HONDA ODYSSEY 2020 Owner's Manual (in English)
Manufacturer: HONDA, Model Year: 2020, Model line: ODYSSEY, Model: HONDA ODYSSEY 2020Pages: 767, PDF Size: 43.89 MB
Page 111 of 767

109
uuIndicators uDriver Information Interface Wa rning and Information Messages
Continued
Instrument Panel
MessageConditionExplanation
•Appears when you try to ch ange the gear position 
without releasing your foot  off the accelerator pedal.•Release your foot off the accelerator pedal, then select 
a shift button.
•Appears when the (P button is pressed while the 
vehicle is moving.
• Appears if you change the gear position to 
(R while 
the vehicle is moving forward, or to 
(D while the 
vehicle is reversing.
• Make sure that the vehicle comes to a stop before 
operating the select button.
•Appears when you set the power mode to ON 
without fastening the driver’s seat belt.
• Appears when you change the gear position after 
(P has been automatically se lected with the driver’s 
door open, the driver’s seat  belt unfastened, then 
the brake pedal is released.
• Fasten the seat belt properly before you start to drive.
2 Shift Operation  P. 552
•Appears when depressing the accelerator pedal 
while the gear position is in 
(N.
•Remove your foot from the accelerator pedal. When 
driving, depress the brake pedal and change the gear 
position.
20 US ODYSSEY-31THR6210.book  109 ページ  2020年2月28日 金曜日 午前7時26分 
Page 112 of 767

110
uuIndicators uDriver Information Interface Wa rning and Information Messages
Instrument Panel
MessageConditionExplanation
•Appears when you press and hold (N button for 
more than two seconds.• Disappears when you set the  gear position to other 
than 
(N.
2 If you want to keep the transmission in (N 
position [car wash mode]  P. 554
•Appears if there is a problem with the cooling 
system.•Drive slowly to prevent ov erheating and have your 
vehicle checked by a deal er as soon as possible.
•Appears if there is a problem with the headlights.
•Appears while driving  - The headlights may not be 
on. When conditions allow you to drive safety, have 
your vehicle checked by a d ealer as soon as possible.
•Appears if there is a proble m with the parking sensor 
system.
• Check if the area around the  sensor(s) is covered with 
mud, ice, snow, etc. If the indicator(s) stays on or the 
beeper does not stop even  after you clean the area, 
have the system checked by a dealer.
• Appears if there are obstacles around the sensors.
•Check for obstacles near your vehicle to make sure it is 
safe to park.
Models with LED headlights
Models with parking sensor system
Models with parking sensor system
20 US ODYSSEY-31THR6210.book  110 ページ  2020年2月28日 金曜日 午前7時26分 
Page 113 of 767

111
uuIndicators uDriver Information Interface Wa rning and Information Messages
Continued
Instrument Panel
MessageConditionExplanation
•Appears if the automatic brake hold is automatically 
canceled while it is in operation.•Immediately depress the brake pedal.
•Appears when the automati c brake hold system is 
turned off.
2 Automatic Brake Hold P. 611
•Appears when the automati c brake hold button is 
pressed without wearing the driver’s seat belt.• Fasten the driver’s seat belt.
2 Automatic Brake Hold P. 611
•Appears when the automati c brake hold button is 
pressed without depressing the brake pedal while 
the automatic brake hold is in operation.• Press the automatic brake  hold button with the brake 
pedal depressed.
2 Automatic Brake Hold P. 611
•Appears when the park ing brake is applied 
automatically while it is in operation.2 Automatic Brake Hold P. 611
2 Parking Brake P. 607
20 US ODYSSEY-31THR6210.book  111 ページ  2020年2月28日 金曜日 午前7時26分 
Page 114 of 767

