lock Peugeot RCZ 2014 User Guide

36
Service overdue
For 7 seconds after the ignition is switched on, the spanner fl ashes to
indicate that the service must be carried out as soon as possible.
Example: the service is overdue by 300 miles.
For 7 seconds after the ignition is switched on, the central screen
indicates:
The spanner remains on in the small screen
to indicate that a service should have been
carried out.
The distance remaining may be weighted by the time factor,
depending on the type of motoring the vehicle is used for.
Therefore, the spanner may also come on if you have exceeded
the period since the last service specifi ed in the warranty and
maintenance record.
Service indicator zero reset
Retrieving the service information
You can access the service information at any time.
This information appears when running through the manual check
procedure.
 Briefl y press the "CHECK/000" button.
The service information is displayed for a few seconds on the instrument panel central screen, then disappears.
Following this operation, if you wish to disconnect the battery, lock
the vehicle and wait at least fi ve minutes for the zero reset to be
registered.
After each service, the service indicator must be reset to zero.
The procedure for resetting to zero is as follows:
 switch off the ignition,
 press and hold the
"CHECK/000" button,
 switch on the ignition; the distance recorder display begins a countdown,
 when the instrument panel central screen indicates "=0" , release
the button; the spanner disappears from the small screen.

1/
MONITORING
MANUAL CHECK
This function allows you to check the status of the vehicle (reminder o\
f
the active alert warnings) and the service information.
 With the engine running, to start a manual check, briefl y press the "CHECK/000" button on the instrument panel.
If no faults have been detected, "CHECK OK" appears in the
instrument panel central screen.
If a "minor" fault has been detected, the warning lamp concerned then
"CHECK OK" appear in the instrument panel central screen. Contact a
PEUGEOT or a qualifi ed workshop.
If a "major" fault has been detected, only the warning lamps concerned
appear in the instrument panel central screen. Have it checked by a
PEUGEOT dealer or a qualifi ed workshop.
DISTANCE RECORDERS
The total and trip distances are displayed for thirty seconds when the
ignition is switched off, when the driver's door is opened and when the
vehicle is locked or unlocked.
Measures the total distance travelled by the vehicle since its fi rst
registration.
Total distance recorder
 With the ignition on, press and hold this button until zeros appear.
Trip distance recorder
Measures the distance travelled since it was last reset to zero by the
driver.

38
LIGHTING DIMMER
Permits manual adjustment of the brightness of the instruments and
controls to suit the ambient light level. Only operates when the vehicle\

lighting is on, with the exception of the daytime running lamps.
Activation
 Press the button to change the brightness of the instruments and controls.
 When the lighting reaches the minimum setting, release the button, then press again to increase it.
or
 When the lighting reaches the maximum setting, release the button, then press again to reduce it.
 When the lighting reaches the level of brightness required, release the button.
Deactivation
When the vehicle lighting is off, or in day mode on vehicles fi tted with
daytime running lamps, pressing the button does not have any effect.
CLOCK
The analogue clock, located between the central vents of the
dashboard, does not have an adjustment button.
To set the time, refer to the section relating to your multifunction
screen's confi guration menu.
The clock is synchronised with the multifunction screen time; once the
the setting has been confi rmed on the multifunction screen, the hands
will turn to synchronise with the screen, and each time the ignition is \
switched on.

44
* Depending on version.
** Depending on country of sale.
"PERSONALISATION-CONFIGURATION"
MENU
Once this menu has been selected, you can gain access to the
following functions:
- defi ne the vehicle parameters,
- display confi guration,
- choice of language.
Define the vehicle parameters *
Once this menu has been selected, you can activate or deactivate the
following equipment:
- selective unlocking (refer to the "Access" section),
- guide-me-home lighting (refer to the "Visibility" section),
- interior mood lighting (refer to the "Ease of use and comfort" section)\
,
- daytime running lamps ** (refer to the "Visibility" section),
- rear parking sensors (refer to the "Driving" section). Example: setting of the duration of the guide-me-home lighting
 Press the "
 " or "  " buttons, then the "OK" button to select the
menu required.
 Press the "  " or "  " buttons, then the "OK" button to select the
"Guide-me-home headlamps" line.
 Press the "  " or "  " buttons to set the value required (15, 30 or
60 seconds), then press the "OK" button to confi rm.
 Press the "  " or "  " buttons, then the "OK" button to select the
"OK" box and confi rm or press the "Back" button to cancel.

