height adjustment RENAULT KANGOO 1997 KC / 1.G Sheet Metal Work Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1997, Model line: KANGOO, Model: RENAULT KANGOO 1997 KC / 1.GPages: 255
Page 251 of 255
NON-SIDE OPENING ELEMENTS
Bonnet
REFITTING
Refit in the opposite way to removal and refer to
section 40 (opening clearances) to correctly make
adjustments.
ADJUSTMENT
The height adjustment is carried out using strut
mounting bolts (B) on the headlight carrier panel.
The front and rear adjustments are carried out
using mounting nuts (A) on the bonnet .
REMOVAL
48A
PRB4808
13238R
Remove the bonnet nuts (A) (operation must be
carried out by two people).
48-1
Page 253 of 255
NON-SIDE OPENING ELEMENTS
Rear opening doors
48C
13101R
Remove the mounting bolts (A) on the door edges
(this operation should be carried out using two
people).
REMOVAL
PRB4810
REFITTING
Refit in the opposite way to removal and refer to
section 40 (opening clearances) to correctly make
adjustments.
ADJUSTMENT
The height and clearance adjustment is carried
out by means of the mounting bolts (A).
The tilt adjustment is carried out using a a B.H.A.
type clip from Z International, by deforming at (B)
the welded hinges on the rear pillar.
48-3
Page 254 of 255
NON-SIDE OPENING ELEMENTS
Tailgate
48D
13474R
REFITTING
Refit in the opposite way to removal and refer to
section 40 (opening clearances) to make correct
adjustments.
ADJUSTMENT
Height and tilt adjustment are made by fitting
shims under the mounting bolts (A).
Clearance adjustment is carried out by adjusting
the play of the same bolts in their mounting holes.
REMOVAL
PRB4811
After removal of trim and wiring, remove the ba-
lancers then the mounting bolts (A) from the roof
rear cross member (this operation should be car-
ried out with two people).
48-4