key Lexus CT200h 2014 (in English) Repair Manual

5558-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Pull the insertion key out of the kit.
Place the kit with the bottom facing
upward.
Peel off the label, and push in the inser-
tion key until a click is heard.
Return the kit to an upright position
and make sure that the compressor
switch is off.
Use the kit with the top facing upward.
Connect the power plug to the
power outlet socket. ( →P. 4 3 7 )
Emergency repair method
1
2
3
4
CT200h_OM_OM76135E_(EE).book Page 555 Friday, May 30, 2014 1 1:14 AM

5638-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
If the hybrid system will not start
One of the following may be the cause of the problem:
●The electronic key may not be functioning properly.* ( → P. 565)
●There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle. ( →P. 76 )
●There may be a malfunction in the immobilizer system.* (→ P. 7 9 )
●There may be a malfunction in the shift control system.* (→ P. 1 8 0 , 5 7 7 )
●The hybrid system may be malfunctioning due to an electrical problem such
as electronic key battery depletion or a blown fuse. However, depending on
the type of malfunction, an interim measure is available to start the hybrid sys-
tem. ( →P. 5 6 4 )
*: It may not be possible to shift the shift position other than P.
One of the following may be the cause of the problem:
●The 12-volt battery may be discharged. ( →P. 5 6 7 )
●The 12-volt battery terminal connections may be loose or corroded.
(→ P. 4 6 3 )
One of the following may be the cause of the problem:
●The 12-volt battery may be discharged. ( →P. 5 6 7 )
●One or both of the 12-volt battery terminals may be disconnected. ( →P. 463)
Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional if the problem cannot be repaired, or if repair procedures
are unknown.
Reasons for the hybrid system not starting vary depending on the situation.
Check the following and perform the appropriate procedure:
The hybrid system will not start even though the correct starting proce-
dure is being followed. ( →P. 177)
The interior lights and headlights are dim, or the horn does not sound or
sounds at a low volume.
The interior lights and he adlights do not turn on, or the horn does not
sound.
CT200h_OM_OM76135E_(EE).book Page 563 Friday, May 30, 2014 1 1:14 AM

5658-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
If the electronic key does not operate properly
Use the mechanical key ( →P. 1 1 5 ) i n
order to perform the following opera-
tions:
Locks all the doors
Closes the windows
* (turn and hold)
Unlocks all the doors
Opens the windows
* (turn and hold)
*: These settings must be customized at any authorized Lexus dealer or repairer, or another duly qualified and equipped professional.
Depress the brake pedal.
Touch the Lexus emblem side of the
electronic key to the power switch.
If any of the doors is opened or closed
while the key is being touched to the
switch, an alarm will sound to indicate
that the start function cannot detect the
electronic key.
Press the power switch within 10 seconds of the buzzer sounding, keeping the
brake pedal depressed.
In the event that the hybrid system still cannot be operated, contact any autho-
rized Lexus dealer or repairer, or another duly qualified and equipped profes-
sional.
If communication between the electronic key and vehicle is interrupted ( →P.
130) or the electronic key cannot be us ed because the battery is depleted, the
smart entry & start system and wireless remote control cannot be used. In such
cases, the doors can be opened and the hybrid system can be started by following
the procedure below.
Locking and unlocking the doo rs and key linked functions
1
2
3
4
Starting the hybrid system
1
2
3
CT200h_OM_OM76135E_(EE).book Page 565 Friday, May 30, 2014 1 1:14 AM

5668-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
■Stopping the hybrid system
Set the parking brake, shift the shift position to P and press the power switch as you nor-
mally do when stopping the hybrid system.
■Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the electronic
key battery be replaced immediately when the battery is depleted. (→P. 4 8 3 )
■Alarm (if equipped)
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set, the alarm
may be triggered. ( →P. 8 5 )
■Changing power switch modes
Within 10 seconds of the buzzer sounding, release the brake pedal and press the power
switch.
The hybrid system does not start and modes will be changed each time the switch is
pressed. ( →P. 1 7 8 )
WA R N I N G
■When using the mechanical key and operating the power windows
Operate the power window after checking to make sure that there is no possibility of
any passenger having any of their body parts caught in the window.
Also, do not allow children to operate the mechanical key. It is possible for children and
other passengers to get caught in power window.
CT200h_OM_OM76135E_(EE).book Page 566 Friday, May 30, 2014 1 1:14 AM