1/
MONITORING
"SETUP" MENU
 Press the "SETUP" button to gain access to the confi guration
menu:
- "Display confi guration",
- "Voice synthesis",
- "Choice of language",
- "Vehicle parameters",
- "Alert log".
For safety reasons, confi guration of the multifunction screen by
the driver must only be done when stationary.
Display configuration
This menu allows you to choose a colour scheme for the screen, to
adjust the brightness, set the date and time and choose the units for
distance (km or miles), fuel consumption (l/100 km, mpg or km/l) and\

temperature (°Centigrade or °Fahrenheit).
Voice synthesis
This men allows you to adjust the volume for navigation instructions and\

to choose the type of voice (male or female).
* Depending on version.
** According to country of sale.
Choice of language
This menu allows you to choose the language used by the screen
(French, English, Italian, Portuguese, Spanish, German, Dutch, Turkish,
Polish, Russian).
Vehicle parameters *
This menu allows you to activate or deactivate certain driving and
comfort equipment, arranged by category:
- Access to the vehicle ● Selective unlocking of the driver's door; refer to "Access"),
- Parking sensors
- Operation of wipers
● Rear wiper linked to reverse (rear wiper operates in reverse gear; refer to "Visibility"),
- Lighting confi guration (see "Visibility"):
● Duration of the guide-me-home lighting,
● Directional headlamps (main/additional directional lighting),
● Mood lighting (Interior mood lighting),
● Daytime running lamps function ** .
Alert log
It lists the active alerts by displaying their associated messages in tu\
rn.
Setting the date and time
 Press " SETUP ".
 Select "Display confi guration" and confi rm.
 Select "Set date and time" and confi rm.
You can select " Synchronise the minutes with GPS ", so that the
minutes are adjusted automatically by satellite reception.  Select the setting to modify. Conform by pressing "
OK ", then adjust
the setting and modify again.
 Adjust the settings one by one.
 Select " OK " in the screen then confi rm to save the setting.

2/
ACCESS
REMOTE CONTROL KEY
System which permits central unlocking or locking of the vehicle using
the lock or from a distance. It is also used to locate and start the
vehicle, as well as providing protection against theft.
UNLOCKING THE VEHICLE
Unfolding the key
 First press this button to unfold the key.
Complete unlocking using the remote control
 Press the open padlock to unlock the vehicle.
Selective unlocking using the remote control
 Press the open padlock once to unlock the driver's door and the fuel fi ller fl ap only.
 Press the open padlock again to unlock the passenger's door and the boot.
Selective unlocking using the key
 Turn the key forwards in the driver's door lock once to unlock the driver's door and the fuel fi ller fl ap only.
 Turn the key forwards in the driver's door lock again to unlock the passenger's door and the boot.
The complete or selective unlocking parameter is set via
the vehicle confi guration menu.
Complete unlocking is activated by default.
Complete unlocking using the key
 Turn the key forwards in the driver's door lock to unlock the vehicle.
Unlocking and partial opening of the boot
 Press this button for more than two seconds to unlock the boot. The boot opens slightly.
This action also unlocks the doors and the fuel fi ller fl ap.
The direction indicators fl ash for a few seconds.
Depending on version, the door mirrors unfold, the alarm is deactivated.\

52
If one of the doors or the boot is still open, the central locking does \
not take place; the vehicle lock and then immediately unlocks,
witnessed by the sound of the locks rebounding. However,
the alarm (if fi tted) will be completely activated after about
45 seconds .
When the vehicle is locked, if it is unlocked inadvertently, it will
lock itself again automatically after thirty seconds unless a door is
opened.
If the alarm had been activated previously, it will not be reactivated
automatically.
The folding and unfolding of the door mirrors using the remote
control can be deactivated by a PEUGEOT dealer or a qualifi ed
workshop.
LOCKING THE VEHICLE
Normal locking using the remote control
 Press the closed padlock to lock the vehicle completely.
Normal locking using the key
 Turn the key rearwards in the driver's door lock to lock the vehicle completely.
Deadlocking using the remote control
 Press the closed padlock to lock the vehicle completely.
 Press the closed padlock again within fi ve seconds to deadlock the vehicle.
Deadlocking using the key
The direction indicators come on for a few seconds.
Depending on version, the door mirrors fold, the alarm is
activated.
Deadlocking renders the exterior and interior door controls
inoperative.
It also deactivates the manual central control button.
Therefore, never leave anyone inside the vehicle when it is
deadlocked.
The direction indicators come on for a few seconds.
Depending on version, the door mirrors fold, the alarm is activated.
 Turn the key rearwards in the driver's door lock to lock the vehicle
completely.
 Turn the key rearwards again within fi ve seconds to deadlock the vehicle.