112
uuIndicators uDriver Information Interface Wa rning and Information Messages
Instrument Panel
MessageConditionExplanation
•Appears when you pull the electric parking brake 
switch without depressing the brake pedal.•Depress the brake pedal to release the parking brake.
2 Parking Brake  P. 607
•Appears as soon as a prob lem is detected in the 
smart entry system.
• Appears constantly  - Have your vehicle checked by a 
dealer.
• Appears as soon as a proble m is detected in the push 
button starting system.• Appears constantly  - Have your vehicle checked by a 
dealer.
• Appears if there is a prob lem with the Auto high-
beam.
• Manually operate the headlight switch.
• If you are driving with th e high-beam headlights when 
this happens, the headlights are changed to low beams.
• Appears when the Auto high -beam is in operation, 
or the headlight switch is turned in  AUTO, but the 
temperature inside the came ra is too high. The Auto 
high-beam cancels automatically.
• Use the climate control sy stem to cool down the 
camera.
• Goes off  - The camera has been cooled down. Turning 
the headlight switch to  AUTO can resume the system.
2Front Sensor Camera* P. 569
•Appears when the area around the camera is 
blocked by dirt, mud, etc. Stop your vehicle in a safe 
place, and wipe it off with a soft cloth.
• May appear when driving in bad weather (rain, 
snow, fog, etc.)
•Have your vehicle checked by a dealer if the message 
comes back on after you cl eaned the area around the 
camera.
Models with smart entry system
Models with Auto high-beam
Models with Auto high-beam
Models with Auto high-beam
* Not available on all models
20 US ODYSSEY-31THR6210.book  112 ページ  2020年2月28日 金曜日 午前7時26分 
Page 115 of 767

113
uuIndicators uDriver Information Interface Wa rning and Information Messages
Continued
Instrument Panel
MessageConditionExplanation
•Appears if there is a problem with the fuel pump 
system.•Set the power mode to OFF for a while, then set the 
power mode to ON. The message disappears if there is 
no problem. If the message  appears again, take your 
vehicle to a dealer.
• Appears if there is a problem with the engine 
management system.•Set the power mode to OFF for a while, then set the 
power mode to ON. The message disappears if there is 
no problem. If the message  appears again, take your 
vehicle to a dealer.
• Appears if there is a pr oblem with the ignition 
system.• Set the power mode to OFF for a while, then set the 
power mode to ON. The message disappears if there is 
no problem. If the message  appears again, take your 
vehicle to a dealer.
• Appears if there is a problem with the seat heaters*.•Turn off the seat heaters* until the message disappears. 
If the message appears again, take your vehicle to a 
dealer.
• Appears if there is a problem with the climate 
control system.•Turn off the climate contro l system until the message 
disappears. If the message appears again, take your 
vehicle to a dealer.
* Not available on all models
20 US ODYSSEY-31THR6210.book  113 ページ  2020年2月28日 金曜日 午前7時26分 
Page 116 of 767

114
uuIndicators uDriver Information Interface Wa rning and Information Messages
Instrument Panel
MessageConditionExplanation
•Appears when you unlock and open the driver’s 
door while the engine is  running by remote engine 
start.
2 Remote Engine Start with Vehicle Feedback* P. 544
MessageConditionExplanation
•Flashes when the system senses a likely collision with 
a vehicle in front of you.•Take the appropriate means to prevent a collision (apply 
the brakes, change lanes, etc.)
2 Collision Mitigation Braking SystemTM (CMBSTM)* 
P. 615
2 Adaptive Cruise Control (ACC)
* P. 571
•Appears when ACC has been automatically 
canceled.•You can resume the set speed after the condition that 
caused ACC to cancel  improves. Press the RES/+ 
button.
2 Adaptive Cruise Control (ACC)* P. 571
•Appears when pressing the  –/SET button while the 
vehicle is moving and the brake pedal is depressed.• ACC cannot be set.
2 Adaptive Cruise Control (ACC)* P. 571
•Appears if the VSA ® or traction control function 
operates while ACC is in operation.• ACC has been automa tically canceled.
2Adaptive Cruise Control (ACC)* P. 571
Models with remote engine starter
Models with ACC
* Not available on all models
20 US ODYSSEY-31THR6210.book  114 ページ  2020年2月28日 金曜日 午前7時26分 
Page 117 of 767

