Peugeot Partner VU 2001 Owner's Guide

1
11
Maintenance intervals If your vehicle is used in particular- ly harsh conditions, it is necessaryto select the maintenance sche-dules for arduous conditions (seethe Maintenance Guide) whichconsist of more frequent services.Note : if the maximum time bet-
ween two oil changes is reachedbefore the mileage is up, the span-ner symbol lights. To change the maintenanceintervals :
- Switch off the ignition. - Press and hold down button
1.
- Switch on the ignition
- The distance remaining until the next service flashes.
- Release the button immediately.
- The maintenance interval is dis- played.
- Pressing button 1briefly allows
the maintenance intervals to be alternated - When the desired maintenance
interval is displayed, press but-ton 1for ten seconds to validate
(the selected maintenance inter-val will flash for ten seconds).
Release the button to validatewhen the display stops flashing. Resetting the maintenance indi- cator to zero
Your dealer will perform this ope-
ration after each service. However,if you intend to service the vehicleyourself, the procedure for reset-ting the maintenance indicator isas follows:
- Switch off the ignition.- Press and hold down button 1.
- Switch on the ignition.
- The distance remaining until the next service flashes.
- Holdbutton 1down for ten
seconds.
- The display will read Ò=0Óand
the spanner will disappear.
29I-14INSTRUMENT PANEL*
* According to model or country.

B
1 - The clockcan be set, with the ignition on and the engine not running , by pressing button B for more than three
seconds; the hour will start to flash.
Changing the time 2 - Short press on B, allows the time to be changed slowly.
If the button is not pressed for five seconds : The hour is memorised, the minutes flash. Long press, rapid scrolling
Changing the minutes 3 - Short press on B, allows the time to be changed slowly.
If the button is not pressed for five seconds : The minutes are set. Long press, rapid scrolling
Note : the clock display comes on when the driverÕs door is opened and goes out one minute after it is shut. The
clock display goes off after 10 minutes if the driverÕs door remains open.
32I-14INSTRUMENT PANEL*
Digital clock
* According to model or country

B
Adjust with theengine running and the sidelamps
on by pressing the control B.
- Press the button successively : the level of lighting
of the instrument panel changes progressively.
- Keep the button pressed down : the level of ligh-
ting of the instrument panel changes rapidly
33I-14INSTRUMENT PANEL*
Dashboard lighting
* According to model or country

Rear fog lamp See ÒSIGNALLINGÓ.ABS system See ÒBRAKESÓ.Diesel engine preheating warning lamp
See ÒSTARTING THE ENGINEÓ.
Left direction indicators See ÒSIGNALLINGÓ.
Right direction indicatorsSee ÒSIGNALLINGÓ.
34I-15WARNING LAMPS *
All the direction indicator lights flash at the same time when the hazard warning signal is operated.
Dipped beam See ÒSIGNALLINGÓ. Main beamSee ÒSIGNALLINGÓ.
* According to specification or country

Electronic key warning lamp Lights up when switching
on ignition if the key is not recogni- sed
* Depending on version or country.
35I-15WARNING LAMPS *
Minimum coolant fluid level warning lamp If the warning lamp lights
up, it is imperative to stop the vehicle. Check the level and takethe precautions detailed in chapter
ÒLEVELS AND CHECKSÓ).
Battery charge warninglamp Should not be on when the engine is running. If it
comes permanently on, contact
your nearest approved Dealer.
Imperative stopwarning lamp Lights up at the same time as ano-
ther visual warning or if the maxi-mum permissible coolant fluid tem-perature is reached.
Engine oil pressurewarning lamp If it lights up while you are
driving, stop the engine, check the
level, (See ÒLEVELS ANDCHECKSÓ). If it remains lit despite the level being correct, contact your nearest
approved Dealer. Warning lamp for hand-brake and for brakefluid level Indicates that the brake
is applied or incorrectly released. Also that the brake fluid level is
insufficient. See ÒBRAKESÓ,
ÒLEVELS AND CHECKSÓ . The warning lamp may also indica- te a malfunction of the electronicbraking distribution.
Engine operation war-ning lamp (autodiagno-sis)
If it flashes or lights up, this indi-cates a malfunctioning of either theinjection, ignition or emissioncontrol systems (depending oncountry). Quickly consult your nearest
approved dealer.
AIRBAG operation war-ning lamp
See ÒTHE AIRBAG SYSTEMÓ. Doors open warninglamp Lights up when swit- ching on ignition.
Goes out when all the doors are
closed correctly.

