bulb RENAULT KANGOO 1997 KC / 1.G Electrical Equipment Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1997, Model line: KANGOO, Model: RENAULT KANGOO 1997 KC / 1.GPages: 83
Page 6 of 83
HEADLIGHTS
Lens units and indicators
80
NOTE : The lens unit and indicators cannot be se-
parated.
REMOVAL - REFITTING
Disconnect:
- the battery,
- the connectors for the bulbs in the lens unit
and the indicator and for the remote
adjustment unit.
Remove the upper bolt (A).
Remove:
- the two bolts (D) from the bumper and the
three mounting bolts for the mudguard to al-
low the bumper to be partially removed,
- mounting bolt (C) and bolt (B) to remove the
lens unit.
ADJUSTMENT
Ensure that the vehicle is unladen, then adjust the
height using bolt (G) and the direction using bolt
(F).
13055R
The headlight is refitted in the reverse manner to
removal.
13057R
80-3
Page 7 of 83
HEADLIGHTS
Remote adjustment
80
13056S
REMOVING - REFITTING OF THE CONTROL
Remove the coin tray or the switch mounting de-
pending on version and, passing your hand inside
the dashboard, unclip the control and push it out-
wards.
CONNECTION
Refer to the Technical Note "Wiring diagrams".
REMOVING - REFITTING THE RECEIVER
Disconnect the remote adjustment receiver
connector.
Turn the receiver an eighth of a turn towards the
centre of the vehicle to release the lens unit.
Then release the ball joint of the receiver and the
lens unit parabola to remove the receiver.
SPECIAL NOTES FOR REFITTING
Remove the bulb connector protective cover at
the rear of the lens unit.
Keep the parabola towards the rear of the lens
unit by pulling on the base of the bulb and click
the ball joint into position.
Now refit the receiver to the lens unit by turning it
an eighth of a turn.
Reconnect the connector and refit the protective
bulb cover at the rear of the lens unit.
Set the remote adjustment control to "0" and ad-
just the headlight:
- bolt (G) for height adjustment,
- bolt (F) for direction adjustment.
13057R1
80-4
Page 8 of 83
REAR AND INTERIOR LIGHTS
Courtesy light
81
REMOVING - REFITTING THE COURTESY LIGHT
Remove the light diffuser using a screwdriver to
lever it out at the two points (A).
NOTE : The map reading light diffuser (depending
on equipment) is removed in the same way.
13073R
Remove the two courtesy light console mounting
bolts (B).
13072R
SPECIAL NOTES FOR REFITTING
When refitting the mounting (D), check that the
switch (E) is positioned to the right (see above) so
the contacts are not damaged on refitting.
Release the assembly towards the front and dis-
connect the connector.
REMOVING - REFITTING THE MOUNTING (D)
After removing the bulb, remove bolt (C) and un-
clip the mounting (D).
13074R
81-1
Page 62 of 83
WIRING
Remote control for door locking
88
Remove the receiver and its printed circuit by se-
parating tabs (F) (example: infrared receiver).
13075R
Special notes for refitting
When refitting the mounting (D), check that the
switch (E) is positioned towards the right (see dia-
gram) to avoid damaging the contacts on reclip-
ping the assembly.
13074R2
13072R
- the two courtesy light console mounting bolts
(B).
Release the assembly forwards and disconnect the
connector.
After removing the bulb, remove bolt (C) and un-
clip mounting (D).
13074R1
88-7