Page
Cooling
Specifications
Filling and bleeding
Testing
Diagram
Water pump
Exhaust
General
Exhaust pipe assembly
Fuel tank
Tank
Sender unit
Pump and sender unit assembly
Engine suspension
Suspended engine mountings19-1
19-2
19-3
19-4
19-7
19-12
19-15
19-17
19-29
19-30
19-32 COOLING - EXHAUST - FUEL TANK -
ENGINE SUSPENSION
19
16-1
16-7 STARTING - CHARGING
Alternator
Starter
16
IGNITION - INJECTION
Ignition
Static ignition
Plugs
Injection
General
Location of components
Centralised coolant temperature
management
Injection fault warning light
Immobiliser function
Computer configuration depending
on gearbox type17
14-1
14-2
14-7
14-11 ANTIPOLLUTION
Test for the presence of lead
Fuel vapour rebreathing
Oil vapour rebreathing
Exhaust gas recirculation
(EGR)
14
17-17
17-18
17-19
17-20
17-22 IGNITION - INJECTION
(continued)
Injection/air conditioning
programming
Idle speed correction
Adaptive idle speed
correction
Richness regulation
Adaptive richness correction
17
Page
17-1
17-3
17-4
17-8
17-13
17-14
17-15
17-16
Contents
EXHAUST
General
19
ATTACHMENT OF THE PIPE UNDER THE BODY
The attachment of the pipe under the body is by
the rubber mounting at (1).
This can generally be unhooked by hand by ta-
king the weight off the exhaust pipe.
However, in certain cases, it may be necessary to
slacken the bolts retaining the support ( 2) under
the body in order to more easily unhook the rub-
ber mountings. During operation, the catalytic converter reaches
high temperatures, and consequently, it is vital
not to park the vehicle in a place where combusti-
ble materials could come into contact with it, and,
as a result, ignite.
Under certain conditions, these materials could
ignite.
IMPORTANT:
- the seal, between the exhaust manifold gas-
ket face and the catalytic converter (inclu-
sive), must be in perfect condition,
_ it is imperative that every gasket removed be
REPLACED (especially at the catalytic converter
flange)
- during removal and refitting, the catalytic
converter must not undergo repeated mecha-
nical shocks, as it will be damaged.
CUTTING THE EXHAUST PIPE
The exhaust pipes are of the monoblock type.
There is no join from the beginning of the cataly-
tic converter or the expansion box, to the end of
the silencer.
It will therefore be necessary, when replacing one
of the components in After Sales, to cut the
exhaust pipe.
For this, it is absolutely essential to accurately :
- mark the area to be cut,
- use the cutting tool Mot. 1199-01,
- fit the after sales sleeve .
12847-1R
19-12
