OPEL FRONTERA 1998 Workshop Manual

8D–408 WIRING SYSTEM
Step Action Yes No
The control unit makes lock/unlock response once with interval of
one second.
Is the response complete?
The control unit makes lock/unlock response three times with
interval of one second.
Is the response complete? 12
13Finished
Finished—
—
Step Action Yes No
1. Open the driver’s side door.
2. Turn the starter switch off.
Is the action complete?
Turn the starter switch to ACC position and then off three times
within five seconds after step 1.
Is the action complete within five seconds?
Close the door and then open it two times within ten seconds after
step 2.
Is the action complete within ten seconds?
1. Turn the starter switch to ACC position and then off.
2. Close the door and then open it.
NOTE: This step must be performed within ten seconds after step
3.
Is the action complete?
The control unit makes lock/unlock response twice as many the
number of registered ID code with interval of two seconds. (In case
of no registered code, the response is made ten times.)
Is the response complete? 1
2
3
4
5Go to Step 2
Go to Step 3
Go to Step 4
Go to Step 5
Finished—
Finished
Finished
Finished
—
This procedure checks how many kinds of ID code are
registered.
Step Action Yes No
Open the driver’s side door.
Is the action complete?
Lock the door and then unlock it three times within ten seconds
after step 1.
Is the action complete within five seconds?
Close the door and then open it two times within ten seconds after
step 2.
Is the action complete within ten seconds? 1
2
3Go to Step 2
Go to Step 3
Go to Step 4—
Finished
Finished Anti–theft horn, as an answer back function for the
transmitter operation, changes from available into
unavailing or from unavailing into available by this
procedure.

WIRING SYSTEM 8D–409
Step Action Yes No
1. Lock the door and unlock it three times.
2. Close the door and then open it.
NOTE: This step must be performed within ten seconds after step
3.
Is the action complete?
Answer back mode changes.
Is this step complete?
The control unit makes lock/unlock response once with interval of
one second.
Is the response complete?
The control unit makes lock/unlock response three times with
interval of one second.
Is the response complete? 4
5
6
7Go to Step 5
Go to Step 6
Finished
FinishedFinished
Go to Step 7
—
—
1. Remove and install the control unit.
Refer to Anti–theft & Keyless Entry Control Unit
Removal and Installation in this section.
2. Register ID code.
Refer to ID Code Registration in this section.
3. Check that the keyless entry system works normally.
1. Prepare a new transmitter.
2. Register ID code.
Refer to ID Code Registration in this section.
3. Check that the keyless entry system works normally.
1. Remove a screw to remove the cover.
2. Remove the batteries.
3. Set the new batteries into the transmitter.
4. Install the cover to the transmitter.
5. Check that the keyless entry system works normally.

D08RW722
3C-3910
H-42
0.5
B/R0.5
B/R 0.5
B/R
B
D
C
A
FENDER-RH
H-104
M-10
2
A
I 0.5
L/Y0.5
L/Y0.5
L/Y
1M-109
H-103
H-9
0.5
LG/W0.5
LG/W
0.5
LG/W0.5
LG/W 0.5
LG/W0.5
R/W
SPEEDO-
METER
RESET
SWTACHOMETERENGINE
COOLANT
TEMPERATURE
GAUGEFUEL
GAUGEOIL
PRESSURE
GAUGE FUSE C-15
3M-10125
H-9
11
H-10
VEHICLE
SPEED SENSOR
I-10
0.5
Y/B0.5
Y/B0.5
Y/B
1
E-191 4
H-24
11
H-6
I-10
2H-8
PCM
(D7)CRUISE CONTROL
UNIT(9)0.5
B/R
15H-9
PCM
(C10)9
I-9
0.5
Y/R
14
H-2520
I-10
ENGINE
COOLANT
TEMPERATURE
UNIT
0.5
Y/G0.5
Y/V0.5
Y/B
1
E-217 19
H-9
10
H-6
I-10
OIL
PRESSURE
UNIT
8I-10METER
ODO/TRIP
METER

D08RW723
B
C
D
J
E
5 18 15105
2 25
4 21
163
5 1
19 156
VOLT
METERC-10 10A
METER, GAUGE
CHECK
TRANS.A/T OIL
TEMP.
18
C-39 H-16I-9
PCM
(A13)PCM
(A11)PCM
(A10)PCM
(A14)PCM
(A9)
0.5
V0.5
P/W0.5
P/G0.5
O/B0.5
O/L 0.85
B/PH-26
I-9 0.5
L/Y0.5
L/Y0.5
L/Y3.0
B/Y STARTER SW
(IG1)
0.3
Y/G
0.85
B/P
FENDER-RH
I-10
H-25I-9
H-9I-9
H-9I-9
H-9I-9
H-9I-9
H-24 FUEL MIL POWER WINTER
METER
MIL:MALFUNCTION INDICATOR LIGHT

