ESP TOYOTA HILUX 2015 Owners Manual (in English)

431-1. For safe use
1
HILUX_OM_OM0K219E_(EE)
For safety and security
CAUTION
Observe the following precautions.
Failure to do so may cause the driver’s floor mat to slip, possibly interfering
with the pedals while driving. An unexpectedly high speed may result or it may
become difficult to stop the vehicle, leading to an accident, or leading to death
or a serious injury.
■When installing the driver’s floor mat
● Do not use floor mats designed for other models or different model year
vehicles, even if they are Toyota Genuine floor mats.
● Only use floor mats designed for the driver’s seat.
● Always install the floor mat securely using the retaining hooks (clips) pro-
vided.
● Do not use two or more floor mats on top of each other.
● Do not place the floor mat bottom-side up or upside-down.
■ Before driving
● Check that the floor mat is securely
fixed in the correct place with all the
provided retaining hooks (clips). Be
especially careful to perform this check
after cleaning the floor.
●
With the engine stopped and the shift
lever in P (automatic transmission) or N
(manual transmission), fully depress
each pedal to the floor to make sure it
does not interfere with the floor mat.
HILUX_OM_OM0K219E_(EE).book Page 43 Wednesday, May 14, 2014 3:06 PM

531-1. For safe use
1
HILUX_OM_OM0K219E_(EE)
For safety and security
The main SRS airbag system components are shown above. The
SRS airbag system is controlled by the airbag sensor assembly. As
the airbags deploy, a chemical reaction in the inflators quickly fills the
airbags with non-toxic gas to help restrain the motion of the occu-
pants.
Bench type front seat: The SRS airbags are designed to protect the
driver and front outside passenger, and they are not designed to pro-
tect an occupant in the front center seating position.
CAUTION
■SRS airbag precautions
Observe the following precautions regarding the SRS airbags.
Failure to do so may cause death or serious injury.
● The driver and all passengers in the v ehicle must wear their seat belts
properly.
The SRS airbags are supplemental devices to be used with the seat belts.
● The SRS driver airbag deploys with considerable force, and can cause
death or serious injury especially if the driver is very close to the airbag.
Since the risk zone for the driver’s airbag is the first 50 - 75 mm (2 - 3 in.)
of inflation, placing yourself 250 mm ( 10 in.) from your driver airbag pro-
vides you with a clear margin of safety. This distance is measured from
the center of the steering wheel to your breastbone. If you sit less than
250 mm (10 in.) away now, you can change your driving position in sev-
eral ways:
• Move your seat to the rear as far as you can while still reaching the ped- als comfortably.
• Slightly recline the back of the seat. Although vehicle designs vary, many drivers can achieve the 250 mm
(10 in.) distance, even with the driver seat all the way forward, simply by
reclining the back of the seat somewhat. If reclining the back of your
seat makes it hard to see the road, raise yourself by using a firm, non-
slippery cushion, or raise the seat if your vehicle has that feature.
• If your steering wheel is adjustable, tilt it downward. This points the air- bag toward your chest instead of your head and neck.
The seat should be adjusted as recommended above, while still maintain-
ing control of the foot pedals, steering wheel, and your view of the instru-
ment panel controls.
HILUX_OM_OM0K219E_(EE).book Page 53 Wednesday, May 14, 2014 3:06 PM

541-1. For safe use
HILUX_OM_OM0K219E_(EE)
CAUTION
■SRS airbag precautions
● Vehicles with SRS front passenger airbag: The SRS front passenger air-
bag also deploys with considerable force, and can cause death or serious
injury especially if the front passenger is very close to the airbag. The front
passenger seat should be as far from the airbag as possible with the seat-
back adjusted, so the front passenger sits upright.
● Vehicles with SRS front passenger airbag: Improperly seated and/or
restrained infants and children can be killed or seriously injured by a
deploying airbag. An infant or child who is too small to use a seat belt
should be properly secured using a child restraint system. Toyota strongly
recommends that all infants and children be placed in the rear seats (if
equipped) of the vehicle and properly restrained. The rear seats (if
equipped) are safer for infants and children than the front passenger seat.
( → P. 64)
HILUX_OM_OM0K219E_(EE).book Page 54 Wednesday, May 14, 2014 3:06 PM

