display Lancia Musa 2007 Owner handbook (in English)

AUTOMATIC OPERATION (AUTO)
For engaging/disengaging the automatic operating mode (AUTO),
move lever A to A/M: automatic mode activation is indicated by
message AUTO and gear engaged on the display (see figure).
With AUTO mode active, the system decides to change gear
depending on car speed, engine rpm and how the accelerator pedal is
pressed. It is however possible to change gears with the control lever
without deactivating the automatic mode: this function called “gear
advice” suspends the automatic mode for the time required to change
gear.
194
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D1243g
L0D0333m
L0D0332m

Automatic operation (AUTO - ECO)
The ECO function can be activated only with automatic mode active.
To activate the ECO function press button E set on the mask near the
gearshift lever. After activating this function, the display shows the
gear engaged and words AUTO and E (see figure).
With ECO function active the system will select the most suitable gear
(according to car speed, engine rpm and how the accelerator pedal is
pressed) to save as much fuel as possible.
If necessary (e.g.: overtaking) the system will change gears in order
to provide suitable torque and power for acceleration (this will take
place in automatic mode regardless of ECO function condition, ON or
OFF).
195
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D1244g
L0D0334m

ENGAGED GEAR DISPLAYING
One second after turning the ignition key to MAR, the gear engaged
and the last operating mode adopted (AUTO or MANUAL) will be
displayed on the display:
N = neutral;
1 = first gear;
2 = second gear
3 = third gear;
4 = fourth gear;
5 = fifth gear;
R = reverse.
If the ECO function is on, the display will show E (Economy) next to
the gear engaged.
IMPORTANT If after 10 seconds (with ignition key to MAR) the
display does not show the gear engaged, turn the ignition key to
STOP and wait for the display to turn off, then repeat system switch
on. If the fault persists, contact Lancia Dealership.
196
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D1243g
L0D1244g

STARTING THE ENGINE
The engine can be started either with a gear engaged or in neutral N,
always press the brake pedal first.
After starting:
❒the gearbox sets to neutral N automatically
❒lever A keeps the same position it had before starting
❒the display shows N and a buzzer will indicate if the lever position
and the gear engaged are not matching
❒gears that can be engaged are: 1st, 2nd or reverse R gear.
IMPORTANT When trying to start the engine with gearbox not in
neutral (any gearshift lever position other than N and without
pressing the brake pedal, the multifunction display will show a
dedicated message (see paragraph “Warning lights and messages”).
In this event, to start the engine just repeat operation keeping the
brake pedal pressed.
197
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
L0D0332m
WARNING
If the engine fails to start with the gear engaged, the driver is informed of the
potentially dangerous situation due to the fact that the gearbox is in neutral by
the buzzer.

PARKING THE CAR
To park the car safely it is absolutely necessary to
press the brake pedal and to engage first gear or
reverse R and also the hand brake if the car is on a
slope; it is also absolutely necessary to wait for the
multifunction display showing the gear engaged to
go off before releasing the brake pedal.
IMPORTANT NEVER leave the car with gearbox in
neutral N.
IMPORTANT NOTES
❒With the car stopped and a gear engaged always
keep the brake pedal pressed until deciding to
move off, then release the brake pedal and
accelerate gradually;
❒during prolonged halts with the engine running it
is advisable to keep the gearbox in neutral N;
❒when the car is parked facing uphill, to safeguard
clutch efficiency do not use the accelerator to
keep the car still since clutch overheating could
damage it. Use the brake pedal and press the
accelerator pedal only when deciding to move off;❒use second gear only when more control is needed
for moving off manoeuvres with poor grip;
❒if, in reverse gear R, first gear is to be engaged or
vice versa, shift gear only when the car is stopped
completely and with the brake pedal pressed;
❒though highly inadvisable, if when travelling
downhill for some unexpected reason the car is
set to neutral N, when the engagement of a gear
is requested, the system automatically engages
the best gear in relation to the speed of the car to
allow the correct transmission of torque to the
wheels;
❒when travelling downhill with a gear engaged and
the accelerator released (if the car is moving),
beyond a pre-established speed, the system
engages the clutch automatically to give the car
adequate engine braking.
199
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR

