reverse NISSAN TIIDA 2007 Service Repair Manual

WW-68
< ON-VEHICLE REPAIR >
FRONT WASHER NOZZLE AND TUBE
Blow air in the injection direction, and make sure that air flows only
one way. Make sure that the reverse direction is not possible.
AdjustmentINFOID:0000000001404273
 Adjust spray positions to match the positions as shown.
 Insert a suitable tool into the nozzle hole and move up/down and left/right to adjust to the specified spray
position.
SKIB5665E
1. Windshield A. 395 mm (15.55 in) B. 216 mm (8.50 in)
C. 100 mm (3.94 in) D. 85 mm (3.35 in) E. Black mask
F. 303 mm (11.93 in) G. 212 mm (8.35 in) H. 249 mm (9.80 in)
I. Center of windsheild J. Spray pattern area K. 286 mm (11.26 in)
LKIA0938E

WW-76
< ON-VEHICLE REPAIR >
WIPER AND WASHER SWITCH
WIPER AND WASHER SWITCH
Exploded ViewINFOID:0000000001366672
NOTE:
The LHD model shown, RHD model similar.
Removal and InstallationINFOID:0000000001366673
REMOVAL
1. Remove the steering column cover. Refer to IP-10, "Component Parts".
2. While pressing in on the pawls, pull the wiper and washer switch straight out to disconnect it from the
switch base.
INSTALLATION
Installation is in the reverse order of removal.
1. Wiper & washer switch A. Pawl
JPLIA0311ZZ

WW-78
< ON-VEHICLE REPAIR >
REAR WIPER MOTOR
2. Clean pivot area as shown. This will reduce the possibility of
wiper arm looseness.
3. Install wiper blade.
4. Install wiper arm so that the arm rests in the stopper and tighten
rear wiper arm nut.
5. Install wiper arm cover.
REAR WIPER MOTOR
Removal
1. Remove wiper arm. Refer to WW-77, "Removal and Installation".
2. Raise arm cap.
3. Remove the rear wiper motor nut, remove the rear wiper arm and blade.
4. Remove the back door lower finisher. Refer to INT-18, "
Removal and Installation".
5. Disconnect the rear wiper motor connector (B).
6. Remove the bolts (A) and remove the rear wiper motor (1).
Installation
Installation is in the reverse order of removal.
CAUTION:
Do not drop the wiper motor or allow it to contact other parts.
AdjustmentINFOID:0000000001366676
REAR WIPER BLADE POSITION ADJUSTMENT
SEL024J
LKIA0789E

REAR WASHER NOZZLE AND TUBE
WW-81
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
MA
B
WW
N
O
P
Installation is in the reverse order of removal.
NOTE:
Inspect rear washer nozzle for proper spray pattern, adjust as necessary. Refer to XX-XX, "*****"
.
AdjustmentINFOID:0000000001366679
 Adjust the washer nozzle (1) to specification (A) using suitable tool
as shown.
 Washer nozzle (1)
 Washer spray area (A)
 Black print area (B)
 Wiping area edge (C)
 30 mm (1.18 in) (D)
 161 mm (6.34 in) (E)
AWLIA0142ZZ
AWLIA0143ZZ