SSANGYONG RODIUS 2005 Service Manual

0-14
RODIUS 2005.07
3240-01
TORQUE ON DEMAND
4. CIRCUIT DIAGRAM

0-3
PROPELLER SHAFT
RODIUS 2005.07
3310-01
3310-01PROPELLER SHAFT
1. PROPELLER SHAFT GENERAL INFORMATION
The propeller shaft transfers the power through
the transmission and transfer case to the
front/rear axle differential carrier (final reduction
gear). It is manufactured by a thin rounded steel
pipe to have the strong resisting force against
the torsion and bending. Both ends of propelle
r
shaft are connected to the spider and the cente
r
of propeller shaft is connected to the spline to
accommodate the changes of the height and
length. The rubber bushing that covers the
intermediate bearing keeps the balance of rea
r
propeller shaft and absorbs its vibration.
2. SPECIFICATION

0-4
RODIUS 2005.07
3310-01
PROPELLER SHAFT
1. COMPONENTS AND LOCATION
1) Front Prepeller Shaft Assembly
2) Rear Prepeller Shaft Assembly
Bolt Bolt
CV joint Front propeller shaft assembly
Universial joint
Bolt/was
her/nut
Universial joint
1st rear propeller shaft
Center bearing assembly
CV joint
2nd rear propeller shaft
Universial joint
Bolt

0-3
SUSPENSION SYSTEM
RODIUS 2005.07
4111-01
4410-01SUSPENSION SYSTEM
1. FRONT SUSPENSION SPECIFICATION

0-4
RODIUS 2005.07
4111-01
SUSPENSION SYSTEM
2. REAR SUSPENSION SPECIFICATION

0-5
SUSPENSION SYSTEM
RODIUS 2005.07
4111-01
3. STRUCTURE OF SHOCK ABSORBER AND COIL SPRING
1) front coil spring
▶ Specification

0-6
RODIUS 2005.07
4111-01
SUSPENSION SYSTEM
2) front shock absorber assembly
▶ Specification

0-7
SUSPENSION SYSTEM
RODIUS 2005.07
4111-01
Marking Point
3) rear shock absorber
Keep the suitable distance when compressed and expanded.
Minimum length is 10 mm longer than the minimum length under compression. ·
·
▶Specification

0-8
RODIUS 2005.07
4111-01
SUSPENSION SYSTEM
4) rear coil spring
Steel for high tensional spring is adapted.
Maintain more than 20 mm of freeplay when compressed.
Spring seat applied. ·
·
·
▶ Specification

0-3
BRAKS SYSTEM
RODIUS 2005.07
4830-01
4830-01BRAKE SYSTEM
1. SPECIFICATION