Direction indicators Left: move the stalk downwards. Right: move the stalk upwards.
To signal a change of direction, move the stalk past the point of resistance. The signal will cancel automatically as the steering wheel returns.
36I-16SIGNALLING
Horn Press the end of the stalk. Headlamp flash Flick the stalk gently towards you.
It is possible to flash the headlamps when the engine is switched off. Hazard warning This operates all the direction indicators at the same time.
Use it only in case of danger,for an emergency stop or in exceptional dri-
ving circumstances.
It can also operate when the ignition is off.The direction indicators will not operate if the vehicle is driven with the hazard warning lights on.

A
All lights switched off
37I-16SIGNALLING *
LIGHTING CONTROLS (Ring A)
Turn ring Ain the direction of the arrow.
Side lights
Your instrument panel lights.
Turn ring Ain the direction of the arrow.
Dipped beam / main beam
Pull the stalk fully towards you to switch between dipped beam/main beam. Lights on buzzer
It operates when a front door is opened with the ignition off, to indicate that the headlamps are still on. It stops when the door is closed, the headlamps
are switched off or if the ignition is switched on.
Timed illumination of the headlamps
Immediately after switching off ignition, pull the control stalk towards you : the headlamps will come on and then go out automatically after a minute.This will help you, for example, to find your way out of a poorly lit car-park. * According to specification.

B
Rear fog lamp off
38I-16SIGNALLING*
Rear fog lamp
Turn ring Bin the direction of the arrow.
Rear fog lamp
The warning light is lit. The rear fog lamp can operate when the dipped beam or the main beam is on. It switches off automatically when the headlamps are switched off.
Reminder
The rear fog lamp should only be used in conditions of fog or snow.
* According to specification.

Electrical adjustment*
On the dashboard to the left of the driver.
Position 0 :driver alone or with 1 passenger.
Intermediate Ñ : driver + 2 passengers.
Position 1 : driver + 4 passengers.
Position 2 : driver + 4 passengers and luggage in the boot.
Position 3 : driver alone + maximum load at the rear.
40I-17VISIBILITY
Adjusting the headlamps * It is recommended that you adjust the beam setting according to the weight and distribution of the load in the vehicle. This system allows you to avoid dazzling other road users, and also to ensure optimum beam settings.
* According to specification and country.

3
2
1
0
4
5
6
Front wipers 0Stop
1 Intermittent wipe
2 Normal wipe
3 Rapid wipe
4 Single stroke wipe
Press downwards Front windscreen washPull the stalk towards you. This starts a timed wiping operation. Note : - Position 1: the intermittent wipe
will automatically adjust according to the vehicle speed.
- Positions 1, 2 and 3: when statio-
nary, the wipe speed will automati-cally reduce.
- The engaging of reverse gear, when the front wiper is operating,makes the rear wiper operate. 5 Rear screen wiper For intermittent wipe: twist the ring forwards. 6 Rear screen wash
For screen wash and wipe: turn the ring for-wards.
On release: approximately fourwipes, then it stops. Electric demister* : Electric demister for rear screen or rear view mirrors or both simulta-
neously, according to specifica-
tion. The light indicating operation
switches off automatically afterapproximately 12 minutes to pre-vent excessive power consump-tion. Press once to stop thedemisting function. Press onceagain to restart for 12 minutes. The electric demister will only ope- rate when the engine is running.
* According to specification or country.
39I-17VISIBILITY