maintenance RENAULT SCENIC 2008 J84 / 2.G Gas Injection LPG 3000 Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2008, Model line: SCENIC, Model: RENAULT SCENIC 2008 J84 / 2.GPages: 107, PDF Size: 0.31 MB
Page 8 of 107
17C-8
MR-372-J84-17C000$059.mif
V2
GAS INJECTION
Fault finding - Introduction
LPG 3000
Program No: AB
Vdiag No: 08/10
17C
ROAD TEST (in Petrol mode, then in LPG mode)
–check that the stabilisation time is normal,
–check that the engine does not stall under sudden braking and that it maintains a stable idle speed until the vehicle
comes to a stop,
–put the vehicle in 4th gear, at a steady speed of 36 mph (60 km/h). Check that the vehicle accelerates
progressively under full load acceleration.
Maintenance operations:
–no adjustment,
–removal of internal components is not permitted,
–if LPG clips are removed, they must be replaced,
–if LPG unions are removed, they must be replaced.
The tank must be bled before removing:
●the fuel tank,
●a component bolted to the fuel tank,
To remove the following, bleed all gas contained in the gas circuit (except the gas in the tank):
●the filler neck,
●the pipes,
●the filter,
●the pressure relief valve,
●the solenoid valve. IMPORTANT
Before performing any work on the vehicle, drain the LPG circuit.
Only personnel who have undergone special LPG training can work with gas unions where gas is circulating and
which run from the expansion valve via the fuel tank.
Equally, only these persons are permitted to perform servicing and repair operations on LPG vehicles.
Workshops can only carry out work on the fuel tank if they have a degassing burner. If the tank cannot be
degassed, do not carry out any work and contact the Comité Français du Butane et du Propane (French
Butane and Propane Commission) by fax on 01 41 97 02 89.