warning NISSAN 300ZX 1984 Z31 Body Workshop Manual
[x] Cancel search | Manufacturer: NISSAN, Model Year: 1984, Model line: 300ZX, Model: NISSAN 300ZX 1984 Z31Pages: 77, PDF Size: 1.97 MB
Page 6 of 77
BODYENDANDDOOR
When removing and installing hood or back door, place a cloth or other padding on hood or back door
corners to avoid scratching vehicle body
When removing clip or fastener,
refer to CLIP & FASTENER.
Apply sealing compound where necessary when installing parts
Front End
Hood adjustment Adjust at hinge portion
Hood lock adjustment After adjusting, check hood lock control operation Apply a coat of grease to
hood locks engaging mechanism
Hood opener
Do not attempt to bend cable forcibly. Doing so increases effort required to unlock hood.
Bumper fascia.
It is made of plastic, so do not use excessive force and take care to keep oil away from it
When adjusting or removing/installing hood or removing/installing hood switch, check theft warning sys-
tem operation
WARNING:
a. Be careful not to scratch hood stay when installing hood. A scratched stay may cause gas leakage.
b. The contents
of the hood stay are under pressure. Do not take apart, puncture, apply heat or allow fire
near It.
Bumper shock absorber inspection
1. Check shock absorber for oil leakage, cracks or deformation
2. Function of shock absorber,
(1) Place vehicle in front of a wall
(2) Place a jack between bumper and wall, jack is positioned squarely with bumper directly in line with
(3) Apply pressure to compress shock absorber at least 10.0 mm (0.394 in).
Use a jack with capacity of more than 600 kg (1,323 Ib).
(4) Make sure bumper returns to its original position when jack is retracted Replace if necessary
CAUTION:
It IS not recommended to confirm proper installation by driving into walls or other barriers as this could
cause personal injury
or damage to the vehicle.
When replacing shock absorbers, make sure they
are of the same type and rating, and manufactured by the
same maker
Apply parking brake and place tire stoppers securely.
shock absorber
to be checked
BF-6
Page 8 of 77
BODY END AND DOOR
Rear End
Back door adjustment. Adjust at hinge for proper back door fit
Lock Adjust lock
so that it is in the center of the striker. After adjusting, check back door lock opera-
tion Bumper fascia
It is made of plastic, so do not use excessive force and take care to keep oil away from it.
When adjusting or removing/installing back door or removing/installing back door lock system, check
theft warning system operation.
WARNING:
a. Be careful not to scratch back door stay when installing back door. A scratched stay may cause gas
leakage.
b. The contents of the back door stay are under pressure. Do not take apart, puncture, apply heat or allow
fire near
it.
BF-8
Page 12 of 77
BODY END AND DOOR
Theft Warning System
. When adlustlng hood, front door, back door or removing & installlng them or swltches, check theft warn-
ing system operation.
Back dooiunlkk witch
Door wttch IF89 31 k door Lev cylinder mpcr w1Ch lFig 8)
P-rdmr lkk XCNI~O~ (Fig 61 Sack dwr witch (Fig 71
Dmr lock wnuh Doorunlock watch Door Lev cylinder lamper witch (Fig 4)
Power door lock witch (Fig 51
&rubcontrolamp (Fig 2)
clew to operate lead switch 1
Door wside handle
power door lhk ktllatW IFlg 61
Po-r dmr lock
Door match IFig. 3)
I
Power door lock wttch (Fig 51
Brk door witch (Fig. 7)
I Back dmr lod;
Back doM unlock Smtch & key ylindn 3mw wnch (Fig 81
Back dmr unlock witch IUW MgWflC lever to operate lead switch I
key cylinder IS removed 1
BF-I 2
Page 13 of 77
BODY END AND DOOR
Theft Warning System (Cont'd)
SYSTEM OPERATION
If the ignition key is set in the "ACC" position in the course of START to ARMED or in the ARMED state
shown in this flow chart, the system operation is cancelled
the key cylinder lDoor fully
1 I Condition
0 Judgment
IAWSI and drwer rider, back door or
Indicator lamp goes YES
IAISISI and drtver
BF-13
Page 14 of 77
BODY END AND DOOR
Theft Warning System (Cont’d)
Indicator lamp goes
L
BF-I 4
Page 15 of 77
BODY END AND DOOR
Theft Warning System (Cont’d)
1
.+a
I
Door open7 or IAwit. back driver door) rode.
NO
NO<>* (Assort. Key cylinder driver drawn sidi’, or back door)
YESD
@ c-
Alarm starts
I
Timer in operation 2-4m,r
Unlocked with key
during timer
operation7
IAwst.
driver ride. =:::-:- or back door)
Alarm stops
Alarm stops
Starter remains OFF
BF-15
Page 16 of 77
BODY END AND DOOR
Theft Warning System (Cont'd)
@
t
10
I I
-8
(Assist, driver ride.
1
Key cylmder drawn
(Assist, driver ride. NO
@
@
@
Alarm actuated by opening hood
Alarm actuated by opening
any door
(Driver, =tist side. or back doorl
Alarm actuated by drawing
out any key cylinder
(Driver. assist side. or back door)
BF-16
Page 17 of 77
BATTERY .A,. (Via fusible link) (Theft warning system power l0"reel THEFT WARNING INDICATOR LAMP 10A Iln combination meter -
FUSE^^^^^ A ACC or ON
SWlTCl
IGNITION SWITCH 1 ST I
IGNITION SWITCH ON or ST
STARTER MC
BATTERY (Via fusible link1
BATTERY (Via fusible link1
To horn switch
TO llghtlng system
A
HEADLAMP RH
HEADLAMP LH
TO
lighting
system
POWERDOORLOCKACTUATOR gg
2 a A 0 U I-
;;
m
2 0 DOOR SWITCH IAsrirt) z z U
2
t UI I I-
R
H -I
DOOR SWITCH IDrwerI
I
(Via fusible
1
I I I I POWER DOOR LOCK SWITCH
Page 18 of 77
BODY END AND DOOR
Theft Warning System (Cont'd)
Operation chart
Driver de door SW Auin lids door SW Back dmr SW Wood SW
0
0
0
BF-18
Page 19 of 77
BODY END AND DOOR
Theft Warning System (Cont'd)
0
I-
x 0 x x
x
-l-l-l-l -
I
---r--E
e
x
x
x
x
x
__-
x
x
x
-
BF-19