boot Peugeot RCZ 2015 User Guide

47
RCZ_en_Chap02_ouvertures_ed01-2015
CLOSING
The window rises automatically after a few seconds and adjusts to
provide perfect sealing when closed.-

when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
CENTRAL LOCKING CONTROL
This control permits simultaneous locking or unlocking of the doors,
boot
lid and fuel filler flap from inside the vehicle.
Locking
F Press this button to lock the vehicle.
The red indicator lamp on the button comes on.
If one of the doors or the boot lid is open, the central locking from
the inside does not take place.
Unlocking
F Press this button again to unlock the vehicle.
The red indicator lamp on the button goes of f.
Locking / deadlocking from the outside
When the vehicle is locked or deadlocked from the outside, the
red indicator lamp flashes and the button is inactive.
F

With normal locking, pull on the interior door control lever to
unlock the vehicle.
F


With deadlocking, you have to use the remote control or the
key to unlock the vehicle.
When washing your vehicle:
-

first

lock

the

vehicle

using

the

remote

control

or

the

key,
-

avoid spraying the upper part of the windows,
-


keep the end of the high pressure nozzle at least 1 metre from
the windows and door seals.
When a door is not closed correctly:
Be aware of the risk of pinching when the window rises
automatically on closing the door

.
-

when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on, accompanied by an audible signal and
a message in the screen for a few seconds.
2/
ACCESS

48
RCZ_en_Chap02_ouvertures_ed01-2015
Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks the
vehicle, but the vehicle will be locked again when the speed exceeds
6 mph (10 km/h).
Activation / deactivation
You can activate or deactivate this function.
F
With the ignition on, press the button for more than two seconds.
A


confirmation message appears in the screen.
EMERGENCY LOCKING
To lock or unlock the doors mechanically in the event of a central
locking
system failure or flat battery.
Locking the driver's door
F Insert the key in the lock, then turn it to the right.
Unlocking the driver's door
F Insert the key in the lock, then turn it to the left.
Locking the passenger door
F Using the key, remove the black cap on the edge of the door.
F
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door

.
F Remove
the key and refit the cap.
Unlocking the passenger door
F Pull the interior door opening control.
ANTI-INTRUSION SECURITY
This function permits automatic and simultaneous locking of the doors,
boot lid and fuel filler flap as soon as the vehicle speed exceeds 6 mph
(10 km/h).
Operation
If one of the doors is open, the automatic central locking does not take\

place.
If the boot lid is open, the automatic central locking of the doors is
active.

49
RCZ_en_Chap02_ouvertures_ed01-2015
BOOT
OPENING
F Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.
F

Lift the boot lid.
This


action
also unlocks the doors and the fuel filler flap.
Using the manual control; vehicle unlocked
F Press the opening control above the number plate.
F
Lift the boot lid.
CLOSING
F Lower the boot lid using one of the interior grab handles.
F
If necessary
, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly: -

when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When selective unlocking is activated, the boot can also be
opened by a second press on the open padlock on the remote
control.
Using the remote control
Emergency locking
If the central locking system fails (flat battery), you are advised to disconnect the battery.
-

when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.
Never grasp the boot lid by the active spoiler
.
2/
ACCESS

58
RCZ_en_Chap03_confort_ed01-2015
ACCESS TO THE REAR SEATS
REAR SEATS
Two-seat bench with one-piece fixed seat cushion and one-piece folding backrest.
The
rear seat headrests are fixed.
FOLdING dOWN THE REAR BACKREST
RETURNING THE REAR BACKREST TO THE UPRIGHT POSITION
When returning the backrest to the upright position, ensure that it is
locked securely to assure your safety. F
Open the boot.
F

Pull the backrest release handle, located under the shelf.
When transporting long objects, do not place a load of more
than 30 kg on the rear of the backrest.
Do not place rough objects on the rear of the backrest which
could damage it.
F

Check

that

the

front

seat

has

been

moved

forward

sufficiently.
F

Pull the control upwards to fold the backrest; this control does not
release the seat cushion.
When put back in place, the backrest returns to its initial position.
The backrest can be folded down to increase the boot storage space.
The backrest release control is located in the boot.
F

Check

that

the

front

seats

have

been

moved

forward

sufficiently.
F

Check that nothing has been left on the rear seats.
F


Store the seat belt buckles on their respective securing points
located between the headrests. F

Fold the backrest down onto the seat cushion.

60
RCZ_en_Chap03_confort_ed01-2015
In order for these systems to be fully effective, follow the operation
and maintenance guidelines below:
F
T
o obtain an even air distribution, take care not to obstruct
the exterior air intake grilles located at the base of the
windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.
F

Do not cover the sunshine sensor
, located on the dashboard;
this is used for regulation of the air conditioning system.
F

Operate the air conditioning system for at least 5 to
10

minutes, once or twice a month to keep it in good working
order.
F Ensure
that the passenger compartment filter is in good
condition

and have the filter elements replaced regularly

(refer to the "Checks" section).
W

e recommend the use of a combined passenger
compartment
filter.
Thanks
to its special active additive,
it

contributes to the purification of the air breathed by the
occupants and the cleanliness of the passenger compartment
(reduction of allergic symptoms, bad odours and greasy
deposits).
F


T
o ensure correct operation of the air conditioning system,
you are also advised to refer to the warranty and maintenance
record for information on when it should be checked.
F