5698-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Close the exclusive jump starting terminal cover, and reinstall the fuse box
cover to its original position.
Once the hybrid system starts, have the vehicle inspected at any authorized
Lexus dealer or repairer, or another duly qualified and equipped professional as
soon as possible.
■Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting.
■To prevent 12-volt battery discharge
●Turn off the headlights and the audio system while the hybrid system is off.
●Turn off any unnecessary electrical components when the vehicle is running at a low
speed for an extended period, such as in heavy traffic.
■When the 12-volt battery is removed or discharged
●The hybrid system may not start. ( →P. 4 6 5 )
●If the 12-volt battery discharges while the shift position is in P, it may not be possible to
shift the shift position to other positions. In this case, the vehicle cannot be towed with-
out lifting both front wheels because the front wheels will be locked. ( →P. 5 1 0 )
●When the 12-volt battery is reconnected, start the hybrid system and confirm that the
shift position can be changed to each position using the shift position indicator.
●Make sure that the key is not inside the vehicle when recharging or replacing the 12-
volt battery. The key may be locked in the vehicle if the alarm is activated. (→P. 8 5 )
■Charging the 12-volt battery
The electricity stored in the 12-volt battery will discharge gradually even when the vehicle
is not in use, due to natural discharge and the draining effects of certain electrical appli-
ances. If the vehicle is left for a long time, the 12-volt battery may discharge, and the
hybrid system may be unable to start. (The 12-volt battery recharges automatically while
the hybrid system is operating.)
WA R N I N G
■Avoiding 12-volt battery fires or explosions
Observe the following precautions to prevent accidentally igniting the flammable gas
that may be emitted from the 12-volt battery:
●Make sure each jumper cable is connected to the correct terminal and that it is not
unintentionally in contact with any other than the intended terminal.
●Do not allow the other end of the jumper cable connected to the “+” terminal to come
into contact with any other parts or metal surfaces in the area, such as brackets or
unpainted metal.
●Do not allow the + and - clamps of the jumper cables to come into contact with each
other.
●Do not smoke, use matches, cigarette lighters or allow open flame near the 12-volt
battery.
9
CT200h_OM_OM76135E_(EE).book Page 569 Friday, May 30, 2014 1 1:14 AM

5919-2. Customization
CT200h_OM_OM76135E_(EE)
9
Vehicle specifications
Vehicles with a navigation system or Lexus Display Audio: Settings that can be
changed using the Remote Touch or Lexus Display Audio controller
Vehicles with a navigation system or Lexus Display Audio: Settings that can be
changed using the multi-information display
Vehicles without a navigation system or Lexus Display Audio: Settings that
can be changed using the multi-information display
Settings that can be changed by any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional
Definition of symbols: O = Available, – =Not available
■Door lock ( →P. 119, 565)
Customizable Features
1
2
3
4
FunctionDefault
settingCustomized setting
Allows all doors to be
unlocked by turning the
mechanical key once in the
driver’s doorOff
(All doors
unlocked in first
step)
On
(Driver’s door
unlocked in first step, all doors
unlocked in sec- ond step)
O––O
Speed linked door locking
functionOnOffO–OO
Shift position linked door
locking functionOffOnO–OO
Shift position linked door
unlocking functionOffOnO–OO
Driver’s door linked door
unlocking functionOnOffO–OO
1234
CT200h_OM_OM76135E_(EE).book Page 591 Friday, May 30, 2014 1 1:14 AM

