height adjustment RENAULT KANGOO 1997 KC / 1.G Electrical Equipment Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1997, Model line: KANGOO, Model: RENAULT KANGOO 1997 KC / 1.GPages: 83
Page 6 of 83

HEADLIGHTS
Lens units and indicators
80
NOTE : The lens unit and indicators cannot be se-
parated.
REMOVAL - REFITTING
Disconnect:
- the battery,
- the connectors for the bulbs in the lens unit
and the indicator and for the remote
adjustment unit.
Remove the upper bolt (A).
Remove:
- the two bolts (D) from the bumper and the
three mounting bolts for the mudguard to al-
low the bumper to be partially removed,
- mounting bolt (C) and bolt (B) to remove the
lens unit.
ADJUSTMENT
Ensure that the vehicle is unladen, then adjust the
height using bolt (G) and the direction using bolt
(F).
13055R
The headlight is refitted in the reverse manner to
removal.
13057R
80-3
Page 7 of 83

HEADLIGHTS
Remote adjustment
80
13056S
REMOVING - REFITTING OF THE CONTROL
Remove the coin tray or the switch mounting de-
pending on version and, passing your hand inside
the dashboard, unclip the control and push it out-
wards.
CONNECTION
Refer to the Technical Note "Wiring diagrams".
REMOVING - REFITTING THE RECEIVER
Disconnect the remote adjustment receiver
connector.
Turn the receiver an eighth of a turn towards the
centre of the vehicle to release the lens unit.
Then release the ball joint of the receiver and the
lens unit parabola to remove the receiver.
SPECIAL NOTES FOR REFITTING
Remove the bulb connector protective cover at
the rear of the lens unit.
Keep the parabola towards the rear of the lens
unit by pulling on the base of the bulb and click
the ball joint into position.
Now refit the receiver to the lens unit by turning it
an eighth of a turn.
Reconnect the connector and refit the protective
bulb cover at the rear of the lens unit.
Set the remote adjustment control to "0" and ad-
just the headlight:
- bolt (G) for height adjustment,
- bolt (F) for direction adjustment.
13057R1
80-4