JAGUAR S TYPE 2005 1.G Technical Guide Update

JAGUARS-TYPEElectrical/Electronic
86
Exterior Lighting
The exterior lighting switch located on the fascia,
operates the headlamps, sidelights, fog lamps and
the delay variable timer switch. Each headlamp
assembly consists of two headlamp units, the
main beam lamp unit is the inner and the dipped
beam, front parking (side) lamp and the direction
indicator lamp unit is the outer.
Fog lamps are located in recesses in the front
bumper. The two retaining screws are located
behind the anti-theft cover and splitter vane.
J.418.442
Each rear lamp assembly incorporates a tail/stop
lamp and an auxiliary tail lamp, a fog lamp, a
reversing lamp and a direction indicator lamp.
Access for bulb replacement is from the luggage
compartment. The high mounted stop lamp is
powered via the stoplamp switch, it is clipped to
the rear screen and is replaceable as a unit.
The side repeater lamps (where fitted) are located
within the front fender. The sidemarker lamps are
located with the rear and front bumper and are
EXTERIOR LAMPS
High Mounted Stop Lamp
Number Plate Lamps
Inner Headlamp
Unit
Outer Headlamp
Unit
Front Fog Lamp
Side Marker Lamp
Side Repeater Lamp
(where fitted)
Side Marker Lamp
Rear Lamp Assembly
J.418.441 & 442

JAGUARS-TYPEElectrical/Electronic
87
Bulb renewal
It is important that only Jaguar bulbs of the type
specified are used when renewing bulbs.
Before renewing bulbs, switch off the ignition and
light switches.
Top cover
To gain access to the headlamp units, the top
cover must be removed.
Turn the four fasteners a quarter turn anti-
clockwise and then remove the top cover.
After changing the defective bulb, refit the cover
and turn the fasteners clockwise to retain the
cover.
JOL.073
supplied as part of a high level bumper assembly
(the side markers are located in the bumper by
tangs on one side of the unit and held in position
by a spring clip on the other side).TOP COVER

JAGUARS-TYPEElectrical/Electronic
88
JOL.074
Headlamp - Bulb Renewal
The bulbs are halogen type and will be damaged if
touched by hand or contaminated with oil or
grease. It is important to use clean gloves or cloth
when handling a bulb which is to be used again. A
contaminated bulb may be cleaned with
methylated spirit before refitting.
JOL.116
Dipped Beam (outer) Headlamp
Open the bonnet.
Remove the top cover.
Turn the circular cover (A) anti-clockwise and
remove.
Press the spring clip (B) towards the bulb and
downwards to release the bulb. Remove the
bulb/connector (C) from the headlamp assembly.
Pull the connector from the bulb.
Attach the connector to the new bulb, type H7 for
dipped beam, and fit to the headlamp. The bulb
will only correctly fit in one position.
Engage the spring clips to retain the bulb and then
fit the circular cover.
Refit the top cover and close the bonnet.
Have the headlamp aim checked after bulb
replacement.
Main Beam (inner) Headlamp
Open the bonnet.
Remove the top cover.
Turn the bulb holder a quarter turn anti-clockwise
and remove the bulb and holder from the lamp
unit.
Fit a new bulb to the holder, type HB3 for main
beam.
Fit the holder to the lamp unit, the bulb will only
correctly fit in one position.
Refit the top cover and close the bonnet. HEADLAMP - DIPPED BEAM
HEADLAMP - MAIN BEAM
ABC

JAGUARS-TYPEElectrical/Electronic
89
JOL.078
JOL.079
D.417.108
Front Direction Indicator - Bulb Renewal
Remove the top cover.
The bulb is contained within the outer headlamp.
Turn the holder a quarter turn anti-clockwise and
remove the bulb and holder.
Remove the bulb and fit a new one of the correct
type, PY21W.
Fit the holder to the lamp unit, it will only fit in
one position.
Refit the top cover and close the bonnet.
Front Parking (side) Lamp - Bulb Renewal
Open the bonnet.
Remove the top cover.
The front parking lamps are contained within the
outer headlamp units.
Rotate the bulb holder anti-clockwise and remove
from the headlamp.
Pull the capless bulb from the holder and fit a
new one of the correct type, W5W.
Reposition the bulb holder in the headlamp unit
and turn clockwise.
Refit the top cover and close the bonnet.
Front Fog Lamp - Bulb Renewal
Remove bumper splitter vane and blackout panel.
Unscrew fixing; remove lamp from front.
Twist/remove bulb carrier.
Remove the bulb and fit a new one of the correct
type, H3.
Refit the bulb carrier, fixing, blackout panel and
splitter vane.FRONT DIRECTION INDICATOR AND PARKING LAMPS
FRONT FOG LAMP
Front Parking
Lamp
Front Direction
Indicator Lamp
JOL.078 & 079

JAGUARS-TYPEElectrical/Electronic
90Side Repeater Indicator - Bulb Renewal
Remove the lamp unit from the front wing panel
by pressing the unit forwards or rearwards to
compress the spring clip and remove the complete
unit.
Twist the bulb anti-clockwise and remove.
Fit a new bulb of the correct type, W5W.
Press the unit into the recess until it clicks into
place.
JOL.076
JOL.075
Rear Lamp Assembly - Bulb Renewal
The rear lamp assembly has the following bulbs:
¥ Reverse lamp, type P21W.
¥ Stop/tail lamp, type P21/4W.
¥ Fog lamp, type P21W
¥ Tail lamp, type R5W.
¥ Direction indicator, type PY21W.
Ensure that the lamps and ignition switch are OFF
before removing any bulbs.
Open the luggage compartment, loosen the side
carpet and unclip the rear lamp bulb carrier.
Remove the faulty bulb and fit a new one of the
correct type, as illustrated on the bulb holder.
Fitment of the correct type is essential.
Refit the bulb carrier assembly, ensuring that the
clips are correctly secured.
Refit the carpet. SIDE REPEATER INDICATOR
REAR LAMP ASSEMBLY
Direction Indicator
Tail Lamp
Stop/Tail Lamp
Fog Lamp
Reverse Lamp

