ESP MERCEDES-BENZ C-CLASS COUPE 2015 Owners Manual

driving at full throttle and sudden acceleration.
Never refuel using fuel with alower RON.
i In some countries, the available petro
lmay
not be sufficiently low in sulphur. This fuel can temporarily produce unpleasant odours,
especially on short journeys. As soon as sul-
phur-free fuel (sulphur conten t<10ppm) is
used for refuelling, the odours are reduced.
Information on refuelling (Y page 167).
Mercedes-AMG vehicles
! Only refuel using super unleaded petro
lwith
at least 98 ROZ, that conform stoEuropean
standard EN 228 or an equivalent specifica-
tion.
You can otherwise impair engin eoutput or
damage the engine.
Fuel of this specification may contain up to
10% ethanol. Your vehicle is suitable for use
with E10 fuel. You may refuel your vehicle
using E10 fuel.
! As
atemporary measure, if the recommen-
ded fuel is not available, you may also use
unleaded petro lwith an octane ratin gof
95 RON. This may reduce engin eperform-
ance and increase fuel consumption .Asmuch
as possible, avoid driving at full throttle.
! As
atemporary measure, if the recommen-
ded fuel is not available, you may also use
unleaded petro linemergencies with an
octane ratin gof91RON.
Doin gsor esults in noticeably higher fuel con-
sumption ,and the engin epower output is
noticeably reduced. Avoid driving at full throt- tle.
If no fuel other than petro lwith 91 RON or a
lower grade is available, you should have the
vehicle adapted to run on this fuel at aquali-
fied specialist workshop.
C2 00, C250
! Only refuel using sulphur-free unleaded pet-
rol with at least 95 ROZ ,that conform stothe
European standard EN 228 or EDIN or an
equivalent specification.
You could otherwise impair engin eoutput or
damage the emission control system.
i In some countries, the available petro
lmay
not be sufficiently low in sulphur. This fuel can temporarily produce unpleasant odours,
especially on short journeys. As soon as sul- phur-free fuel (sulphur conten
t<10ppm) is
used for refuelling, the odours are reduced.
C3 00
! Only refuel using super unleaded petro
lwith
at least 98 ROZ, if you want maximum per-
formance from the engine. Alternatively, you
can also use unleaded petro lofatleast
95 ROZ.
As atemporary measure, if the recommended
fuel is not available, you may also use regular
unleaded petro lwith an octane ratin gof
91 ROZ. Doin gsoresults in higher fuel con-
sumption and significantly reduced perform-
ance. Never refuel using fuel with alower
RON.
Fuel of this specification may contain up to
10% ethanol.
Fuel that does not conform to EN 228 or EDIN
51626–1 can lead to increased wear as well
as damage to the engin eand exhaust system.
Additives ! Operatin
gthe engin ewith fuel additives
added later can lead to engin efailure. Do not
mix fuel additives with fuel. This does not
include additives for the removal and preven-
tion of residue build-up. Petro lmust only be
mixed with additives recommended by
Mercedes-Benz.O bserve the instructions for
use in the product description. More informa- tion about recommended additives can be
obtained from any Mercedes-Benz Service
Centre.
Mercedes-Benz recommends that you use fuel
brands that have additives.
The quality of the fuel available in some coun-
tries may not be sufficient. Residue could build
up in the fuel injection system as aresult. In this
case, in consultation with aMercedes-Benz Ser-
vice Centre, the petro lmay be mixed with the
cleanin gadditive recommended by Mercedes-
Benz. Always observe the notes and mixing
ratios specified on the container.
Diesel Fuel grade
G
WARNING
If you mix diesel fuel with petrol, the flash
point of this fuel mixture is lower than that of pure diesel fuel. When the engin eisrunning, Service product
sand capacities
373Technical data
Z

components in the exhaus
tsystem may over-
hea tunnoticed. There is ariskoff ire.
Neve rrefuel with petrol. Neve radd petro lto
diese lfuel.
! Whe
nrefuelling, only us ediese lfue lthat
conform stothe Europea nstandard EN 590 or
is of equivalent quality .Fuelthat doe snot
conform to EN 590 can lead to increase dwear
as well as damag etothe engine and exhaust
system.
