RENAULT SCENIC 2007 J84 / 2.G Electrical Equipment - Radio Owner's Guide

RADIO
Recovering a jammed CD
86A
86A - 31V2 MR-372-J84-86A000$891_eng.mif
Remove the two bolts (C).
Remove the CD guide arm.
Disconnect connector (D).Remove the eight bolts (E),
Remove both clips from the two connectors.
CHANGER IN THE DASHBOARD

RADIO
Recovering a jammed CD
86A
86A - 32V2 MR-372-J84-86A000$891_eng.mif
Remove both ribbon cables.
Remove the upper section of mechanism.Turn the guides and push the mechanism as shown in
the diagram in order to raise or lower the CDs.
The CDs can now be accessed.
CHANGER IN THE DASHBOARD
IMPORTANT
Never refit the changer mechanism once it has been
removed.

RADIO
Recovering a jammed CD
86A
86A - 33V2 MR-372-J84-86A000$891_eng.mif
Remove:
–the three bolts (1) located underneath the unit,
–the two springs (2) after bringing them to the upper
position,
–the four dampers (3) (clipped on).Remove the electronic module from the mounting and
place it to the side.
First solution
If the electric motors are operating:
1Reinsert the CD and its drawer into the changer (4)
using a 4.5 V battery to supply the electric motor (3),
(attach the + wire to contact (1) and the - wire to
contact (2)).
2Eject the changer by moving lever (4).
CHANGER IN THE BOOT

RADIO
Recovering a jammed CD
86A
86A - 34V2 MR-372-J84-86A000$891_eng.mif
Second solution
If the electric motors are not operational:
1To reinsert the CD and its drawer into changer (5),
remove the pinion mounting (6) by its bolt,
turn the toothed wheel (7) by hand in an
anticlockwise direction until the drawer is turned
completely upside down in the changer (5).2Eject the CD changer by moving the lever (8).
Before replacing the radio:
●refit the module in its unit, replace the four dampers
and the two springs,
●attach the module to the unit using the three bolts,
●re-close the changer, attach its cover and refit the
rear section.
CHANGER IN THE BOOT