turn signal INFINITI QX4 2001 Factory Manual PDF

INFINITI QX4 2001 Factory Manual PDF QX4 2001 INFINITI INFINITI https://www.carmanualsonline.info/img/42/57027/w960_57027-0.png INFINITI QX4 2001 Factory Manual PDF

Page 844 of 2395

INFINITI QX4 2001  Factory Manual PDF SEF751UA
Component DescriptionNBEC0177The fuel tank temperature sensor is used to detect the fuel tem-
perature inside the fuel tank. The sensor modifies a voltage signal
from the ECM. The modified si

Page 855 of 2395

INFINITI QX4 2001  Factory Manual PDF On Board Diagnosis LogicNBEC0182When a misfire occurs, engine speed will fluctuate. If the engine
speed fluctuates enough to cause the CKP sensor signal to vary,
ECM can determine that a misfire is oc

Page 861 of 2395

INFINITI QX4 2001  Factory Manual PDF 12 CHECK HEATED OXYGEN SENSOR 1 (FRONT)
Without CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Set voltmeter probes between ECM terminal 63 (HO2S1 bank 1 right signal) o

Page 863 of 2395

INFINITI QX4 2001  Factory Manual PDF SEF332I
Component DescriptionNBEC0185The knock sensor is attached to the cylinder block. It senses
engine knocking using a piezoelectric element. A knocking vibration
from the cylinder block is sensed

Page 866 of 2395

INFINITI QX4 2001  Factory Manual PDF Diagnostic ProcedureNBEC0190
1 CHECK KNOCK SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT-I
1. Turn ignition switch ªOFFº.
2. Disconnect ECM harness connector.
3. Check resistance between ECM termin

Page 880 of 2395

INFINITI QX4 2001  Factory Manual PDF Diagnostic ProcedureNBEC0202
1 CHECK STARTING SYSTEM
Turn ignition switch to ªSTARTº position.
Does the engine turn over?
Does the starter motor operate?
YesorNo
Ye s©GO TO 2.
No©Check starting sy

Page 883 of 2395

INFINITI QX4 2001  Factory Manual PDF SEF344Z
DTC Confirmation ProcedureNBEC0215
SEF345Z
SEF560X
NOTE:
If ªDTC Confirmation Procedureº has been previously conducted,
always turn ignition switch ªOFFº and wait at least 10 seconds
befor

Page 907 of 2395

INFINITI QX4 2001  Factory Manual PDF 3 CHECK EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE OUTPUT SIGNAL CIRCUIT
FOR OPEN AND SHORT
1. Turn ignition switch ªOFFº.
2. Disconnect ECM harness connector.
3. Check harness continuity bet

Page 913 of 2395

INFINITI QX4 2001  Factory Manual PDF 3 CHECK EVAP CANISTER VENT CONTROL VALVE POWER SUPPLY CIRCUIT
1. Turn ignition switch ªOFFº.
2. Disconnect EVAP canister vent control valve harness connector.
SEF143S
3. Turn ignition switch ªONº.

Page 917 of 2395

INFINITI QX4 2001  Factory Manual PDF On Board Diagnosis LogicNBEC0238Malfunction is detected when an improper voltage signal from
EVAP control system pressure sensor is sent to ECM.
Possible CauseNBEC0513IHarness or connectors
(The EVAP