JAGUARS-TYPEElectrical/Electronic
91
JOL.077
High Mounted Stop Lamp
Remove the rear parcel tray trim panel.
Depress clips to remove from pegs.
Number Plate Lamp - Bulb Renewal
Push the lens clip sideways and remove the lens
from the vehicle.
Remove the bulb and fit a new one of the correct
type, W5W.
Refit the lens by pressing it firmly into the recess
until it clicks into place.NUMBER PLATE LAMP
J.418.447
EXTERIOR LIGHTING CONTROLS
Exterior Lighting
Switch
LH Column
Switchgear
Lighting Stalk
Hazard Switch
Autolamp
Sensor
Instrument
Pack
To
General Electronic
Control Module
To
Rear Electronic
Control Module

JAGUARS-TYPEElectrical/Electronic
92
J.418.449
LH Side Repeater
RH Side Repeater
LH Side Marker
(NAS only)
RH Side Marker
(NAS only)
Direction Indicator
Parking
Dip Beam
Main Beam
LH Headlamp
Direction Indicator
Parking
Dip Beam
Main Beam
RH Headlamp
Front Fog Lamp
Relay
Front Power
Distribution Box
General
Electronic
Control
Module
From
Instrument Pack
RH Front Fog
LampLH Front Fog
Lamp FRONT EXTERIOR LIGHTING

JAGUARS-TYPEElectrical/Electronic
93
J.418.448
REAR EXTERIOR LIGHTING
Stop
Brake Switch
LH Rear Lamp Unit
Direction Indicator
Tail
Fog
Reverse
Rear
Electronic
Control
Module
High Mounted Stop
Lamp
Number Plate Lamp
LH Side Marker
(NAS only)
Stop
RH Rear Lamp Unit
Direction Indicator
Tail
Fog
Reverse
RH Side Marker
(NAS only)
Number Plate Lamp
From
Instrument Pack

JAGUARS-TYPEElectrical/Electronic
94
Interior Lighting
The automatic operation of the interior lamps is
controlled by the general electronics control
module (GECM).
The interior lighting system consists of the
following lamps:
¥ Two front interior lamps.
¥ Front footwell lamps
¥ Two rear interior lamps with integral reading
lamps.
¥ Front door/puddle lamps
¥ Glove compartment lamp.
¥ Vanity mirror lamps.
¥ Two luggage compartment lamp.
Front and Rear Interior Lamps
Two combined map/reading/courtesy lamps are
fitted in the front overhead console. Operation is
described in the ÔInstrument and ControlsÕ
section. A map/reading/courtesy lamp is fitted
above each rear passenger grab handle.
Illuminated Entry/Exit
When the vehicle is unlocked, the courtesy lamps
will gradually illuminate and remain on for 20
seconds.
If the courtesy lamps are on they will fade off
when the vehicle is locked with a key or a key-ring
transmitter.
Door Guard/Puddle Lamps
Door guard lamps are fitted to each front door to
give warning of an open door to passing vehicles.
The rear doors are fitted with reflectors. The
puddle lamps illuminate the Ôstep outÕ area at
night.
Luggage Compartment, Glovebox and Vanity
Mirrors
The luggage compartment, glovebox and vanity
mirrors are illuminated when in use. These lamps
will work for up to 40 minutes after the ignition
has been switched off.
J.418.443
JOL.064
FRONT INTERIOR LAMPS AND SWITCHES
REAR INTERIOR LAMP AND SWITCH

JAGUARS-TYPEElectrical/Electronic
95
Instrumentation and Controls
1. Instruments pack
2. Wipers/washers and headlamp power
wash switches,
3. Trip computer switches,
4. Hazard warning switch,
5. Audio system control panel,
6. Cassette stowage, telephone presenter or
navigation display,
7. Climate control panel,
8. Ashtray and cigar lighter,
9. Traction control or dynamic stability
control switch,
10. Sports mode switch,
11. Front seat heater switches,
12. Coin tray,
13. Cruise control switches,
14. Horn and driverÕs airbag,
15. Audio switches,
16. Dimmer switch,
17. Bonnet release lever,
18. Headlamp levelling switch,
19. Fuel filler flap release switch,
20. Luggage compartment release switch,
21. Exterior lighting switch,
22. Direction indicators and main beam
switches,
1
7
8
9 10 11 12 13 19
16 17 18 20 21 22
142
3
45
6
15
Instrument Pack
Vehicle instrumentation is installed on the
instrument pack on the fascia. The calibration of
the odometer and speedometer, the language of
the message center and the composition of the
indicator lamps are tailored to suit the destination
market. The instrument pack acts as a system
monitor for the audible and visual warnings.When the ignition switch is turned to position II,
the following visual warnings (telltales) are
illuminated for three seconds to provide a bulb
prove out function:
¥ ABS telltale
¥ Airbag telltale (six seconds prove out)
¥ Catalyst over temperature telltale (Japan only)
¥ Charging system telltale