service indicator NISSAN 300ZX 1984 Z31 Automatic Transmission Workshop Manual
[x] Cancel search | Manufacturer: NISSAN, Model Year: 1984, Model line: 300ZX, Model: NISSAN 300ZX 1984 Z31Pages: 99, PDF Size: 3.09 MB
Page 6 of 99
GENERAL SERVICE NOTICE
Oil Channel
Oil channels which connect components are
located in the
areas shown below.
OIL CHANNELS IN OIL PUMP
Oil pump cover ride
11 pump suction hole Cooler in pressure
011 pump discharge hold LTorque converter in pressure
Oil pump housing ride
ne oressure
SAT499
SAT500
OIL CHANNELS IN TRANSMISSION CASE
Front face rlde
Front & 0 D lubrication Forward clutch (Rear1
gh-reverse clutch
011 pump discharge hole
Direct clutch apply &OD sew0 release pressure
0 0 indicator pressure
SAT501
Lower face side
Governor pressure (To control valve)
Governor feed
(From control
valve)
LOW & reverse brake
High-reverse clutch IFrontl pressure SAT502
ii
OIL CHANNELS IN O.D. CASE
011 pump suction hole Hlgh-reverse clutch (Front1 pressure
Forward clutch
(Rear) Oresure
ront & 0 D lubrication
SAT645 In regards to oneway plug. refer to page AT-32.
AT-6
Page 17 of 99
ON-VEHICLE SERVICE
Overdrive Control Sy:
O.D. CANCEL SWITCH 81 O.D.
INDICATOR LAMP
Inspection
Power shift switch
SAT716
O.D. CANCEL SOLENOID
Location
SAT619
?m (4N71B) (Cont'd)
Inspection
Confirm that clicking sound
is heard when power is
applied.
w SAT620
AT-I 7
Page 61 of 99
ASSEMBLY
290 (1 142)
29 5 (1 161)
30 0 (1 1811
30 5 (1 201)
31 0 (1 220)
Vacuum diaphragm rod selection
31932-XO103
31932-X0104
31932-XOlOO
31932-X0102
31932-XOlOl
Measured depth
“L” mm (in)
Under 25 55
(1 0059)
25 65
- 26 05
(1
0098 - 1 02561
2615-2655
(1 0295 - 1 04531
26 65.27 05
(1 0492
- 1 0650)
Over 27 15
(1 0689)
Rod length
mm (in) Part number
41 Install vacuum diaphragm.
Make sure that vacuum diaphragm rod does not
interfere with side plate
of control valve.
42 Install downshift solenoid, O.D. cancel sole-
noid, O.D. indicator switch and lock-up sole-
noid.
LO D csncei rolenoid SAT740
43. Install inhibitor switch Check for proper
operation in each range using
a circuit tester.
Refer to On Vehicle Service.
Y li
SAT082
44 Before installing oil pan, check parking pawl
engagement Make wiring connections to shift
switches and low temperature sensor
(E4N71B
automatic transmission models)
45. Install oil pan with new gasket.
-
AT-61