automatic SSANGYONG NEW ACTYON SPORTS 2012 Owner's Manual

02-498710-01
Automatic Hazard Warning Lamp Switch (SHP: Safety Hazard Protection) ▶
When the automatic hazard warning lamp switch is pressed for approx. 0.1 to 0.59
seconds, the hazard warning lamp blinks 3 times at an interval of 0.35 seconds.
When the automatic hazard warning lamp switch is pressed for approx. 0.6 seconds or
longer, the hazard warning lamp blinks 10 times at an interval of 0.35 seconds.
This function is only available when the ignition key is in the "ON" position.
If the ignition key is turned to the "OFF" position during this function is activated, this
function is immediately deactivated.
If the system receives signals for the turn signal lamp operation during this function is
activated, this function is immediately deactivated.
While the turn signal lamp signals are already inputted, pressing the automatic hazard
warning lamp switch does not activate the automatic hazard warning lamp function. 1.
2.
3.
4.
5.
6.
Automatic hazard warning lamp switch ▶
Press briefly (0.1 ~ 0.59 seconds): The hazard
warning lamp blinks three times.
Press and hold (more than 0.6 seconds): The
hazard warning lamp blinks ten times. ·
·

02-558710-01
Remote Escort ▶
When you press and hold the door LOCK button (more than 0.5 seconds) the escort function
is activated.
The headlamp comes on for 20 seconds and goes off automatically, when the escort
message is received from the remote control key. 1.
2.
Auto Door Lock in 30 Seconds after Pressing Door Unlock Button ▶
If no door is opened for 30 seconds after inputting remote door unlock, the doors are
automatically locked and the armed mode of anti-theft system is activated again (RELOCK
function). 1.

03-157010-06
3) Remote Escort
When you press and hold the PANIC button (more than 0.5 seconds) the escort function is
activated.
The headlamp comes on for 20 seconds and goes off automatically, when the escort
message is received from the remote control key. 1.
2.
4) Remote Panic
When pressing and holding the PANIC button on the remote control key for more than 2
seconds, the panic function is activated.
The vehicle activates the panic alarm by using the horn for 27 seconds when receiving the
panic message from the remote control key. 1.
2.

04-158210-01
Change
OrderMode LCD Display Description
1 TRIP A The maximum distance value that can be displayed is
999.9 km with increments of 0.1 km. The trip meter is
reset to 0.0 km when the value reaches above 999.9
km. When measuring a trip distance, reset the
distance value in the mode you want to use by
pressing the TRIP switch for 1 sec. or more.
2 TRIP B The maximum distance value that can be displayed is
6,213.09 mi with increments of 0.62mi. The trip meter
is reset to 0.0 km when the value reaches above
999.9 km. When measuring a trip distance, reset the
distance value in the mode you want to use by
pressing the TRIP switch for 1 sec. or more.
3 Distance
to emptyThe estimated distance that can be traveled is
calculated based on the current fuel level.
If the DTE is less than 50 km, "---" flashes on the
display.
4 Driving
timeThe driving time from resetting the value (0:00) until
now is displayed. The value displayed is accumulated
while the engine is running even if the vehicle is not
driven. The display range is 00:00 to 99:59. When
measuring the driving time, press the TRIP switch for
1 sec. or more to reset the value.
5 Average
fuel
economyThe average fuel economy from resetting the value (-
-.-) until now is displayed. The value displayed is
accumulated while the engine is running even if the
vehicle is not driven. The display range is 0.0 to 99.9
km/h. When measuring the average fuel economy,
press the TRIP switch for 1 sec. or more to reset the
value. "--.-" is displayed on the screen when
resetting. The value is reset automatically whenever
the vehicle is fuelled.
5) Description for LCD Display
LCD display
Mode Description ▶

04-16
Change
OrderMode LCD Display Description
6 Instant fuel
consumptionThe fuel range is calculated based on the distance
driven and fuel consumed every 2 seconds. If the
vehicle speed is below 10 km/h or the engine rpm
is 200 rpm or less, the instant fuel economy is not
displayed. The display range is 0.0 to 99.9 km/.
7 Brightness
adjustmentThe brightness of the illumination can be adjusted
in 6 steps by pressing the TRIP switch briefly (less
than 1 sec.). The display is changed from ILL1 to
ILL6 every time the switch is pressed. If you select
one level within the range and press and hold the
TRIP switch, the brightness level is memorized. If
there is no TRIP switch input for 5 seconds or
more, the mode is switched to TRIP A mode
automatically. When the battery is reinstalled, the
brightness level is reset to level 4.