211
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
GENERAL WARNINGS
Failure indications shown on the reconfigurable
multifunction display together with buzzer
sounding (adjustable) and warning light (if any)
coming on on the cluster, are accompanied by
specific warning messages (e.g.: “Switch off
engine”, etc...). These indications are concise and
cautionary and are aimed to suggest the prompt
action the driver must adopt when a car
malfunctioning appears. These indications,
however, shall not be considered as exhaustive
and/or as an alternative to the specifications
contained in this “Owner Handbook”, which shall
always be read through carefully and thoroughly. In
case of failure indication always refer to the
specifications contained in this section.
IMPORTANT Failure indications displayed on the
reconfigurable multifunction display are divided
into two categories: very serious failures and
serious/minor failures.
The message and the warning indication
corresponding to very serious failures are displayed
alternately for few seconds. This “cycle” is repeated
indefinitely and it stops any previous indication on
the display. It is displayed every time the ignition
key is turned to MAR, until the cause of
malfunctioning is removed. Should failure disappear, message and warning light
will however stay on for about 2 seconds.
Eliminating the failure, the warning light and the
displayed message will go off. It is possible to stop
this “cycle” by pressing button Q; in this case the
screen active before the failure will be resumed and
the warning light will stay on until eliminating the
failure cause.
The message and the warning indication
corresponding to serious/minor failures are
displayed alternately for few seconds. This “cycle”
is repeated for about 20 seconds and then goes off,
but it comes on again every time the ignition key is
turned to MAR.
Should failure disappear during the 20 seconds
displaying, message and warning light will stay on
for about 2 seconds. Eliminating the failure, the
warning light and the displayed message will go off.
At the end of the display cycle (which lasts approx.
20 seconds), or if button Qis pressed, the screen
active before the failure will be resumed and the
warning light will stay on until eliminating the
failure cause.
Q= Press button “MODE” for less than two seconds
R= Press button “MODE” for over two seconds

212
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
Warning
light on
dialMessage on
multifunction
display
x
x
red
redLOW BRAKE FLUID LEVEL
Turning the ignition key to MAR the warning light on the dial turns
on, but it should go off after few seconds.
The warning light turns on (together with the message on the display,
on certain versions) when the level of the brake fluid in the reservoir
falls below the minimum level, due to possible leak in the circuit.
HANDBRAKE ON
Turning the ignition key to MAR the warning light on the dial turns
on, but it should go off after few seconds. The warning light turns on
when the handbrake is on.
IMPORTANT If the warning light
xturns on when travelling
check that the handbrake is not engaged.
If the warning light xturns on when travelling (on certain versions together with the
message on the display) stop the car immediately and contact Lancia Dealership.
WARNING

213
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
FRONT PASSENGER AIR BAG DEACTIVATED (where fitted)
Dial warning light comes on when front passenger air bag is
deactivated. With front passenger air bag on, turning the ignition key
to MAR, warning light
Fcomes on flashing on the cluster for about
4 seconds, then it shall go off.
F
SEAT BELTS NOT FASTENED
The warning light will come on flashing, together with the warning
buzzer when, with the car moving, the driver's seat belt is not
correctly fastened. The S.B.R. (Seat Belt Reminder) buzzer can only
be excluded by Lancia Dealership, the system can be reactivated
through the set-up menu (see diagram aside).
<
amber
red
Warning
light on
dial Message on
multifunction
display
WARNINGWarning light Findicates also warning light ¬failure. This is indicated by
intermittent flashing, over 4 seconds, of warning light F. In this event, warning
light
¬could be not up to indicate restraint system failures, if any. Stop the car
and contact Lancia Dealership to have the system checked.

214
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
Warning
light on
dialMessage on
multifunction
display
red
red
w
v
LOW BATTERY CHARGE
Turning the key to MAR the warning light on the dial turns on, but it
should go out as soon as the engine is started (with the engine running
at idle speed a brief delay in going out is allowed).
If it stays on contact immediately Lancia Dealership.
LOW ENGINE OIL PRESSURE
Turning the key to MAR the warning light on the dial turns on, but it
should go off as soon as the engine is started.
If the vwarning light turns on when the car is travelling (on certain versions together with the
message on the display), stop the engine immediately and contact a Lancia Dealership.

215
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
ENGINE COOLANT FLUID HIGH TEMPERATURE
Turning the ignition key to MAR the warning light on the dial turns
on, but it should go off after few seconds.
The warning light turns on (together with the message on the display)
when the engine is overheated. If the warning light comes on when
driving, proceed as follows:
❒normal driving conditions: stop the car, switch off the engine and
check whether the water level in the reservoir is not below the MIN
mark. Otherwise wait for few seconds to allow engine cooling, then
open slowly and carefully the cap, top up coolant and check
whether its level is falling between MIN and MAX marks in the
reservoir. Check visually any leak. If when restarting the warning
light comes on again, contact a Lancia Dealership;
ç
continues on next page
red
Warning
light on
dial Message on
multifunction
display