SSANGYONG NEW ACTYON SPORTS 2012 Service Manual

02-78710-01
1) Wiper and Washer Operations
When pulling up the lever, the wiper
operates once and the wiper lever
returns to the "OFF" position.
Stop the operation.
Operates automatically
according to the vehicle
speed or the amount of rain.
Continuous wipe, slow
operation.Front Wiping Speed Control Switch
FAST: Fast interval
SLOW: Slow interval
Continuous wipe, fast operation
Front Wiper and Washer Coupled Operation
Pull the lever briefly (below 0.6 seconds):
One wiping cycle without washer spray
Pull and hold the lever for more than 0.6 seconds:
Three wiping cycles with washer spray
Front Auto Washer Switch (AFW)
When the front wiper switch is off and this switch is pressed,
washer fluid will be sprayed and the wiper will automatically
operate 4 times. Then, the fluid will be sprayed again and the
wiper will automatically operate 3 times.
MIST
OFF
AUTO
LO
HI
Previous model
Pressing the switch makes washer
fluid to be sprayed for 2 sec. with
four wiping, after having delay of 0.6
sec., washer fluid to be sprayed for
1.5 sec. with three wiping
Pressing the switch makes washer
fluid to be sprayed for 2 sec. with
four wiping, and washer fluid to be
sprayed for 1.5 sec. with three
wiping, with no delay of time New model

02-8
2) Operation Logic
▶Wiper MIST and Front Washer Coupled Wiper
The wiper relay is turned on at 0.3 seconds after from the time when the washer switch is
turned on for 0.1 to 0.59 seconds with the ignition switch "ON".If the wiper parking
terminal gets off, the wiper relay is turned off. -
The wiper relay is turned on at 0.3 seconds after from the time when the washer switch is
turned on for more than 0.6 seconds with the ignition switch "ON". The wiper relay gets on
3 times immediately after turning off the washer switch. -

02-98710-01
When the washer switch is turned on for more than 0.6 seconds during the wiper
operation by INT switch, the operation in step (2) is performed.
When it is turned on for a certain period of time (0.1 to 0.59 seconds), the operation in
step (1) is performed. -

02-10
▶Auto Washer and Wiper Switch (AFW)
When the auto washer switch is turned on with the ignition switch "ON" and the INT switch
"OFF", the washer motor output gets ON for 1 second. If the system recognizes the output
signal, the wiper relay output gets ON during 4 cycles and the washer motor output gets
ON for 1 second. Then, the wiper relay output gets OFF after 3 cycles. -

02-118710-01
The auto washer switch input is overridden during the washer coupled wiper operation.
The auto washer switch input is overridden during the auto washer coupled wiper
operation.
The auto washer switch input is overridden during the rain sensor coupled wiper or vehicle
speed sensitive INT wiper operation.
When the auto INT switch input is received during the auto washer operation, the auto
washer operation stops and the auto INT operation is activated. -
-
-
-

02-12
▶Rain Sensor Coupled Wiper and Auto Light Control
If equipped with RKSTICS rain sensor, it has following operation system. -
▶System layout

02-138710-01
Rain sensing unit
(AUTO light integrated type)
▶INT Switch Auto Position Reminder (Power-Up Reminder Wiper)
When turning off and on the auto INT switch, the system drives the wiper motor through
LOW relay regardless of communication with rain sensor.
When turning the INT-AUTO switch from the "OFF" to "ON" position with the ignition switch
in the "ON" mode, the LOW relay operates to drive the wiper motor for 1 cycle, regardless
of the rain sensor communication.
After that, when turning the INT-AUTO switch from the "OFF" to "ON" position, the LO
W
relay operates to drive the wiper motor for 1 cycle only if data from the rain sensor
indicates rain drops. -
-
Multifunction wiper switch:
AUTO and sensitivity control
A sensor that emits infrared rays through LED
and then detects the amount of rain drops by
receiving reflected rays against sensing section
(rain sensor mounting section on the
windshield) with photodiode (auto light sensor
integrated type)AUTO: Wiper operates automatically by rain
sensor
FAST↔SLOW: Auto delay/Auto speed control. A
position that can control sensitivity against rains
on the windshield and transmits wiping demand
signal accordingly

02-14
▶Washer Coupled Wiper in Rain Sensing Mode
The washer coupled wiper is operated when receiving the washer switch input with the
ignition switch and the INT-AUTO switch "ON" in the rain sensing mode. At this moment,
the communication with the rain sensor is overridden. However, a washer input is overridden
if there is an output for continuous operation.
The operation data is sent to the rain sensor even during the washer coupled wiper's
operation. -
-

02-158710-01
▶Sensitivity Control
The wiper LOW relay is turned on and the wiper motor runs one cycle when the volume
sensitivity is increased (ex: sensitivity 0 ⇒ 1) while the ignition switch and the INT switch is
in the "ON" position, and the wiper motor is in "Parked" position). However, the wiper motor
can be operated only when the rain sensor detects the "Rain Detected" signal.
If the volume sensitivity is changed more than 2 stages within 2 seconds, the wiper motor
runs only one cycle. -
※

02-16
▶When the Wiper Parking Signal is abnormal
The wiper system continuously outputs the wiper parking signal when the wiper parking
terminal is grounded, while the ignition switch is in "ON" position and the INT switch is in
"ON" position. -
<0b54007b008f008c0047009e00900097008c0099004700940096009b0096009900470099009c0095009a004700960095009300a00047009e008f008c00950047009b008f008c004700990088009000950047009a008c0095009a0096009900470099008c00
98009c00900099008c009a0047009b008f008c0047009e0090>per operation.
When the parking terminal is fixed to IGN, the wiper system outputs the wiper operating
signal for 2 seconds, then continuously outputs the wiper parking signal. -
<0b54007b008f008c0047009e00900097008c0099004700940096009b0096009900470099009c0095009a004700960095009300a00047009e008f008c00950047009b008f008c004700990088009000950047009a008c0095009a0096009900470099008c00
98009c00900099008c009a0047009b008f008c0047009e0090>per operation.