If the system does not produce cold air
, switch it off and
contact
a PEUGEOT

dealer or a qualified workshop.
When towing the maximum load on a steep gradient in high
temperatures, switching off the air conditioning increases the
available engine power and so improves towing performance. The condensation created by the air conditioning results in a
discharge of water under the vehicle which is perfectly normal. If after an extended stop in sunshine, the interior temperature is
very
high, first ventilate the cabin for a few moments.
Put
the air flow control at a setting high enough to quickly change
the air in the cabin.
The air conditioning system does not contain chlorine and does
not present any danger to the ozone layer

.
RECOMMENDATIONS FOR VENTILATION AND AIR CONDITIONING

73
RCZ_en_Chap03_confort_ed01-2015
BOOT FITTINGS
1. Stowing rings
2.
Storage net
3.


Storage well

(see details on following page)
3/
EASE OF USE and COMFORT

74
RCZ_en_Chap03_confort_ed01-2015
The duration of lighting varies, depending on the context:
-
when the ignition is of
f, approximately ten minutes,
-

in energy economy mode, approximately thirty seconds,
-


when the engine is running, no limit.
STORAGE BOX
This has areas for storing a box of spare bulbs, a first aid kit, the temporary puncture repair kit, a warning triangle, the removable ball
of the towbar system...
BOOT LAMPS
Your vehicle is fitted with two boot lamps; one in the right-hand boot side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch of f
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim.
For access to it:
F raise

the

floor

using

the

strap,
F

secure it in the vertical position behind the stops, located on
the sides of the boot.

94
RCZ_en_Chap05_securite_ed01-2015
Before operating the spoiler, ensure that no one is in the proximity
of the moving parts to avoid any risk of injury.
Nevertheless, in the event of pinching, you must reverse the
movement of the spoiler. To do this, release the control button
then press it again to raise the spoiler.
MAINTENANCE
To maintain the spoiler, with the vehicle stationary, ignition on:
F
raise the spoiler to the maximum position B

by pressing the button
briefly,
F

once the cleaning is complete, retract the spoiler: press and hold
the button until the end of the manoeuvre.
The keep this system in good working order

, check the spoiler and its
housing periodically preventing the unwanted accumulation of leaves,
ice or snow.
OPERATING F AULT
If the control system fails, the indicator lamp in the control button
flashes,
accompanied by an audible signal and a message in the
screen.

As a safety precaution, the spoiler rises to the maximum
position, regardless of the speed of the vehicle.
If the problem persists and you wish to retract the spoiler:
F

stop where it is safe to do so,
F


switch of
f the ignition,
F

switch the ignition on again.
If

the indicator lamp no longer flashes, the failure was temporary, the
system has resumed normal operation.

To retract the spoiler, refer to
the paragraph "To exit from manual mode".
If
the indicator lamp flashes again and the spoiler is still raised, the
system is still faulty

.
Have
it checked by a PEUGEOT

dealer or a qualified workshop.
In the event of a system operating fault (e.g. jamming of the spoiler)\
, the
indicator
lamp in the control button flashes, accompanied by an audible
signal and a message in the screen. For safety reasons, do not exceed
a speed of 85 mph (140 km/h).
Have

it checked by a PEUGEOT

dealer or a qualified workshop.
Before washing the vehicle, always retract the spoiler into its
housing.
Keep the end of the high-pressure nozzle at least 1 metre from the
spoiler housing. Never press on the spoiler to close the boot or push the vehicle as
this may damage it.
The installation of load-carrying accessories on the vehicle limits
the effectiveness of the spoiler.
Do not install load carrying accessories which are not
recommended by PEUGEOT.
To exit from manual mode:
F press

the

button

briefly:

the

indicator

lamp

on

the

button

goes

off

(return to automatic mode).
At speeds below 6 mph (10 km/h), the spoiler stays in the open
position. It retracts automatically as soon as the vehicle exceeds
this speed threshold.

140
RCZ_en_Chap07_verifications_ed01-2015
FUEL USE d FOR PETROL ENGINES
The petrol engines are compatible with E10 bio-petrol (containing
10 % ethanol), conforming to European standards EN 228 and EN 15376.
E85 type fuels (containing up to 85 % ethanol) are reserved exclusivel\
y for
vehicles marketed for the use of this type of fuel (BioFlex vehicles).\
The
quality
of the ethanol must comply with European standard EN 15293.
FUEL USE d FOR dIESEL ENGINES
The Diesel engines are compatible with biofuels which conform to
current and future European standards (Diesel fuel which complies
with
standard EN 590 mixed with a biofuel which complies with
standard
EN 14214) available at the pumps (containing up to 7 % Fatty
Acid Methyl Ester).
B30 biofuel can be used in certain Diesel engines. However, this use,
even
occasional, requires strict application of the special servicing
conditions.

Contact a PEUGEOT

dealer or a qualified workshop.
The use of any other type of (bio)fuel (vegetable or animal oils, pur\
e
or diluted, domestic fuel...) is strictly prohibited (risk of damage t\
o the
engine and fuel system).
When

you

have

filled

the

tank:
F

put the cap back in place,
F

turn it to the right,
F
close

the

flap.
Freezing conditions
In these conditions, the filler flap may be jammed.
Opening the boot gives access to the flap, allowing it to be
released by hand.

150
RCZ_en_Chap08_info-pratiques_ed01-2015
TEMPORARY PUNCTURE REPAIR
KIT
ACCESS TO THE KIT
This kit is installed in the storage box, under the boot floor.
Complete system consisting of a compressor and a sealant cartridge
which permits
temporary repair of a tyre so that you can drive to the
nearest garage.
It is designed to repair most punctures which could af
fect the tyre,
located on the tyre tread or shoulder.