automatic transmission fluid MITSUBISHI 3000GT 1991 User Guide

37A-24
STEERING - Power Steering Gear Box
/Oil seal
Back-up washer13A0181L
GuideNeedle roller
bearmg13R0547
MB990927-01
&
13R0378
Vent hole
SERVICE POINTS OF REASSEMBLYM37PHAW
34. INSTALLATION OF BACK-UP WASHER / 33. OIL SEAL(1) Apply a coating of the specified fluid to the outside of
the oil seal.
LJSpecified fluid: MITSUBISHI PLUS
ATF/Automatictransmission fluid “DEXRON” or
“DEXRON II”
(2) Using a tool, press the back-up washer and the oil seal
into the rack housing to the specified position (whereIthe upper surface of the press-in guide coincides with
the stepped part of the press-in tool).
32. INSTALLATION OF NEEDLE ROLLER BEARINGI(1) Apply specified fluid to housing, bearing and oil seal
Ipress fitting surface.
ISpecified fluid: MITSUBISHI PLUS ATF/Automatictransmission fluid “DEXRON” or
I“DEXRON II”(2) Press fit needle roller bearing.
CautionIPress fit straight as valve housing is aluminium.
31. INSTALLATION OF BALL BEARINGPress fit ball bearing.
28. INSTALLATION OF OIL SEAL
/ 27. O-RING
(1) Apply a coating of the specified fluid to the outside of
the oil seal and O-ring.
Specified fluid: MITSUBISHI PLUS
ATF/Automatictransmission fluid “DEXRON” or
“DEXRON II”
(2) Press fit oil seal until it touches rack bush end.
26. INSTALLATION OF RACK(1) Apply a coating of multipurpose grease to the rack teeth
face.
Caution
Do not close the vent hole in the rack with grease.13K583(
TSB Revision

STEERING - Power Steering Gear Box37A-25
Back-up washer1360147
(2) Cover rack serrations with special tool.
(3) Apply specified fluid on special tool.
Specified fluid: MITSUBISHI PLUS
ATFIAutomatictransmission fluid “DEXRON” or
“DEXRON II”(4) Match oil seal center with rack to prevent retainer
spring from slipping and slowly insert rack from power
cylinder side.
Vinyl tape
Rack bushing
136014613K687
Seal rings
MB99131 7
Tapered
side13A0313
25. INSTALLATION OF RACK BUSHINGWrap the rack end with vinyl tape, apply a coating of the
specified fluid, and then install the rack bushing and rack
stopper.
Specified fluid:MITSUBISHI PLUS
ATF/Automatictransmission fluid “DEXRON” or
“DEXRON II”
CautionDo not allow oil seal retainer spring to slip out.
23. INSTALLATION OF CIRCLIPInsert circlip to rack stopper hole through cylinder hole. Turn
rack stopper clockwise and insert circlip firmly.
CautionInsert circlip to rack stopper hole while turning rack
stopper clockwise.20. INSTALLATION OF SEAL RINGS
/ 19. PINION AND
VALVE ASSEMBLY
(I) When installing seal rings, press firmly into valve
groove. Apply specified fluid.
Specified fluid: MITSUBISHI PLUS
ATF/Automatictransmission fluid “DEXRON” or
“DEXRON II”
NOTEBecause the seal rings expand at the time of installa-
tion, use the special tool to compress the seal rings so
that they are well seated.
ITSB RevisionI