581-1. For safe use
HILUX_OM_OM0K219E_(EE)
■If the SRS airbags deploy (inflate)
●Bruising and slight abrasions may result from contact with a deploying
(inflating) SRS airbag.
● A loud noise and white powder will be emitted.
● Vehicles without SRS curtain shield airbags: Parts of the airbag module
(steering wheel hub, airbag cover and infl ator) as well as the seats may be
hot for several minutes. The airbag itself may also be hot.
● Vehicles with SRS curtain shield air bags: Parts of the airbag module (steer-
ing wheel hub, airbag cover and inflator) as well as the seats, parts of the
front and rear pillars, and roof side rails, may be hot for several minutes.
The airbag itself may also be hot.
● The windshield may crack.
■ SRS airbag deployment conditions (SRS front airbags)
●The SRS front airbags will deploy in the event of an impact that exceeds the
set threshold level (the level of force corresponding to an approximately 20 -
30 km/h [12 - 18 mph] frontal collision with a fixed wall that does not move or
deform).
However, this threshold velocity will be considerably higher if the vehicle
strikes an object, such as a parked vehicle and sign pole, which can move
or deform on impact, or if the vehicl e is involved in an underride collision
(e.g. a collision in which the front of the vehicle “underrides”, or goes under,
the bed of a truck etc.).
● Depending on the type of collision, it is possible that only the seat belt pre-
tensioners will activate.
■ SRS airbag deployment conditions (S RS side airbags and curtain shield
airbags)
The SRS side airbags and curtain shield airbags will deploy in the event of an
impact that exceeds the set threshold level (the level of force corresponding
to the impact force produced by an approximately 1500 kg [3300 lb.] vehicle
colliding with the vehicle cabin from a direction perpendicular to the vehicle
orientation at an approximate speed of 20 - 30 km/h [12 - 18 mph]).
HILUX_OM_OM0K219E_(EE).book Page 58 Wednesday, May 14, 2014 3:06 PM

1092. Instrument cluster
2
Instrument cluster
HILUX_OM_OM0K219E_(EE)
■Outside temperature display
In the following situations, the correct outside temperature may not be dis-
played, or the display may take longer than normal to change:
●When the vehicle is stopped, or moving at low speeds (less than 20 km/h
[12 mph])
● When the outside temperature has changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
■ When “--” is displayed
The system may be malfunctioning. Take your vehicle to any authorized
Toyota dealer or repairer, or another duly qualified and equipped professional.
■ When disconnecting and reconnecting battery terminals
The following information data and settings will be reset:
●Average fuel consumption
● Average vehicle speed
● Elapsed time
CAUTION
■Cautions during setting up the display
As the engine needs to be operating during setting up the display, ensure
that the vehicle is parked in a place with adequate ventilation. In a closed
area such as a garage, exhaust gases including harmful carbon monoxide
(CO) may collect and enter the vehicle. This may lead to death or a serious
health hazard.
NOTICE
■The information display at low temperatures
Allow the interior of the vehicle to warm up before using the liquid crystal
information display. At extremely low temperatures, the information display
monitor may respond slowly, and display changes may be delayed.
■
During setting up the display
To prevent battery discharge, ensure that the engine is operating while set-
ting up the display features.
HILUX_OM_OM0K219E_(EE).book Page 109 Wednesday, May 14, 2014 3:06 PM