04-218210-01
ABS Warning Light
This warning light comes on
when the ignition switch is
turned to "ON" position and
should go out if the system is
normal.
The vehicle with ABS performs
self-diagnosis. During this
diagnosis, brake pedal
vibration and noise may be
apparent when the driving
motors discharges the
hydraulic pressure from the
internal hydraulic device.4WD IndicatorLow Fuel Level
Warnig Light
This warning light
comes on when the
fuel will soon be
exhausted. The time
it takes turn on,
however, varies
according to the
gradient of the
vehicle.
4WD HIGH Indicator
The lamp blinks momentarily during
the change of driving mode.
4WD LOW Indicator
The lamp blinks momentarily during
the change of driving mode.
4WD CHECK Warning Light
This indicates that there is
something wrong in the transfer
case system. (check the system) -
-
-
Auto Cruise Control
Indicator
Operating the cruise
control switch turns on
the indicator lamp to
indicate the cruise
control system is
activated.
Water Separator Warning Light
This lamp comes on to warn the driver of
water in the fuel tank which causes the
loss of engine power. When a certain
amount of water is accumulated, the lamp
comes on and a chime sounds.
Engine CHECK Warning Light
This warning light comes on when
the ignition switch is turned to "ON"
position and should go out if the
system related to engine control is
normal.
This comes on when different
sensors and devices related to
engine control are defective.
Winter Mode
Indicator
Pressing the "W" side of the
automatic transmission mode
selector switch switches the
driving mode to winter mode and
turns on the indicator lamp.
Use this mode to drive off
smoothly on icy and slippery
roads.
Charge Warning Light
This warning light comes on when the
ignition switch is turned on and go off
when the engine is started.
If this light doesn't go off after engine
starting, it means there is a malfunction in
the system.
Engine Hood Open Warning Light
When the engine hood is open, this light
comes on to inform the driver.

04-22
How to enter self-diagnosis mode ▶
Turn the ignition ON with the TRIP switch pressed.
Press and hold the TRIP switch for 5 to 10 sec. with the ignition ON.
Press and hold the TRIP switch for less than 10 sec. and then cycle the switch between ON
and OFF 5 times within 3 sec.
Confirm that the self-diagnosis mode is activated through the instrument cluster. 1.
2.
3.
4.
4. SELF-DIAGNOSIS CHECK
Self-diagnosis OFF ▶
If the engine speed increases to 396 rpm or more while the engine is cranking or the ignition key
is turned OFF in self-diagnosis mode, the self-diagnosis mode is turned OFF automatically.
Operating process ▶
Speed gauge: changes from 0 to 220 km
RPM gauge: changes from 0 to 6,000 rpm
Fuel gauge: changes from E to F
Temperature gauge: changes from C to H
Warning/Indicator lamps: All indicator/warning lamps controlled by MICOM are turned ON.
Dimming: Illuminates at the highest lighting level.
LCD display: All elements are activated. 1.
2.
3.
4.
5.
6.
7.

06-58610-08
Major Functions of Multifunction Switch (Added functions)
Automatic hazard warning flasher switch
<00470047004700470d960047006900990090008c008d009300a0004700970099008c009a009a00610047006f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c0099004700890093009000950092009a00
47009b008f0099008c008c0047009b00900094008c009a0055>
<00470047004700470d96004700770099008c009a009a004700880095008b0047008f00960093008b00610047006f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c009900470089009300900095009200
9a0047009b008c00950047009b00900094008c009a0055>Auto washer switch
Washer fluid is sprayed
on the windshield and
the wiper sweeps off 4
times. Then, the fluid will
be sprayed again and the
wiper will automatically
operate 3 times.
Auto light switch
Front wiper and washer coupled operation
Pull the lever briefly (below 0.6 seconds):
Wiping without washer spray
Pull and hold the lever for more than 0.6 seconds:
Three wiping cylces with washer spray
4WD control switch
Driver's heated
seat switch
Passenger's heated
seat switchAudio remote control switch
Gear shift switch
Front room lamp spot switch
Sun roof switch
Main room lamp switch
Front wiper operation range
(move the wiper lever up/down)

07-6
3. FUNCTIONS
1) Wiper and Washer Fluid Switch Operation
The wiper operates for 1 cycle when
pushing up the lever. The lever will return
to the "OFF" position when released.Front Automatic Wiping Speed
Control Switch
Fast: Fast interval
Slow: Slow interval
Stop the operation.
Operates automatically
according to the vehicle
speed or amount of rain.
Continuous wipe,
fast operation Continuous wipe,
slow operation
Front Auto Washer Switch (AFW)
When the front wiper switch is off
and this switch is pressed,
washer fluid will be sprayed and
the wiper will automatically
operate 4 times. Then, the fluid
will be sprayed again and the
wiper will automatically operate 3
times.
Wiper and Washer Coupled Operation
Pull the lever briefly (for less than 0.6 seconds):
One wiping cycle with washer spray Pull and hold the
lever for more than 0.6 seconds: Three wiping cycles
with washer spray Wiping without
washer spray
Wiping stopsMIST
OFF
AUTO
LO
HI

08-38610-09
Multifunction Wiper Switch:
AUTO and Sensitivity Control
1. OVERVIEW
The rain sensing wiper unit system doesn't control the wiper directly. The rain sensing unit
detects the amount of rain drops and sends the operating signal to STICS, and STICS drives the
wiper directly.
Rain Sensing Unit
(AUTO Light Sensor Integrated Type)
A sensor that emits infrared rays through LED
and then detects the amount of rain drops by
receiving reflected rays against sensing
section (rain sensor mounting section on the
windshield) with photodiode. The auto light
sensor is Integrated into the rain sensor (refer
to the below picture).AUTO: Wiper operates automatically by
rain sensor
FAST SLOW: Auto delay/auto speed
control. A position that can control
sensitivity against rains on the windshield
and transmits wiping demand signal
accordingly.
Emitter lens
The LED which is located at
bottom emits the infrared rays
and the lens guides the infrared
rays to target point.
Auto light sensor
Enlarged auto light
sensor section
Auto light sensor(Vertical)
Auto light sensor (Horizon)