! Do not us
ethe following:
R marine diesel
R heating oil
R bio-diesel
R vegetable oil
R petrol
R paraffin
R kerosene
Do not mix such fuels with diese lfue land do
not us eany specia laddit ives. Otherwise,
engine damag emay occur.
Usually yo uwillf ind information abou tthe fuel
grade on the pump. If yo ucannot find the label
on the petro lpum p, ask the filling station staff.
Information on refuelling (Y page 167).
Lo wo utside temperatures
In winter months, diese lfue lw ithani mproved
cold flo wquality is available .InEurope, the
EN 590 standard defines variou sclimate-
dependent temperature categories. Malfunc-
tions can be avoided by refuelling with diesel
fue lthat corresponds to the climati cspecifica-
tions outlined in EN 590. At unusually low out-
sid etemperatures, it is possible that the flow
characteristics of the diese lfue lcould be insuf-
ficient. Accordingly ,diese lfue lfrom warmer
areas may not be suitabl efor operation in colder
climati cconditions.
i Further information on country-specific fuel
properties and fue ltypes with low-tempera-
ture resistance can be obtained from oil com- panies ,e.g. at filling stations. AdBlue
®
Important safety notes AdBlue
®
is aw ater-solubl efluid for the exhaust
ga sa ftertreatment of diese lengines. It is:
R non-toxic
R colourless and odourless
R non-flammable
If yo uopent he AdBlue ®
tank, small amounts of
ammonia vapou rmay be released.
Ammoni avapours have apungent odour and are
particularly irritating to the skin, to mucous
membrane sand to the eyes. You may experi-
ence aburning sensation in your eyes, nose and
throat. You may also experience coughing and
watery eyes.
Do not inhale any ammonia vapours that may be
released .Only fil lthe AdBlue ®
tank in well-ven-
tilated areas.
Lo wo utside temperatures AdBlue
®
freezes at atemperature of approx-
imately -11 †. The vehicle is delivered from the
factory equipped with an AdBlue ®
preheating
system. Winte roperation can thus be guaran-
teed eve nattemperatures below -11 †.
Additives !
Only us
eAdBlue ®
in accordance with ISO
22241. Do not us eaddit ivesw ithA dBlue ®
and do not dilute AdBlue ®
with water. This
may destroy the BlueTEC exhaus tgas after-
treatment system.
Purity !
Impurities in AdBlue ®
(e.g .due to othe rser-
vice products, cleaning agents or dust) lead
to:
R increase demission values
R damag etothe catalytic converter
R engine damage
R malfunctions in the BlueTEC ®
exhaus tgas
aftertreatment system
Assuring the purity of AdBlue ®
is particularly
important with respect to avoiding malfunctions
in the BlueTEC exhaus tgas aftertreatment sys-
tem. 374
Servic
eproducts and capacitiesTechnical data

If AdBlue
®
is pumpedo ut of the AdBlue ®
tank,
e.g. during repairw ork, do not use this fluidto
refill the tank. The purity of the fluidc an no lon-
ger be guaranteed.
Capacities The total capacity of the AdBlue
®
tank may vary,
depending on the vehicle equipment. Model Total capacity
All models
8.5 l
or
24.5 l Engine oil
General notes When handling engine oil, observe the important
safety notes on service products (Y page 371).
The quality of the engine oil is decisive for the
function and service life of an engine. After
extensive tests, Mercedes-Benz approves
engine oils that correspond to the current tech-
nical standard.
Therefore, only Mercedes-Benz approved
engine oils may be used in Mercedes-Benz
engines.
Further information on tested and approved
engine oils can be obtained from any Mercedes-
Benz Service Centre. Mercedes-Benz recom-
mends that you have the oil change carried out
at aq ualifieds pecialist workshop. Mercedes-
Benz approval is indicated on the oil container
by the inscription "MB-Freigabe" or "MB-
Approval "and the corresponding designation,
e.g. MB-Freigabe or MB-Approval 229.51. You can call up an overview of approved engine
oils on the Internet at
http://bevo.mercedes-benz.com by entering
the designation, e.g. 229.5.
The table shows which engine oils have been
approved for yourv ehicle.