1173-2. Opening, closing and locking the doors
3
Operation of each component
HILUX_OM_OM0K219E_(EE)■
Setting and canceling the functions
●
Answerback function
See “Before setting and canceling the functions”. ( →P. 1 1 6 )
Within 5 seconds, push the lock button on the wireless remote
control key once. Within the next 2 seconds, push the unlock
button once. The turn signal lights will flash once.
Within 10 seconds, set the desired condition by pushing the
lock and unlock buttons according to the following table.
*: On vehicles with two batteries, the security horn does not sound.
1
2
3
Optional function conditionOperation
AnswerbackOpen door reminderStep 1Step 2Settings
response
Turn signal
lights flash
Security horn
sounds
*
Push lock
button once
Push unlock
button once
within 2 sec-
onds
Turn signal
lights flash
once
Turn signal
lights flash
and security
horn sounds
*
Push lock
button twiceTurn signal
lights flash
twice
Off
Security horn
does not
soundPush lock
button three
timesTurn signal
lights flash
three times
Cancel the settings
Push lock
button four or
more times
Not applicable
HILUX_OM_OM0K219E_(EE).book Page 117 Wednesday, May 14, 2014 3:06 PM

1183-2. Opening, closing and locking the doors
HILUX_OM_OM0K219E_(EE)
●Automatic locking and unlocking function
See “Before setting and canceling the functions”. ( →P. 1 1 6 )
Within 5 seconds, push the lock button on the wireless remote
control key twice within 2 seconds. Within the next 2 seconds,
push the unlock button once. The turn signal lights will flash
twice.
Within 10 seconds, set the desired condition by pushing the
lock and unlock buttons according to the following table.
1
2
3
Automatic
locking/unlocking functionOperation
Step 1Step 2Settings
response
On Push lock button
once
Push unlock but-
ton once within 2
secondsTurn signal lights
flash once
Off Push lock button
twice Turn signal lights
flash twice
Cancel the
settings Push lock button
three or more
times
Not applicable
HILUX_OM_OM0K219E_(EE).book Page 118 Wednesday, May 14, 2014
3:06 PM

1323-2. Opening, closing and locking the doors
HILUX_OM_OM0K219E_(EE)
CAUTION
■To prevent an accident
Observe the following precautions while driving the vehicle.
Failure to do so may result in a door opening and an occupant falling out,
resulting in death or serious injury.
● Ensure that all doors are properly closed.
● Do not pull the inside handle of the doors while driving.
Be especially careful for the driver’s door, as the door may be opened
even if the inside lock button is in locked position.
● Set the rear door child-protector loc ks when children are seated in the rear
seats.
HILUX_OM_OM0K219E_(EE).book Page 132 Wednesday, May 14, 2014 3:06 PM

1433-3. Adjusting the seats
3
Operation of each component
HILUX_OM_OM0K219E_(EE)
CAUTION
■Head restraint precautions
Observe the following precautions regarding the head restraints. Failure to
do so may result in death or serious injury.
● Use the head restraints designed for each respective seat.
● Adjust the head restraints to the correct position at all times.
● After adjusting the head restraints, push down on them and make sure
they are locked in position.
● Do not drive with the head restraints removed.
HILUX_OM_OM0K219E_(EE).book Page 143 Wednesday, May 14, 2014 3:06 PM

1513-5. Opening and closing the windows
3
Operation of each component
HILUX_OM_OM0K219E_(EE)
CAUTION
Observe the following precautions.
Failure to do so may result in death or serious injury.
■Closing the windows
● The driver is responsible for all t he power window operations, including the
operation for the passengers. In order to prevent accidental operation,
especially by a child, do not let a child operate the power windows. It is
possible for children and other passengers to have body parts caught in
the power window. Also, when riding with a child, it is recommended to use
the window lock switch. ( →P. 150)
● Check to make sure that all passengers do not have any part of their body
in a position where it could be caught when a window is being operated.
● When exiting the vehicle, turn the engine switch off, carry the key and exit
the vehicle along with the child. T here may be accidental operation, due to
mischief, etc., that may possibly lead to an accident.
■ Jam protection function (only driver’s window for type B)
● Never use any part of your body to intentionally activate the jam protection
function.
● The jam protection function may not work if something gets caught just
before the window fully closes.
HILUX_OM_OM0K219E_(EE).book Page 151 Wednesday, May 14, 2014 3:06 PM