115
uuIndicators uDriver Information Interface Wa rning and Information Messages
Continued
Instrument Panel
MessageConditionExplanation
•Appears when the vehicle is  driving out of a detected 
lane. The steering wheel vibrates rapidly.
• Keep the vehicle within  the lane you are driving.
2Lane Keeping Assist System (LKAS)* P. 588
•Appears when the vehicle is  driving out of a detected 
lane.
- The steering wheel vibr ates rapidly when the 
vehicle is drifting out of a detected lane.
- The steering wheel vibr ates rapidly when the 
vehicle is drifting out of a detected line. The system 
also steers the vehicle to help you remain within 
your driving lane.
• Keep the vehicle within  the lane you are driving.
2Road Departure Mitigation (RDM) System* P. 583
•You can change the setting for the road departure 
mitigation system.  Normal, Wide , and Warning Only  
can be selected.
2 Customized Features  P. 448
•Blinks when you fail to steer the vehicle. The beeper 
sounds simultaneously.•Operate the steering wheel to resume the LKAS.
Models with LKAS
Lane Keeping Assist System (LKAS)
Road Departure Mitigation (RDM) System
When you selected Warning Only
When you selected Normal or Wide
* Not available on all models
20 US ODYSSEY-31THR6210.book  115 ページ  2020年2月28日 金曜日 午前7時26分 
Page 118 of 767

116
uuIndicators uDriver Information Interface Wa rning and Information Messages
Instrument Panel
MessageConditionExplanation
•Appears when the LKAS is in  operation, or the LKAS 
button is pressed, but there is a problem with a 
system related to the LKAS. The LKAS cancels 
automatically. The beeper s ounds simultaneously if 
selected by customization.• If any other system indicators come on, such as the 
VSA ®, ABS and brake system, take appropriate action.
2Indicators  P. 84
•Appears when the LKAS is in  operation, or the LKAS 
button is pressed, but the temperature inside the 
LKAS camera is too high. The LKAS cancels 
automatically. The beeper s ounds simultaneously if 
selected by customization.• Use the climate control sy stem to cool down the 
camera.
• Goes off  - The camera has been cooled down. Pressing 
the LKAS button can resume the system.
2 Front Sensor Camera* P. 569
•Appears when the area around the camera is 
blocked by dirt, mud, etc. Stop your vehicle in a safe 
place, and wipe it off with a soft cloth.
• May appear when driving in bad weather (rain, 
snow, fog, etc.)•Have your vehicle checked by  a dealer if the indicator 
and message come back on a fter you cleaned the area 
around the camera.
Models with LKAS
* Not available on all models
20 US ODYSSEY-31THR6210.book  116 ページ  2020年2月28日 金曜日 午前7時26分 
Page 119 of 767

117
uuIndicators uDriver Information Interface Wa rning and Information Messages
Continued
Instrument Panel
MessageConditionExplanation
•Appears when  Auto Engine Idle Stop Guidance 
Screens ON has been selected from the 
customization menu.
2 Vehicle Customization P. 134
•Appears when  Auto Idle Stop Display ON  has 
been selected from the customization menu.
2 Customized Features  P. 448
2Auto Idle Stop  P. 558
•Appears when Auto Idle Stop does not activate for 
some reason.
• Appears when the engine  restarts automatically.
• Appears when the battery  temperature is around 
14°F (−10°C) or lower.
• Appears when Auto Idle Stop does not activate 
because the climate control sy stem is in use, and the 
difference between the set temperature and actual 
interior temperature becomes significant.
• Appears when Auto Idle Stop does not activate 
because the engine coolant temperature is too low 
or high.
•Appears when Auto Idle Stop does not activate 
because the battery charge level is low.
• Appears when the battery is low performance.
Models with color audio system
Models with Display Audio
20 US ODYSSEY-31THR6210.book  117 ページ  2020年2月28日 金曜日 午前7時26分 
Page 120 of 767

118
uuIndicators uDriver Information Interface Wa rning and Information Messages
Instrument Panel
MessageConditionExplanation
•Appears when Auto Idle Stop does not activate 
because the pressure to the brake pedal is not 
enough.•Depress the brake pedal firmly.
•Appears when  Auto Engine Idle Stop Guidance 
Screens ON  has been selected from the 
customization menu.
• Appears when  Auto Idle Stop Display ON  has 
been selected from the customization menu.
• Appears when the system  is under the following 
conditions while Auto Idle Stop activates:
• The climate control system  is in use, and the 
difference between the set temperature and 
actual interior temperature becomes significant.
• The humidity in the  interior is high.
• The battery charge level is low.
•The engine restarts automatically in a few seconds.
2 Auto Idle Stop  P. 558
Models with color audio system
Models with Display Audio
20 US ODYSSEY-31THR6210.book  118 ページ  2020年2月28日 金曜日 午前7時26分