KIA CARNIVAL 2007 Workshop Manual

Windshield Wiper / Washer

2007 > 2.7L V6 GASOLINE >
COMPONENT LOCATION

Windshield Wiper-Washer Switch

2007 > 2.7L V6 GASOLINE >
REPLACEMENT
1.Remove the steering column upper and lower shrouds (A) after removing 3 screws.
2.Remove the wiper switch (A) by pushing the lock pin (B) after disconnecting the connector.
[LHD]
[RHD]
3.Installation is the reverse of removal.
INSPECTION
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition,
replace wiper and wiper switch.
[LHD]

[RHD]
WIPER SWITCH
WASHER SWITCH

Front Wiper Motor

2007 > 2.7L V6 GASOLINE >
COMPONENT LOCATION

2007 > 2.7L V6 GASOLINE >
REMOVAL
1.Remove the windshield wiper arm and blade after removing the mounting nut (A).
TORQUE: 28~32 Nm (2.8~3.2 kgf.m, 20~23.1 lbf.ft)
2.Remove the weather strip and the cowl top cover (A) after removing 4 fasteners.
3.Remove the windshield wiper motor and linkage assembly after removing 4 bolts. Disconnect the wiper motor
connector (A) and windshield deicer connector (B) from the wiper motor & linkage assembly.
Torque: 7 - 11Nm (0.7- 1.1, kgf.m, 5.0 - 7.9 lbf.ft)
4.Installation is the reverse of removal.
INSTALLATION
1.Install the wiper arm and blade to the specified position.
Specified position AB

Distance[in (mm)]1.57+0.19/0
(40+5/0) 1.57+0.19/0
(40+5/0)
2. Set the washer nozzle on the specified spray position.
INSPECTION
SPEED OPERATION CHECK
1. Remove the connector from the wiper motor.
2. Attach the positive (+) lead from the battery to terminal 4 and the negative ( - ) lead to terminal 1.
3. Check that the motor operates at low speed.
4. Connect the positive (+) lead from the battery to terminal 5 and the negative ( - ) lead to terminal 1.
5. Check that the motor operates at high speed.

Front Washer Motor