D08RW725
G
H
FE
16
14 CRUISE
SETCRUISE
MAINAIR BAG ABS 4WD BRAKEEHCU:ELECTRONIC HYDRAULIC CONTROL UNIT
OIL
PRESSURE
CRUISE
CONTROL
UNIT(14)0.5
B/OI-9
H-2617
15
CRUISE
CONTROL
UNIT(13) 0.5
GR/LI-9
H-2624
2
SDM
(7) 0.5
W/RI-9
H-6216
2
EHCU
(16)
OIL PRESSURE
SWBRAKE
FLUID
SWPARKING
BRAKE
SW
0.5
YI-10
H-1618
19
4WD
CONTROL
UNIT(19)/
FRT
AXLESW(2)
OR
4WDSW(1)0.5
LGI-9
H-2722
22
12
1 0.5
LB
0.5
LB0.5
B/P
0.5
B0.5
B/P0.5
B/P
0.5
LBI-9
H-9
H-6
E-14
1
8 9
213
1
FENDER-RH0.5
B/PI-9
H-16
C-15
C-39 C-15H-26
B-27
METER

D08RW 727
F
G
H
6
10
AC GENERATOR
(L)ILLUMINAITON
CONTROLLER(3)TAIL RELAY
(4)TURN SIGNAL/
LIGHT SWREAR
FOG LIGHT
BODY-RH 0.85
W/G
0.85
W/GI-9
H-16
1
H-38
0.5
R/G30
0.3
B 0.85
G/B 0.85
G/R0.85
P/B
1.25
B
1.25
B20
I-9
H-27
B-191
6
28
10
I-10 H-277
14
I-9 CHARGE METERTURN
-LHTURN
-RH0.5
BR/Y
10
1
I-10 H-27
REAR
FOG
LIGHT ODO/
TRIP
METER
METERI-9 I-9 H-16
H-27

D08RW729
IJ
0.3
Y/G 0.5
Y/R
0.5
Y/R
BODY-RR
ALARM&RELAY
CONTROL UNIT FUEL
TANK
UNIT
0.5
B
1.25
B 0.5
B/P0.3
Y/BR
0.3
Y/BR
0.3
Y/BR
7
17 144 1
12
B-66B-7
DIMMER•
PASSING
SW FUSE F-4
0.85
R/Y 0.85
R/L
14 15 13
9 I-10 I-10 H-16
H-9 HIGH
BEAM
R-4
F-5
H-332
F-518
H-46
13
H-33
F-5
H-33
H-46
0.5
Y/R
FUEL
TANK
UNIT
0.5
B/P0.3
Y/BR
0.3
Y/BR
179 4 1
19
F-5
H-332
F-57
H-33 (SOUTH AFRICA)
F-5
H-33
H-46

D08RW 730
BODY-LH BODY-LH TAIL RELAY
(4)
(W/O SUNROOF) STARTER SW
(ACC)AMBIENT TEMPERATURE
SENSOR
0.5
B
2.0
B 2.0
B 2.0
B 0.5
P/G0.5
G/R0.5
G/R
0.5
O/G0.5
O/G3.0
L/B
0.5
P/G 0.5
P/L0.5
P/L
0.5
P/G 0.5
P/L0.85
B
4
H-21 4 6
H-21 H-21H-21
H-7
C-9L-5
5
8
H-212
3
H-78
2
C-91L-5
4 L-53
L-51 1
H-213
L-5
B-2 B-2
MULTI METER
C-11 10A
AUDIO(ACC), MIRROR

D08RW731
3C-3910
H-42
0.5
B/R0.5
B/R 0.5
B/R
B
D
C
A
FENDER-RH
H-104
M-10
2
A
I 0.5
L/Y0.5
L/Y0.5
L/Y
1M-109
H-103
H-9
0.5
LG/W0.5
LG/W
0.5
LG/W0.5
LG/W 0.5
LG/W0.5
R/W
SPEEDO-
METER
RESET
SWTACHOMETERENGINE
COOLANT
TEMPERATURE
GAUGEFUEL
GAUGE FUSE C-15
3M-10125
H-9
11
H-10
VEHICLE
SPEED SENSOR
I-10
0.5
Y/B0.5
Y/B0.5
Y/B
1
E-191 9
H-24
11
H-6
I-10
2H-8
PCM
(D7)CRUISE CONTROL
UNIT(9)0.5
B/R
15H-9
PCM
(C10)9
I-9
0.5
Y/R
14
H-2520
I-10
ENGINE
COOLANT
TEMPERATURE
UNIT
8I-10METER
ODO/TRIP
METER