speedometer NISSAN PATROL 1998 Y61 / 5.G Transfer Workshop Manual

5. Remove speedometer drive gear and oil gutter.
6. Remove snap ring from 2-4 shift rod.
7. Check front drive sprocket end play.
a. While holding front drive sprocket forward as far as it will go,
measure distance ``A'' between rear surface of front drive
sprocket and front surface of 2-4 coupling sleeve.
b. While holding front drive sprocket back as far as it will go,
measure distance ``B'' as same as step a.
c. Determine front drive sprocket end play to be used by the fol-
lowing equation.
Front drive sprocket end play = A þ B
Standard:
0.20 - 0.35 mm (0.0079 - 0.0138 in)
+If not within speci®cation, disassemble and check contact sur-
face of gear to hub, washer, bushing, needle bearing and shaft.
8. Shift 2-4 coupling sleeve to 2WD position.
SMT106B
SMT107B
SMT108B
SMT110B
DISASSEMBLY
TF-14

h. Install snap ring to 2-4 shift rod.
i. Install speedometer drive gear and oil gutter.
j. Apply gear oil to each part in center case.
9. Apply sealant to mating surface. Set center case assembly onto
front case, then tighten bolts.
10. Install front and rear companion ¯anges and center brake com-
ponents.
SMT107B
SMT106B
SMT171B
ASSEMBLY
TF-32