the upper strap (available together with
the child restraint system) to the anchor
point B fig. 77, located behind the
backrest, at the bottom.
77DVDF0S051c
76DVDF0S227c
78DVDF0S049c
An example of an Universal Isofix child
seat for weight group 1 is shown in
fig. 78.The other weight groups are covered
by the specific Isofix child restraint
system, which can be used only if
specifically designed, tested and
approved for this car (see car list
provided with the child seat).
WARNING The figure is indicative and
for assembly purposes only.
Fit the child restraint system
according to the instructions, which
must be included.
NOTE When a Universal ISOFIX child
restraint system is used, only ECE
R44 “ISOFIX Universal” (R44/03 or
further upgrades) type-approved child
restraint systems can be used.
The Universal Isofix “Duo Plus” child
restraint system and the special “G
0/1” restraint system are available from
Lineaccessori Mopar
®.
For any further details on
installation/use, refer to the
instruction manual provided with the
child seat.