2/
ACCESS
Folding the key
 First press this button to fold the key.
LOCATING YOUR VEHICLE
REMOTE CONTROL PROBLEM
Following disconnection of the vehicle battery, replacement of the
remote control battery or in the event of a remote control malfunction, \
you can no longer unlock, lock or locate your vehicle.
 First of all, use the key in the lock to unlock or lock your vehicle.
 Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT dealer as soon as
possible.
Reinitialisation
 Switch off the ignition.
 Turn the key to position 2 (Ignition on) .
 Press the closed padlock immediately for a few seconds.
 Switch off the ignition and remove the key from the ignition switch.
The remote control is fully operational again.
Changing the battery
Battery ref.: CR1620 / 3 volts.
If the battery is fl at, you are informed by illumination of this
warning lamp, accompanied by an audible signal and an alert
message in the screen.
 Unclip the casing using a coin at the notch.
 Slide the fl at battery out of its location.
 Slide the new battery into its location observing the original direction.
 Clip the casing.
 Reinitialise the remote control.
This function allows you to identify your vehicle from a
distance, particularly in poor light. Your vehicle must be
locked.
 Press the closed padlock on the remote control.
This will switch on the courtesy lamps and the direction indicators will\

fl ash for around ten seconds.

54
LOST KEYS
Go to a PEUGEOT dealer with the vehicle's registration document, your personal identifi cation documents and if possible the key code label.
The PEUGEOT dealer will be able to look up the key code and the transponder code re\
quired to order a new key.
LOCKING THE VEHICLE
Driving with the doors locked may make access to the passenger compartment by the emergency services more diffi cult in an emergency.
As a safety precaution, never leave children alone in the vehicle, excep\
t for a very short period.
In all cases, it is essential to remove the key from the ignition switch\
when leaving the vehicle.
REMOTE CONTROL
The high frequency remote control is a sensitive system; do not operate \
it while it is in your pocket as there is a possibility that it may unlo\
ck
the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range \
and out of sight of your vehicle. You run the risk of stopping it from
working and the remote control would have to be reinitialised.
No remote control can operate when the key is in the ignition switch, ev\
en when the ignition is switched off, except for reinitialisation.
ANTI-THEFT PROTECTION
Do not make any modifi cations to the electronic engine immobiliser system; this could cause malfunctions.
Do not throw the remote control batteries away, they contain metals which are harmful to the environment.
Take them to an approved collection point.
WHEN PURCHASING A SECOND-HAND VEHICLE
Have the pairing of all of the keys in your possession checked by a PEUG\
EOT dealer, to ensure that only your keys can be used to open and
start the vehicle.

2/
ACCESS
ALARM *
System which protects and provides a deterrent against theft and
break-ins. It provides the following types of monitoring.
- exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a door, the boot, the
bonnet...
- interior volumetric
The system checks for any variation in the volume in the passenger compa\
rtment.
The alarm is triggered if anyone breaks a window, enters the passenger
compartment or moves inside the vehicle.
- tilt
The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted, moved or knocked. For all work on the alarm system, contact a PEUGEOT dealer or a
qualifi ed workshop.
LOCKING THE VEHICLE WITH FULL ALARM
SYSTEM
Activation
 Switch off the ignition and get out of the vehicle.
 Press the locking button on the remote control.
The monitoring system is active: the indicator lamp in the button fl ashes
once per second.
After the locking button on the remote control is pressed, the exterior \
perimeter monitoring is activated after a delay of 5 seconds and the
interior volumetric and anti-tilt monitoring after a delay of 45 seconds\
.
Deactivation
 Press the unlocking button on the remote control.
The alarm system is deactivated: the indicator lamp in the button goes o\
ff.
Self-protection function
The system checks for the putting out of service of its
components.
The alarm is triggered if the battery, the central control or the siren
wiring are put out of service or damaged.
* According to country. If an opening (door, boot...) is not closed fully, the vehicle is not
locked but the exterior perimeter monitoring will be activated after
a delay of 45 seconds at the same time as the interior volumetric
and anti-tilt monitoring.