Petrol engines: in certain countries, different
engine oils can be used,p rovidedthat the main-
tenance intervals are reduced .For more infor-
mation, please contact aqualifieds pecialist
workshop. Petrol engines MB-Freigabe or
MB-Approval All models
229.5
Diesel engines MB-Freigabe or
MB-Approval All models
228.51, 229.31,
229.51, 229.52 Use only SAE 0W-40 or SAE 5W-40 engine oils
for Mercedes-AMG vehicles.
i If the engine oils listed in the table are not
available, you may add the following engine
oils until the next oil change:
R Petrol engines: MB-Freigabe or MB-
Approval 229.1, 229.3 or ACEA A3
R Diesel engines: MB-Freigabe or MB-
Approval 229.1, 229.3, 229.5 or ACEA C3
This must only be addedo nce and the amount
must not be greater than 1.0 l.
Capacities The following values refer to an oil change,
including the oil filter.
Model Replacement
amount Mercedes-AMG
vehicles
9.0 l
C2
20 d
C2 50 d 6.0 l
All other models
7.0 lServicep
roducts and capacities
375Technical data Z

Additives
!
Do no
tuse any additive switht he engin eoil.
This could damag ethe engine. Brak
efluid G
WARNING
The brak efluid continuously absorbs mois-
tur efromt heair. This result sintheboiling
poin toft hebrak efluid lowering .Iftheboiling
poin toft hebrak efluid is to olow, vapour
pockets may for mwhen th ebrakes are sub-
jected to aheav yload. This would impair brak-
ing efficiency. There is ariskofana ccident.
Hav ethe brak efluid renewed at th eprescri-
bed intervals.
When handlin gbrak efluid ,observ ethe impor-
tan tsafet ynotes on servic eproducts
(Y page 371).
The brak efluid chang eintervals can be foun din
th eS ervic eBooklet.
Only use brak efluid approve dbyMercedes-
Benz in accordanc ewithM B-Freig abe or MB-
Approval 331.0.
Information about approve dbrak efluid can be
obtained at any qualified specialis tworkshop or
on th eInterne tat
http://bevo.mercedes-benz.co m.
i Have the brake fluid regularly replaced at a
qualified specialist workshop in accordance
with the replacement intervals and the
replacement confirmed in the Service Book-
let. Coolant
Importan tsafety notes G
WARNING
If antifreeze comes into contact with hot com- ponents in the engine compartment, it may
ignite. There is arisk of fire and injury.
Let the engine cool dow nbefore yo utop up
the antifreeze .Make sur ethat antifreeze is
not spilled next to the filler neck. Thoroughly clea
nthe antifreeze from components before
starting the engine.
! Only ad
dcoolant that has bee npremixed
with the desire dantifreeze protection. You
coul dotherwise damag ethe engine.
Furthe rinformatio noncoolants can be found
in the Mercedes-Benz Specifications for Ser-
vice Products, MB Specifications for Service
Products 310.1, e.g. on the Internet at
http://bevo.mercedes-benz.com .Orcontact
aq ualifie dspecialist workshop.
! Always use
asuitabl ecoolant mixture, even
in countries where hig htemperatures prevail.
Otherwise ,the engine cooling system is not
sufficiently protected from corrosion and
overheating.
i Have the coolant regularly replaced at a
qualified specialist workshop and the replace- ment confirmed in the Service Booklet.
Comply with the important safety precautions
for service products whe nhandling coolant
(Y page 371).
The coolant is amixture of water and anti-
freeze/corrosion inhibitor. It is responsible for
the following:
R anti-corrosion protection
R antifreeze protection
R raising the boiling point
If antifreeze/corrosion inhibito rispresent in the
correct concentration, the boiling point of the
coolant during operation will be approximately
130 †.
The antifreeze concentrate/corrosion inhibitor
concentration in the engine cooling system
should:
R be at least 50%. Thi swillp rotect the engine
cooling system against freezing dow nto
approximatel y-37 †.
R not excee d55% (antifreeze protection down
to -45 †). Hea twillo therwise not be dissipa-
ted as effectively.
Mercedes-Benz recommends an antifreeze/
corrosion inhibito rconcentrate in accordance
with MB Specifications for Service Products
310.1.
i Whe
nthe vehicle is first delivered, it is filled
with acoolant mixtur ethat ensures adequate
antifreeze and corrosion protection. 376
Service products and capacitiesTechnical data