seat adjustment MITSUBISHI ECLIPSE 1990 Service Manual

REAR AXLE- Viscous Coupling Type Limited Slip Differential3-a
DIFFERENTIALROlEAM
The differential uses lower torque bearings and
lower torque oil seals to improve power perform-
ante and fuel consumption.
For faster differential cooling and higher reliability
during high speed operation, a differential carrier
with cooling fins has been adopted.For better serviceability, spacers for adjustment of
final drive gear backlash have been inserted
be-tween the side bearing outer race and gear carrier.
A speed difference responsive type viscous
cou-
pling type limited slip differential which provides
outstandingperformance during operationon a
Side gearPinion gearDifferential coverQ./\Side bearing spaceifferential case
VISCOUS COUPLING TYPE LIMITED SLIP DIFFERENTIALRWEBAAWhile the conventional mechanical type limited slip
differential uses a cam (differential pinion shaft) and
disc equipment
compo.sed of a friction plate, disc
and spring seat in limiting the differential, theviscous coupling type limited slip differential limits
the differential by use of a viscous coupling equip-
ment consisting of outer and inner plates and
silicone oil.
Front wheel
Center differential
’ (viscous coupling)Rear wheel
Limited slip differential
assembly
Front differential, I
TDifferential
Differential limiting section
(viscous coupling)11KmI66
L.-

PARKING BRAKE
BRAKES- Parking Brake5-7
ROSDMBThe parking brake is of the mechanical rear wheel
braking type.The parking brake
cable is of the V-type and is
The parking brake is offset toward the driver’s seataccessible for adjustment through the service hole
provided in the floor console.
from the vehicle centerline for greater ease of
operation.CONSTRUCTION DIAGRAM
Y14AO391
<4WD>14A0626

BODY- Door Mirrors .23-27
DOOR MIRRORSIPIKhAC
.i~e large-size Talbot mirrors are attached on the
front doors that smoothly blend into the body
styling. They also contribute to the reduced aerody-
namic drag.
ELECTRIC REMOTE CONTROL MIRRORThe electric remote control mirror is a two-motor
type mirror for independent vertical and horizontalNote that the electric remote control mirror switch
angle
adjustment The mirror system consists of ais the centralized-control type and is installed on the
mirror assembly, actuator assembly, frame, body,door trim on the driver’s seat side. The one switch
etc.can be used to adjust the direction settings (to the
left and right, and up and down) of the left and right
_ mirrors.
/
/
l Pivo; screwFrameBody*Adjustment nutleAo398
‘Motor
B
NOTE
IThe &ark l denotes component parts of actuator assembly.
I

23-30
FRONT SEATS
BODY - Front Seats / Rear Seat
Rz3The front seats are sporty
highback seats with an
integral headrestraint that hold your body in place oncurves. The driver’s seat on the higher grade model
is provided with the lumbar support that is
adjust-able in four positions.The.driver’s seat slides 260 mm (10.2 in.) I230 mm
(9.1 in.) on the front passenger’s seat].
The front passenger’s seat can be folded down to
ensure easy egress/ingress for the rear-seat pas-
sengers.
Seatback
2
Adjustment mechanisms
1. Sliding adjustment2. Reclining adjustment3.Lumbar support adjustment(driver’s seat only)
4.
Folddown mechanism
(on front passenger’s seat only)
REAR SEATR23u9ABThe rear seat is for two passengers, having low
seatback and contoured seat cushions. The seat-back can be folded down to give an additional
luggage c5mpartment space.There are cushion pockets at the center, into which
the rear seat belt buckles are stored when the
seatback is folded down.