5939-2. Customization
CT200h_OM_OM76135E_(EE)
9
Vehicle specifications
■Tu r n s i g n a l l e v e r ( →P. 188)
■Automatic light control system ( →P. 1 9 0 )
■Illumination ( →P. 4 2 6 )
FunctionDefault
settingCustomized setting
Times of flashing of the lane
change signal flashers3
5
O––O
7
9
11
Off
1234
FunctionDefault settingCustomized setting
Light sensor sensitivityStandard-2 to 2O–OO
Welcome light
illumination control On Off – – – O
1234
FunctionDefault
settingCustomized setting
Time elapsed before the inte-
rior lights turn off 15 secondsOff
O–OO
7. 5 s e c o n d s
30 seconds
Time elapsed before the exte-
rior lights turn off15 seconds
Off
O–OO7. 5 s e c o n d s
30 seconds
Operation after the power
switch is turned offOnOff–––O
Operation when the doors
are unlocked with the Smart
entry & start system or the
wireless remote control func-
tion or the mechanical key
*
OnOff–––O
1234
CT200h_OM_OM76135E_(EE).book Page 593 Friday, May 30, 2014 1 1:14 AM

5949-2. Customization
CT200h_OM_OM76135E_(EE)
*: Interior or exterior illumination can be set separately
■Instrument cluster ( →P. 9 6 )
Operation when you
approach the vehicle with the
electronic key on your per-
son
*
OnOff–––O
Footwell lighting On Off – – – O
Cup holder light On Off – – – O
Enable/disable operation of
the outer foot lights when the
doors are unlocked with the
power door lock switch On Off – – – O
FunctionDefault
settingCustomized setting1234
FunctionDefault settingCustomized setting
Display of the tachometer and
Hybrid System Indicator
*1Auto Hybrid system
indicator
(always) – OOO
Tachometer (always)
Eco lamp
*1Eco drive sup- port On (always)
– OOO
Off
Sport lamp
*1On Off – OOO
Brightness of Eco lamp and
sport lamp
*1Standard Bright – OOO
EV indicatorAutoOff–OOO
Language*2English
French
–OOO
Spanish
German
Italian
Russian
Chinese
1234
CT200h_OM_OM76135E_(EE).book Page 594 Friday, May 30, 2014 1 1:14 AM

5969-2. Customization
CT200h_OM_OM76135E_(EE)
■Automatic air conditioning system ( →P. 4 0 8 , 4 1 7 )
■Powe r w i n d ows ( →P. 1 6 1 )
*: This function cannot be customized unless power window operation using the wire-
less remote control is enabled
FunctionDefault settingCustomized setting
Switching between outside air
and recirculated air mode
linked to “AUTO” switch
operation
OnOffO––O
A/C Auto switch operationOnOffO–OO
Heating/coolin g operation
minimized in Eco drive modeOnOff–––O
1234
FunctionDefault
settingCustomized setting
Mechanical key linked opera-
tion (close)OffOn–––O
Mechanical key linked opera-
tion (open)OffOn–––O
Wireless remote control
linked operation (close)OffOn–––O
Wireless remote control
linked operation (open)OffOn–––O
Buzzer sounds if operated
using wireless remote con-
trol
*
OnOff–––O
1234
CT200h_OM_OM76135E_(EE).book Page 596 Friday, May 30, 2014 1 1:14 AM

5979-2. Customization
CT200h_OM_OM76135E_(EE)
9
Vehicle specifications
■Lexus parking assist-sensor* ( → P. 2 1 9 )
*: If equipped
■Reverse buzzer ( →P. 1 8 5 )
■Outside rear view mirrors ( →P. 1 5 7 )
■Alarm* (→ P. 85)
*: If equipped
FunctionDefault
settingCustomized setting
Alert Volume
(Alert volume can be
adjusted)31 to 5O––O
Display
(Automatic display off the
LEXUS Park Assist graphic
can be enabled/disabled)
OnOffO––O
Distance
(Distance mode can be
selected)
LongShortO––O
1234
FunctionDefault settingCustomized setting
Signal (buzzer) when the shift
position is in RIntermittentSingle–––O
1234
FunctionDefault settingCustomized setting
Automatic folding/extending
operationLinked to lock-
ing/unlocking of the doorsOff
–––OLinked to power
switch operation
1234
FunctionDefault settingCustomized setting
Deactivates the alarm when
the doors are unlocked using
the mechanical keyOffOn–––O
1234
CT200h_OM_OM76135E_(EE).book Page 597 Friday, May 30, 2014 1 1:14 AM